1. Introduction
Thank you for choosing the MEKEDE Car Radio Multimedia Player. This manual provides detailed instructions for the safe and effective use of your device. Please read it carefully before installation and operation.
1.1. Safety Measures
- It is forbidden to watch videos or use other visual accessories while driving. Active use of the system during driving is not recommended as it can reduce attention and may result in traffic violations or accidents.
- The unit is designed for use in cars with a 12V power supply and a negative ground. Do not install the system in a bus or truck with an on-board voltage of 24V, as this may cause damage to the device.
- Use a special cleaning device to care for the screen.
- To avoid overheating, do not expose the device to direct sunlight and do not install it near heating systems. The operating temperature range is 0°C to 35°C. If the vehicle interior temperature is too high, cool it before switching on the system. Avoid operating the unit at very low temperatures; wait until the interior temperature normalizes.
- Only use the provided fasteners (screws, mounting frames, etc.) for installation. Using other fasteners may damage the system and void the warranty.
- Installation and connection of the device should be performed by a qualified specialist or specially trained staff.
- Do not reset to factory settings unless absolutely necessary, as this will cause loss of your settings and may result in incorrect operation.
- Violation of these items and improper use may cause the system to malfunction, in which case warranty service will not be performed.
2. Package Contents
The package includes the following items:

- Main Unit (Machine)
- Power Cable
- RCA Cable
- USB Cable (x2 or x3 depending on model)
- Reversing Camera Cable
- GPS Antenna
- Frame and Cable (Accessory Type)
3. Technical Specifications
| Attribute | Specification |
|---|---|
| Mounting Size | 9"/10" |
| Screen Resolution | 1280x720 IPS |
| Screen Size | 9" and 10" |
| CPU | UIS7862 1.8GHz 8-core (2 cores ARM cortex A75 + 6 cores ARM cortex A55) |
| RAM | DDR3 2GB/3GB/4GB/6GB/8GB |
| ROM | 32GB/64GB/128GB |
| Operating System | Android 11 (Android 14 mentioned in title, likely an update) |
| Maximum Output Power | 4 x 45 W |
| Sound Amplifier | TDA 7388/Toshiba 001 (M200S M300S), TDA7851/7850/7838 (M400S M500S M600S M700S) |
| Chip FM Tuner | NXP TEF6686 |
| Features of the Equalizer | Low Pass Filter, Tone Compensation, Balance Mode, Surround Sound Mode, Extended Equalizer settings (32 bands) |
| CarPlay / Android Auto | Supported (add-on Car Link) |
| Video Format | RMVB, MKV, MOV, WMV, AVI, MPG, TS, H.264 codec and others. |
| Audio Format | MP3, WMA, WAV, OGG, FLAC |
| GPS | Built-in receiver with external antenna |
| Software for Navigation | Support |
| Wi-Fi | Support |
| 360° Camera | Support |
| BT Function | A2DP and BT address book transfer |
| Control of the Steering Wheel Buttons | Support |
| ADAS DVR | Activation in the settings menu |
| AHD HD Reversing | Automatic activation of video input |
| 4G Internet / 4G LTE | Support |
| DSP | Support |
| Start | 16c ~ 20c |
| Voltage during operation | DC12V |
| Voltage at operating range | 9V ~ 16V |
| Electric Current | 15A |
| Operating Temperature | -20°C ~ +70°C |
| Main Menu Language | Support for multiple national languages |
| Warranty | One year |
4. Installation
4.1. Connection Diagram of the Device

4.2. Rear Camera Connection Method
4.2.1. Without CANBUS Box

- Red cable (2) is connected to the back light "+".
- Black cable (1) is connected to the "GND".
- The reverse detection cable (4) (Brown color) is connected to the red cable (3) which extends from the video output cable.
4.2.2. With CANBUS Box

Note: Connection of the yellow line will not be needed if you already have a CANBUS box and the reverse control line (A3 area) has been connected to the CANBUS box.
4.3. CANBUS Box Setup (If applicable)
If your car's original functions (e.g., steering wheel control) are not working, a CANBUS box may need to be set up. Check your CANBUS photo and select the corresponding type.

