1. Introduction
Thank you for purchasing the Wishcolor Nowna XU316 USB Audio Interface. This manual provides essential information for the safe and effective use of your device. Please read it thoroughly before operation.
1.1 Basic Product Information
| Parameter | Content |
|---|---|
| Product Series | Consumer electronics/instruments |
| Applicable models | Various models of products |
| Manufacturer | Shenzhen Bagul Technology Co., Ltd |
| EU Responsible Person | Apex CE Specialists GmbH, Habichtweg 1 41468 Neuss Germany |
2. Safety Warnings
Before using this product, please be sure to read and comply with all safety instructions.
2.1 Electrical Safety
- Use only the power adapter provided with the product or a compliant power supply.
- Do not use in humid environments (unless the product specifically states a waterproof rating).
- If the power cord is damaged, do not continue to use it and contact support for a replacement.
- Always disconnect the power before cleaning.
2.2 Usage Environment
- Operating temperature range: -10°C to 40°C (subject to model specifications).
- Avoid direct sunlight, high temperatures, and dusty environments.
- Keep the ventilation good and do not block the heat dissipation holes.
2.3 Operational Safety
- Do not disassemble or modify the product yourself, as there are no user-repairable parts inside.
- Prevent liquid from entering the product interior.
- If the product emits smoke, unusual odors, or abnormal noise, immediately disconnect the power and contact after-sales service.
3. Setup
3.1 Unpacking Inspection
After opening the package, please check that all items are complete:
- 1 x USB interface (Nowna XU316 board)
- 1 x RCA socket
- 1 x Pin header (dual row, 20 pins total)
- 1 x Isolation transformer
If you find any items missing or damaged, please contact us immediately. By default, the RCA socket, pin header, and isolation transformer are not installed for shipping. Please contact us if you require these accessories to be pre-welded.

3.2 First Use & Power Supply
Please ensure the product is fully charged before use (if applicable). Check if the power supply voltage is consistent with the product specifications (AC100-240V, 50/60Hz, applicable worldwide).
The Nowna XU316 can be powered via its USB port. Alternatively, it can be powered by an external 5V power supply. If using an external 5V power supply, you may need to remove specific resistors from the white box area on the board as shown in Figure 2.

3.3 Driver Installation
- Windows Systems: Drivers are required for Windows. It is recommended to use the board with Windows 10 and above.
- Apple Systems (macOS), Dafei, and Mobile Phones: No driver installation is required; the board can be used directly.
4. Operating Instructions
4.1 Basic Operations
- Power On/Off: Press and hold the power button for 3 seconds to turn the device on or off.
- Function Selection: Short press the mode button to switch functions.
- Display Screen: The display screen shows the current value/status (if applicable to your specific model).
4.2 MQA Indicator Light
The device features a 3-color indicator light to show the type of MQA playback:
- Green light: Indicates ordinary MQA.
- Blue light: Indicates MQA Studio.
- Magenta light: Indicates MQA OFS.
4.3 Pinout Diagram
The Nowna XU316 board provides various pins for different functions. Refer to the detailed pinout diagram and table below for connection information.

