Introduction
The Tineco iFLOOR 5 Steam Wet Dry Vacuum is an innovative all-in-one cleaning solution designed to vacuum, mop, and steam your hard floors simultaneously. It utilizes 248°F (120°C) high-temperature steam to effectively dissolve and remove stubborn stains, grease, and germs, ensuring a spotless and hygienic finish. This manual provides essential information for the safe and efficient operation and maintenance of your iFLOOR 5 Steam.

Image: Tineco iFLOOR 5 Steam in action, demonstrating its 3-in-1 capability.
Important Safety Instructions
Before using your Tineco iFLOOR 5 Steam, please read all instructions carefully. Failure to follow these instructions may result in electric shock, fire, or serious injury.
- This appliance is for household use only. Do not use outdoors or on wet surfaces other than those intended for cleaning.
- Always connect to a properly grounded outlet. See grounding instructions.
- Do not allow to be used as a toy. Close attention is necessary when used by or near children.
- Use only as described in this manual. Use only Tineco recommended attachments.
- Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center.
- Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
- Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
- Do not handle plug or appliance with wet hands.
- Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow.
- Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
- Do not use to pick up flammable or combustible liquids, such as gasoline, or use in areas where they may be present.
- Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
- Use extra care when cleaning on stairs.
- Do not use without filters in place.
- This appliance is corded. Ensure the power cord is not a tripping hazard during use.
- The steam function operates at high temperatures (248°F/120°C). Avoid direct contact with steam and hot surfaces.
Product Overview
The Tineco iFLOOR 5 Steam is designed for efficient and hygienic cleaning of hard floors. It integrates vacuuming, mopping, and high-temperature steam cleaning into one device.
Key Components:
- Main Body: Contains the motor, dirty water tank, and clean water tank.
- Handle: Ergonomic handle with controls for power and self-cleaning.
- Brush Head: Houses the brush roller and steam nozzle for cleaning.
- Clean Water Tank (CWT): For fresh water (0.75L capacity).
- Dirty Water Tank (DWT): Collects dirty water and debris (0.75L capacity).
- Power Cord: 6.2-meter cord for extended reach.
- Charging/Storage Base: For convenient storage and self-cleaning.

Image: Illustration of the clean and dirty water tanks, highlighting their capacities.
Setup
1. Assembly:
- Insert the handle into the main body until it clicks into place.
- Ensure all components are securely attached before use.
2. Filling the Clean Water Tank (CWT):
- Remove the Clean Water Tank from the appliance.
- Open the tank cap.
- Fill the tank with clean tap water. For enhanced cleaning, you may add Tineco-specific cleaning solution or a recommended alternative (refer to 'User Tips' for more information). Do not exceed the MAX fill line.
- Close the cap securely and reinsert the CWT into the appliance.
3. Power Connection:
- Unwind the 6.2-meter power cord.
- Plug the power cord into a grounded electrical outlet (220-240V).
Operating Instructions
1. Power On/Off:
- Press the Power button on the handle to turn the appliance ON.
- Press the Power button again to turn the appliance OFF.
2. Cleaning Modes (Vacuum, Mop, Steam):
The iFLOOR 5 Steam operates in a combined mode, simultaneously vacuuming, mopping, and steaming. The high-temperature steam activates automatically upon power-on, reaching 248°F (120°C) to sanitize and clean.

Image: Visual representation of the integrated Mop, Vacuum, and Steam functions.
3. Cleaning Process:
- Ensure the Clean Water Tank is filled and the Dirty Water Tank is empty.
- Plug in the appliance and press the Power button.
- Allow a few moments for the steam to heat up.
- Push the iFLOOR 5 Steam forward and pull it back slowly over the area to be cleaned. The self-propulsion feature assists with maneuverability.
- For heavily soiled areas or stubborn stains, hold the appliance over the spot for a few seconds to allow the steam to penetrate and loosen the mess.
- The dual-tank system ensures continuous cleaning with fresh water, while dirty water and debris are collected in the Dirty Water Tank.
- The appliance provides fast, streak-free drying, leaving floors dry in minutes.

Image: The iFLOOR 5 Steam effectively tackling a sticky mess with high-temperature steam.
Maintenance
1. Self-Cleaning Function:
After each use, it is highly recommended to run the self-cleaning cycle to maintain optimal performance and hygiene.
- Place the appliance on its charging/storage base.
- Ensure the Clean Water Tank has sufficient water and the Dirty Water Tank is empty.
- Press the self-cleaning button (usually indicated by a water droplet icon or similar) on the handle.
- The appliance will automatically wash the brush roller and internal tubes with high-temperature steam.
- Once the cycle is complete, empty the Dirty Water Tank.