Setup Steps for TS7, T3L, TS18, TS10, M100, M150 and Y1, Y2, TS100, TS150, TS200 models:
- Connect as shown in the picture (Figure 4.4).
- Go to Settings > Car Settings > Factory (Password: 8888).
- Select the appropriate Car Model from the options.
5. Operation
5.1. Switching the Appliance On/Off
After switching off the ignition and starting the engine, the multimedia system automatically switches on. The display shows the initial screen. The unit activates automatically after the engine is switched off.
5.2. Touch Screen Operation
The unit is equipped with an interactive touchscreen display. Before using it for the first time, remove the sealed plastic membrane. Otherwise, the touch screen may not function properly.
- Touch: Click the necessary item with your finger to start the plugin (signal source) or select the menu item (option).
- Double Tap: A quick double touch allows you to resize when viewing images.
- Touch & Hold: Click and hold the item for 2 seconds to trigger an additional action.
- Dragging: Touch and hold the selected item, then drag it onto the screen.
- Moving: Rotate the screen with your finger and keep your finger touched, move your finger in the right direction throughout the screen.
- Scroll through: Move your finger on the screen in the direction you need to and let go. Rotation can be stopped by touching the screen, or wait until the motion stops itself.
Attention: Do not use metal or sharply sealed objects to control the interactive display. Also, do not apply excessive force when touching the screen.
5.3. Main Menu Interface Settings
You can customize the position of icons in the main interface, and all applications can be freely edited according to the position of the quick menu bar for easy operation.

5.3.1. Change Wallpaper of Main Menu Interface
You can set a picture or a photo as a background for the main screen. You can choose from previously installed Live Spreadsheets (Live wallpaper) and Spreadsheets (wallpaper) or from images or photos stored on a USB memory device or SD memory card.

5.4. FM/AM Radio
To access the Radio, click the appropriate icon (Radio) on the main menu. It supports automatic search and manual search. You can drag the icon of the target channel and replace it in the channel column.

5.5. DSP Processor/Equalizer
To access the equalizer (EQ) option, press the (Radio) or (Equalizer) icon on the menu. The DSP chip allows for advanced sound settings.

5.5.1. Equalizer Mode
Adjust sound using different frequency settings. You can adjust the volume of each of the 32 bands. Available values: Rock/Soft/Jazz/Pop/Classical/Rock/Hall. Press "Standard" to reset settings.
5.5.2. Automatic Volume Mode
Choose recommended settings for listener position: Driver Mode, Passenger Mode, Rear, Center. Or independently adjust the position on the car diagram.
5.5.3. Balance Mode
Adjust the volume ratio of speakers for comfortable sound. Tune by moving the point on the car interior layout. Supports parametric bass tuning.
5.6. Music / Video Playback
Connect a USB storage device or insert an SD memory card to play music or video files.

Supported video formats include MP4, AVI, MMV, MOV, MKV, MPEG, RMVB. Supported audio formats include MP3, WMA, WAV, OGG, FLAC.
Attention: For safety, video cannot be viewed while the car is in motion. To view video, stop in a safe place and apply the handbrake.
5.7. Bluetooth (BT) Function
The intelligent BT system supports mobile BT pairing, hands-free dialing, and steering wheel buttons for street listening, ensuring driving safety.

5.7.1. Pairing and Connection
In the main menu, click the "BT" icon to enter the hands-free interface. Simultaneously, open your phone's BT "search for new devices" function. When the system and phone detect each other, the phone will prompt "whether to connect with the device". Select "yes" and enter the password (0000) to confirm. The system screen will show "connected" upon successful connection.
5.7.2. Call Log and Dialing
In the call log section, you can view outgoing, incoming, or missed calls. The dialing interface allows you to make calls directly from the unit.
5.7.3. Telephone Book
Synchronize your phone book with the device and call selected contacts. Press (download) to synchronize contacts.
5.7.4. BT Music
Listen to music from a mobile phone via BT connection. Connect your mobile phone to the multimedia device via BT. You can start the add-on in the list of all add-ons.
5.8. Car Link (CarPlay/Android Auto)
Car Link allows you to use your iPhone and Android device in the car without distraction. You can use satellite navigation, make calls, send/receive messages, listen to music, and more.

