IRALAN FX4-1

Contents

IRALAN Ceiling Fan Light Controller and Remote Control Kit

Model: FX4-1

Introduction

This manual provides comprehensive instructions for the installation, operation, and maintenance of your IRALAN Ceiling Fan Light Controller and Remote Control Kit. This kit is designed to provide integrated control over both the fan and light functions of your ceiling fan, offering convenience and efficiency.

The controller is compatible with AC 85-265V voltage and supports three-speed fan adjustment. Its durable ABS material shell ensures stable performance, making it suitable for various environments such as homes, offices, and hotels.

Package Contents

Please verify that all items listed below are included in your package:

  • 1 x Long Page Fan Light Controller (Model ND-433 52F-T190 or ND-433 42F-T260)
  • 1 x Long Page Fan Light Remote Control
  • 1 x Remote Control Wall Mount Bracket
  • Mounting Screws and Wall Anchors
Contents of the IRALAN Ceiling Fan Light Controller and Remote Control Kit, including the remote, controller, and mounting hardware.
Figure 1: Kit Contents - Remote control, fan light controller, and mounting accessories.

Setup and Installation

1. Remote Control Battery Installation

Open the battery cover on the back of the remote control. Insert two AAA (1.5V) batteries (not included), ensuring correct polarity. Close the battery cover.

Image showing the remote control with its battery compartment open, ready for AAA batteries.
Figure 2: Remote Control Battery Compartment.

2. Controller Wiring and Installation

Important: Installation should be performed by a qualified electrician or in accordance with local electrical codes. Ensure power is turned off at the circuit breaker before beginning installation.

The controller is designed to be integrated into your ceiling fan's wiring. Refer to the wiring diagram below for proper connections:

  • IN: AC 85-265V (N, L): Connect to your household AC power supply.
  • OUT: LAMP (N, L): Connect to the ceiling fan's light fixture.
  • OUT MOTOR: Connect to the ceiling fan's motor.
  • LED cable: Connect to the LED light board if applicable.
  • Antenna: Ensure the antenna is not pressed or pinched by the fan ceiling cover to prevent damage and short-circuits.
Detailed wiring diagram for the fan light controller, showing input for AC 85-265V, output for lamp, output for motor, LED cable, and antenna.
Figure 3: Controller Wiring Diagram.
Visual representation of the controller connected to a fan motor and an LED light board.
Figure 4: Controller connected to fan motor and LED light.

Ensure all connections are secure and insulated. Once wired, carefully position the controller within the fan canopy, making sure no wires are pinched.

Operating Instructions

1. Remote Control Functions

The remote control allows you to manage all functions of your ceiling fan and light. Familiarize yourself with the buttons:

Close-up of the remote control showing buttons for All Off, Light On/Off, Forward rotation (F), Reverse rotation (R), Fan/Off, 6 fan speeds (1-6), and Timming (1H, 2H, 4H).
Figure 5: Remote Control Button Layout.
  • ALL OFF: Turns off all loads (fan and light).
  • LIGHT ON/OFF: Toggles the light on or off.
  • F (Forward rotation): Sets the fan to rotate in the forward direction.
  • R (Reverse rotation): Sets the fan to rotate in the reverse direction.
  • FAN/OFF: Turns the fan on or off.
  • 1-6: Adjusts the fan speed (6 speeds available).
  • 1H, 2H, 4H (Timing): Sets the fan to turn off automatically after 1, 2, or 4 hours, respectively.

2. Pairing the Remote Control (Learning Code)

If the remote control does not operate the fan after battery installation, you may need to pair it with the receiver (controller):

  1. Ensure the main power supply to the fan is OFF.
  2. Turn ON the supply power to the fan.
  3. Within 10 seconds of turning on the power, press and hold the remote control's "ALL OFF" button for 5 seconds.
  4. You will hear a long "bee" sound, indicating successful pairing. The fan and light should now operate normally.

Maintenance

  • Battery Care: If the remote control will not be used for an extended period, remove the batteries to prevent leakage and damage.
  • Cleaning: Wipe the remote control and controller with a soft, dry cloth. Do not use abrasive cleaners or solvents.
  • Inspection: Periodically check wiring connections for any signs of wear or damage.

Troubleshooting

Problem Possible Cause Solution
Remote control does not operate the fan/light.
  • Batteries are low or incorrectly installed.
  • Remote not paired with receiver.
  • Interference from other remote-controlled devices.
  • Check battery polarity and replace if necessary.
  • Perform the pairing procedure (see Operating Instructions).
  • Check for other remote-controlled products nearby that might be operating on the same frequency.
Fan or light does not turn on.
  • No power to the fan.
  • Incorrect wiring.
  • Faulty component.
  • Check circuit breaker and wall switch.
  • Verify all wiring connections according to the diagram.
  • Contact customer support if problem persists.
Fan makes unusual noise.
  • Loose mounting.
  • Damaged fan motor.
  • Ensure fan is securely mounted to the ceiling.
  • Contact customer support.

Specifications

Feature Specification
Brand Name IRALAN
Model Number FX4-1
Item Type Lighting Transformers
Input Voltage AC 85-265V
Motor Output DC24V-30V MAX (for controller model ND-433 52F-T190)
Material ABS
Weight 0.16kg
Certification CCC, CE
Applicable Fan Size 42/52-inch fan light
Origin Mainland China
Comparison image showing a 'New controller' and an 'Old controller' for the fan light kit.
Figure 6: New vs. Old Controller Design. The new model is prioritized for shipping.
Examples of compatible ceiling fans: one with a light and one without, both three-gear fan lights.
Figure 7: Examples of compatible fan lights (with and without light).

User Tips

  • Pairing Success: When pairing the remote, ensure you press the 'ALL OFF' button within 10 seconds of turning on the power to the fan for successful code learning.
  • Compatibility Note: The new model controller is compatible with 3-blade fans purchased from this store.

Warranty and Support

For detailed warranty information and customer support, please refer to the official product documentation or contact your retailer. A PDF version of the user manual is available for download here.

© 2024 IRALAN. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.