1. Introduction
This manual provides instructions for the installation, maintenance, and replacement of the A06P Main Brush Replacement Kit, designed for 360 S8 and S8 PLUS Robot Vacuum Cleaners. Using high-quality replacement parts ensures your robot vacuum continues to perform optimally, maintaining a clean home environment.

2. Package Contents
The A06P Main Brush Replacement Kit includes the following items:
- 2 x Main Brushes
- 1 x Cleaning Brush

3. Specifications
| Feature | Detail |
|---|---|
| Model | A06P |
| Compatibility | 360 S8, 360 S8 PLUS Robot Vacuum Cleaner |
| Material | Plastic |
| Brush Length | Approximately 183mm |
| Application Surfaces | Wooden Floor, Ceramic Tile, Marble, etc. |

4. Installation Instructions
Follow these steps to replace the main brush in your 360 S8 or S8 PLUS robot vacuum cleaner:
- Power Off: Ensure your robot vacuum cleaner is powered off and disconnected from its charging base before beginning any maintenance.
- Access the Brush Compartment: Turn the robot vacuum cleaner upside down. Locate the main brush cover, usually secured by a few latches or screws.
- Remove the Old Brush: Open the main brush cover. Carefully lift out the old main brush. Note its orientation for correct installation of the new brush.
- Clean the Compartment: Use the provided cleaning brush or a soft cloth to remove any accumulated dust, hair, or debris from the brush compartment and the brush cover.
- Install the New Brush: Insert the new main brush into the compartment, ensuring the ends align correctly with the slots. The brush should fit snugly.
- Secure the Cover: Close the main brush cover and ensure it is securely latched or screwed back into place.
- Power On: Turn on your robot vacuum cleaner.

5. Maintenance and Care
Regular maintenance of your main brush is crucial for optimal cleaning performance and extending the lifespan of your robot vacuum.
- Daily/Weekly Cleaning: After each cleaning cycle or at least once a week, remove the main brush and use the provided cleaning tool to remove tangled hair, threads, and debris. Pay special attention to the brush ends where hair tends to accumulate.
- Replacement Frequency: To maintain the best cleaning and filtering effect, it is recommended to replace the main brush every 2-3 months, depending on the frequency of use and the amount of debris collected.
- Inspection: Periodically inspect the bristles for wear and tear. If bristles are bent, damaged, or missing, it's time for a replacement.

6. Troubleshooting
If you experience issues with your robot vacuum's cleaning performance after replacing the main brush, consider the following:
- Reduced Cleaning Performance:
- Ensure the new main brush is installed correctly and securely.
- Check for any remaining debris or hair tangled around the brush or in the brush compartment.
- Verify that the vacuum's other components (e.g., side brushes, filter) are also clean and in good condition.
- Unusual Noises:
- Remove the main brush and re-install it, ensuring it clicks into place properly.
- Check for any foreign objects lodged in the brush or its bearings.
7. Warranty and Support
This product is a replacement accessory. For specific warranty information regarding your 360 S8 or S8 PLUS robot vacuum cleaner, please refer to the original vacuum cleaner's user manual or contact the manufacturer directly.
For further assistance or inquiries about this replacement main brush kit, please contact your retailer or the product's seller.