5.8.1. Wireless CarPlay (iOS System) Connection Steps:
- Connect your iPhone via Bluetooth.
- Tap on "Car Link". Your iPhone will ask for authorization to connect. Authorize the connection and wait.
5.8.2. Wireless Android Auto Connection Steps:
- Connect the mobile phone and car DVD player with a USB cable.
- Tap on "Car Link". Your phone will ask for authorization to connect. Authorize the connection and wait.
5.9. Split Screen
On the main device screen, you can display two applications simultaneously, e.g., navigation and music.

To exit split screen mode, pull the icon between the two screens to the right.
5.10. MAP Navigation
The unit features a built-in global positioning system, omni-directional map display, and synchronous real-time traffic conditions for rapid and accurate positioning.

Supported navigation apps include Navitel, IGO, Yandex, and Google.
5.11. Cooling Fan
To start the cooling fan, follow these steps:

- Connect the cooling fan as shown in the diagram.
- The cooling fan will start working.
5.12. 4G LTE Connectivity
Connect to 4G to watch live video, listen to music online, play games, and watch movies, keeping your car seamlessly connected to the Internet.

After inserting the SIM card, pull up the iron plate to fix the SIM card in place.
5.13. Language Settings
To change the system language:

- Go to Settings > Display > Language.
- Select the desired language.
5.14. Launcher App Setting
The device has multicolor illumination and can be set to different modes of light. You can select the light color or set it to automatic color change.
5.15. Additional Features (Optional Accessories)
The following features require additional accessories, which must be purchased separately:
- DAB+: Universal for all Android radios, provides better sound quality and stronger signal.
- OBDII: Monitor real-time data and fault codes from the on-board computer.
- TPMS (Tire Pressure Monitoring System): Sensors automatically monitor tire pressure and temperature, transmitting real-time statistics to the receiver.
- AV Output: Output displayed content to rear headrest display screens for HD video and audio.
- 360° Camera: Requires a built-in 360 Camera Chip on the motherboard radio. Must be ordered with the car radio.
- ADAS DVR (Anti-collision Warning Driving Recorder): Predicts front vehicle distance, warns of collisions, and provides lane departure warnings for safer driving.
- AHD HD Reversing: Provides sharper rear view video than conventional cameras.
6. Troubleshooting
If you encounter a problem, try disconnecting and reconnecting your device. Use the special key to press the Reset button. If this does not solve the problem, refer to the table below or consult your authorized dealer.
| Symptom | Probable Cause | Solution |
|---|---|---|
| General Problems | ||
| It doesn't turn on. | The ignition key is not in the "On" position. | Turn the key to the "On" position. |
| Overheated fuses (15 A). | Check the circuit breaker in the device. If it's not working, replace it with a good one of the same nominal size. | |
| Incorrect connection of the electrical supply droplets (black and yellow). | Check the connection of the electrical supply. | |
| Bluetooth Problems | ||
| Phonebook contacts are not transferred. | No rights on the phone. | After connecting the phone to the device, go to the BT settings on the phone and authorize the transfer of the phone book. |
7. User Tips
- Installation Nuances: Be prepared to spend several hours adjusting everything during installation. Some users found that the frame might require minor adjustments or DIY work to fit perfectly.
- RAM Considerations: If you plan to run multiple applications simultaneously, consider models with more RAM (e.g., 4GB or more), as 2GB might not be sufficient for smooth multitasking.
- Professional Installation: It is highly recommended to have the unit installed by a professional car service to avoid incorrect installation that could damage the device or lead to disputes.
- Check Compatibility: Before purchasing, double-check the dimensions and compatibility with your specific Ford Fiesta model and year to ensure a proper fit.
8. Warranty and Support
The product comes with a 1-year factory warranty (accessories not included). If you experience any issues, please contact the seller for support. Firmware and software updates, including GPS navigation maps, are provided for free.
If you provide a 5-star review and share installation photos, the warranty can be extended to 2 years.
For further assistance, you can refer to the official user manual PDF: View User Manual (PDF)