| Pin | Function | Mark |
|---|---|---|
| 1 | SPDIF | Optional for I2C_SDA (custom firmware) |
| 2 | NC | Optional for I2C_SCL (custom firmware) |
| 3 | DATA | I2S DATA/DSD LEFT* |
| 4 | BCK | I2S Bit Clock/DSD CLOCK |
| 5 | LRCK | I2S LRCK/DSD RIGHT* |
| 6 | MCLK | Master Clock, 1024fs by default (Optional to 512fs) |
| 7 | DSD ON | H=DSD, L=PCM |
| 8 | GND | GND |
| 9 | +3.3V | Power output 3.3V/200mA |
| 10 | +3.3V | Power output 3.3V/200mA |
| 11 | MUTE | H=MUTE, L=UNMUTE |
| 12 | UART | Sending the format and Sampling Rate (custom firmware) |
| 13 | GND | GND |
| 14 | GND | GND |
| 15 | GND | GND |
| 16 | 64/128 | Indicator for DSD64/128 |
| 17 | FS0 | Sampling Rate Pin 0 |
| 18 | FS1 | Sampling Rate Pin 1 |
| 19 | FS2 | Sampling Rate Pin 2 |
| 20 | FS3 | Sampling Rate Pin 3 |
5. Features
The Nowna XU316 USB Audio Interface offers a range of advanced features for high-fidelity audio:
- XU316 asynchronous USB digital interface for MQA and coaxial output.
- Full MQA solution, with a maximum output of 384kHz for MQA, supporting MQA Studio.
- Latest XU316 solution for XMOS, supporting up to PCM32bit/768kHz and DSD64~DSD512.
- Two Japanese crystal oscillators (for NDK) with low-phase noise provide precise clocks for audio.
- Supports coaxial and I2S simultaneous output, equipped with an isolation transformer and a coaxial socket.
- The USB interface includes electrostatic protection for enhanced durability.
- Clock synchronization function for lower jitter compared to boards without this feature.
- Improved sound quality compared to Amanero, fully compatible for upgrading existing devices.
- Compatible with all DAC chips via a toggle switch.
- High-spec USB audio, supporting 32bit/768kHz PCM and DSD512.
- Clock realignment circuit effectively reduces logic circuit jitter to 75ps.
- UART output for audio format and sample rate information.
- I2C interface for custom control software (for bulk purchasers).
- 512fs and 1024fs master clock jumper options to accommodate different DACs.
- Provides 3.3V power output up to 200mA.
- DFU firmware upgrade capability.
6. Specifications
6.1 Technical Specifications
| Parameter Category | General Scope | Remark |
|---|---|---|
| Input interface | USB type-B | |
| Output interface | 20-pin 2.54mm pitch and coaxial output | |
| Coaxial output level | 500mVp-p | |
| Sampling rate (I2S) | 44.1kHz~768kHz | |
| Sampling rate (MQA) | 44.1kHz~384kHz | |
| Sampling rate (DSD) | 2.8224MHz~22.5792MHz | |
| Sampling rate (SPDIF) | 44.1kHz~192kHz | |
| Bit width | 1bit, 24bit and 32bit | |
| MQA types | Normal, studio and raw sample rate | |
| Clock jitter | 75ps (typical) | |
| Power consumption | 5V/200mA | |
| Input power | AC100-240V, 50/60Hz or DC5V/9V/12V | Please refer to the product label. |
| Operating temperature | -10℃ ~ 40°C | |
| Storage temperature | -20℃ ~ 60°C | |
| Protection level | IP20 (for indoor use) | Except for waterproof models |
| Authentication information | CE, RoHS | Compliant with EU directives |
7. Maintenance and Care
7.1 Cleaning
- Wipe the outer casing with a soft, dry cloth.
- Do not use chemical solvents.
7.2 Storage
- When not in use for an extended period, clean and store the device in a cool, dry place.
- Battery (if applicable): If your model includes a battery and will not be used for an extended period, please remove the battery to prevent leakage.
8. Troubleshooting Common Problems
| Problem | Possible Reasons | Solution |
|---|---|---|
| Unable to power on | Power not connected/battery depleted | Check the power connection, charge, and try again. |
| No display/Display error | Poor connection/Incorrect settings | Restart the device and check the connection. |
| Inaccurate measurement values (instrument-related) | Range error/calibration required | Confirm the measurement range and contact calibration services. |
| Other faults | — | Contact customer service for technical support. |
9. User Tips
- Windows 7 Driver Issue: If you encounter driver problems on Windows 7, contact the seller directly. They are known to provide the necessary driver files promptly.
- Accessory Installation: The RCA socket, pin header, and isolation transformer are shipped uninstalled. If you need them welded, inform the seller during purchase.
10. Frequently Asked Questions (FAQ)
Q: Where can I get a driver for the Nowna XU316?
A: For Windows systems, drivers are required. It is recommended to use the board with Windows 10 and above, where drivers are generally more stable. If you are using Windows 7 or encounter driver issues, please contact Wishcolor customer support directly. For Apple systems (macOS), Dafei, and mobile phones, no specific driver installation is needed.
11. Warranty and Support
11.1 Warranty Policy
The product comes with a 12/24 month warranty from the date of purchase (subject to store announcement).
11.2 Technical Support
For detailed technical documentation, calibration certificates, or hard copies of the manual, please contact us via AliExpress internal message or email.
Contact Email: WISHCOLOR@126.COM
Response Time: Replies are typically provided within 24 working hours.
11.3 PDF User Manual
A comprehensive user manual in PDF format is available for download. You can access it via the following link: Nowna XU316 User Manual (PDF)
12. EU Compliance Information
12.1 CE Declaration of Conformity
This product complies with the essential requirements of the following EU directives:
- Low Voltage Directive (LVD) 2014/35/EU
- Electromagnetic Compatibility Directive (EMC) 2014/30/EU
- RoHS Directive 2011/65/EU
12.2 Waste Electrical and Electronic Equipment (WEEE)
The wheeled bin symbol marked with an X on the product indicates that, according to EU Directive 2012/19/EU, this product must not be disposed of as unsorted municipal waste and must be collected and recycled separately.
13. Disclaimer
This instruction manual is a general version; the actual product functions and parameters shall prevail. The manufacturer reserves the right to change product designs and specifications without prior notice.