Instruction Manual

Introduction

This manual provides instructions for the proper installation, operation, and maintenance of your Original ROIDMI Electric Floor Brush Head. This accessory is designed for use with specific ROIDMI cordless vacuum cleaner models, including F8 NEX, X20, X20 Lite, X30, X30 Pro, RS60, and S2. Please read this manual thoroughly before use to ensure optimal performance and longevity of the product.

Setup and Installation

To attach the electric floor brush head to your ROIDMI cordless vacuum cleaner:

1. Ensure your vacuum cleaner is powered off and disconnected from any charging source.
2. Align the connector on the brush head with the corresponding port on the vacuum cleaner's extension wand or main body.
3. Push firmly until you hear a click, indicating that the brush head is securely locked in place.
4. Gently pull on the brush head to confirm it is properly attached and will not detach during use.

Operating Instructions

Once the electric floor brush head is securely attached, operate it as follows:

1. Turn on your ROIDMI cordless vacuum cleaner. The electric brush head will automatically begin to rotate.
2. Guide the vacuum cleaner over the floor surface you wish to clean. The rotating brush is effective on various floor types, including carpets and hard floors.
3. For optimal cleaning, move the vacuum cleaner at a steady pace.
4. After use, turn off the vacuum cleaner. The brush head will stop rotating.

Maintenance

Regular maintenance ensures the efficient operation and extends the lifespan of your electric floor brush head.

Cleaning the Brush Roller

1. Ensure the vacuum cleaner is powered off and the brush head is detached.
2. Locate the release mechanism for the brush roller, usually on the side or bottom of the brush head. Follow your main vacuum cleaner manual for specific instructions on removing the brush roller.
3. Carefully remove any tangled hair, threads, or debris from the brush roller using scissors or a brush cleaning tool.
4. Wipe the brush roller and the inside of the brush head housing with a dry or slightly damp cloth.
5. Reinsert the brush roller, ensuring it clicks back into its correct position.

Important Cleaning Note:

DO NOT SUBMERGE OR WASH THE BRUSH HEAD WITH WATER. This can damage the electrical components. Use only dry or slightly damp cloths for cleaning.

Troubleshooting

• Brush Head Not Spinning:
  • Ensure the brush head is securely attached to the vacuum cleaner.
  • Check for any obstructions (hair, debris) tangled around the brush roller. Remove them as per the maintenance instructions.
  • Verify that the vacuum cleaner itself is powered on and has sufficient battery charge.
• Reduced Suction:
  • Inspect the brush head for any blockages in the air pathways or around the roller.
  • Ensure the brush roller is clean and free of excessive debris.
  • Check the main vacuum cleaner's dustbin and filters, as these can also affect overall suction.

Specifications

Package Information:

• Length: 10 cm
• Width: 10 cm
• Height: 10 cm
• Weight: 1.0 kg

User Tips

• LED Indicators: Some ROIDMI vacuum models may feature LED indicators on the brush head to signal operational status or issues. If your brush head is not functioning, check for any illuminated LEDs that might indicate a fault or low battery on the main vacuum unit.
• Regular Cleaning: To maintain peak performance, regularly inspect and clean the brush roller. Accumulated hair and debris can significantly reduce cleaning effectiveness and strain the motor.
• Avoid Water: As a critical reminder, never submerge the electric floor brush head in water or wash it under running water. This will cause irreparable damage to the internal electronic components.

Warranty and Support

For any questions regarding the operation, maintenance, or troubleshooting of your ROIDMI Electric Floor Brush Head that are not covered in this manual, please contact the seller or the official ROIDMI customer support. Keep your purchase receipt as proof of purchase for any warranty claims.