Image: Activating the one-touch self-cleaning function with high-temperature steam.
2. Emptying and Cleaning the Dirty Water Tank (DWT):
- Remove the Dirty Water Tank from the appliance.
- Open the tank and carefully dispose of the dirty water and collected debris.
- Rinse the DWT thoroughly with clean water.
- Ensure the filter inside the DWT is clean. Rinse if necessary.
- Allow the DWT and filter to air dry completely before reassembling.
3. Cleaning the Brush Roller:
Even with self-cleaning, periodic manual inspection and cleaning of the brush roller is recommended.
- Turn off and unplug the appliance.
- Remove the brush roller cover.
- Remove the brush roller.
- Use the cleaning tool (if provided) to remove any hair or debris wrapped around the roller.
- Rinse the brush roller under running water.
- Allow the brush roller to air dry completely before reinserting.
4. Filter Maintenance:
The iFLOOR 5 Steam uses a HEPA filter. Regular cleaning is crucial for maintaining suction power.
- Locate the HEPA filter (typically in the Dirty Water Tank assembly).
- Remove the filter and tap it gently to dislodge dust and debris.
- If heavily soiled, rinse the filter under cold running water. Do NOT use detergent.
- Ensure the filter is completely dry before reinserting it into the appliance. A wet filter can damage the motor.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Appliance does not turn on | Not plugged in; Power outlet issue; Damaged cord/plug | Ensure power cord is securely plugged into a working outlet. Check for visible damage to cord/plug. |
| No steam or insufficient steam | Clean Water Tank empty; Steam nozzle blocked; Appliance not heated up | Refill Clean Water Tank. Check steam nozzle for blockages. Allow 30-60 seconds for steam to generate after turning on. |
| Poor suction/cleaning performance | Dirty Water Tank full; Brush roller tangled/dirty; Filter clogged; Air inlet blocked | Empty and clean Dirty Water Tank. Clean brush roller. Clean or replace HEPA filter. Check for blockages in the air inlet. |
| Water leaks | Tank caps not sealed; Tanks not properly installed; Damaged tank | Ensure Clean and Dirty Water Tank caps are securely closed. Reinstall tanks correctly. Inspect tanks for cracks or damage. |
| Appliance makes unusual noise | Brush roller obstructed; Motor issue; Foreign object inside | Turn off and unplug. Check brush roller for obstructions. If noise persists, contact customer support. |
| No water warning by sound | Clean Water Tank empty or sensor issue | Refill Clean Water Tank. If the issue persists after refilling, contact customer support. |
Specifications
| Feature | Detail |
|---|---|
| Brand Name | TINECO |
| Model | iFLOOR 5 Steam |
| Function | Wet and Dry Vacuum, Mop, Steam |
| Power (W) | <500W |
| Voltage | 220 - 240 V |
| Dust Box Capacity (L) | 0.6-1 L |
| Dust Storage Type | Dust Box/Dust Bucket |
| Filter Type | HEPA |
| Special Suction Nozzle | Steam Nozzle |
| Installation | Vertical/Hand Held |
| Cleaning Route | Random Type |
| Weight | 6-10 kg (Product package weight: 9.0 kg) |
| Power Source | Corded Electric (6.2-meter power cord) |
| Remote Control | No |
| Certification | CB, CE, EMC, GS |
| Origin | Mainland China |
| Dirty Water Tank (DWT) Capacity | 0.75L |
| Clean Water Tank (CWT) Capacity | 0.75L |
| CWT Water Level Detection | No water warning by sound |
| Self-Cleaning Function | Yes |
| High-Concerned Chemical | None |
Note on Battery Type: While some generic specifications may list 'Li-ion Battery Type', the Tineco iFLOOR 5 Steam is a corded electric appliance and does not rely on a battery for its primary operation. Any internal battery would be for minor electronic functions, not for powering the vacuum/steam.
User Tips
- Cleaning Solution: For optimal results and to ensure the longevity of your appliance, it is recommended to use Tineco-branded cleaning solutions. If using third-party solutions, ensure they are specifically designed for wet/dry vacuums and steam mops to avoid damage or residue buildup. Always dilute according to instructions.
- Cord Management: The 6.2-meter power cord provides ample reach. Utilize the integrated cord hook on the storage base for neat storage when not in use to prevent tangles and damage.
- Pre-Vacuuming (Optional): For floors with a large amount of dry, loose debris, a quick dry vacuum pass before using the iFLOOR 5 Steam can sometimes enhance overall cleaning efficiency, though the iFLOOR 5 is designed to handle both wet and dry messes simultaneously.
- Regular Maintenance: Consistent emptying of the dirty water tank and cleaning of the brush roller and filter after each use will significantly extend the life and performance of your iFLOOR 5 Steam.
Warranty and Support
Tineco products are manufactured to the highest quality standards. For warranty information, product registration, or technical support, please refer to the official Tineco website or contact their customer service directly. Keep your purchase receipt as proof of purchase for any warranty claims.
Online Resources: Visit the official Tineco website for FAQs, video tutorials, and downloadable manuals.
Customer Service: Contact information for customer support can typically be found on the Tineco website or on the product packaging.