1. Introduction
This manual provides instructions for the AZDOME Rear Camera Extension Cable, designed specifically for use with the AZDOME M300S Dash Cam rear camera. This 3.5-meter cable allows for extended reach and flexible placement of your rear camera within your vehicle.

Figure 1: AZDOME Rear Camera Extension Cable
2. Setup and Installation
Before installation, ensure your vehicle's ignition is off. This cable is designed to extend the existing rear camera cable for the AZDOME M300S system.
- Identify Connectors: The extension cable features a 3.5mm jack on one end and a 4-pin female connector on the other.
- Connect to Rear Camera: Connect the 4-pin female end of the extension cable to the male 4-pin connector of your AZDOME M300S rear camera cable. Ensure the connection is firm and secure.
- Connect to Main Unit: Connect the 3.5mm jack end of the extension cable to the corresponding input port on your AZDOME M300S main dash cam unit.
- Route Cable: Carefully route the cable through your vehicle's interior, ensuring it does not interfere with airbags, pedals, or other vehicle controls. Use cable clips or ties to secure the cable neatly and prevent it from dangling.
- Test Connection: Once connected and routed, turn on your vehicle's ignition and power on the dash cam. Verify that the rear camera feed is displayed correctly on your dash cam's screen.

Figure 2: Cable Connectors (3.5mm jack and 4-pin female)
3. Operating Instructions
This extension cable is a passive component. Once properly connected, it facilitates the transmission of video signals from the rear camera to the main dash cam unit. No active operation is required for the cable itself.
4. Maintenance
- Keep the cable clean and free from dust or debris.
- Avoid sharp bends or kinks in the cable, as this can damage the internal wiring.
- Ensure connectors are free from moisture and corrosion.
- Do not expose the cable to extreme temperatures for prolonged periods.
5. Troubleshooting
- No Rear Camera Signal:
- Check all connections to ensure they are fully seated and secure.
- Verify that the cable is not damaged (e.g., cut, pinched).
- Ensure the rear camera itself is functioning correctly with its original cable (if possible to test).
- Intermittent Signal or Flickering:
- Inspect connectors for any looseness or debris.
- Check the cable for any visible damage or excessive bending.
6. Specifications
| Product Type | Rear Camera Extension Cable |
| Compatibility | AZDOME M300S Rear Camera |
| Cable Length | 3.5 meters (approx. 11.5 feet) |
| Connector 1 | 3.5mm Jack (for main dash cam unit) |
| Connector 2 | 4-Pin Female (for rear camera cable) |
| Color | Black |
| Approx. Package Dimensions | 12cm (L) x 12cm (W) x 2cm (H) |
| Approx. Package Weight | 0.2 kg |
7. User Tips
- Before purchasing, verify the connector type (male/female) required for your specific rear camera and dash cam unit to ensure compatibility. This cable features a 4-pin female connector.
- When routing the cable, consider using existing vehicle trim gaps or wire channels for a cleaner and safer installation.
8. Warranty and Support
For warranty information or technical support, please refer to the documentation provided with your AZDOME M300S Dash Cam or contact the seller directly. Keep your purchase receipt for warranty claims.
A user manual in PDF format may be available from the seller for general product guidance.