Dtirszxy ONN Soundbar Audio Speaker System 100024201 100020788 Replacement Remote

Contents

User Manual: Replacement Remote Control

For ONN Soundbar Audio Speaker System 100024201 & 100020788

Brand: Dtirszxy | Model: ONN Soundbar Remote

1. Introduction

This manual provides comprehensive instructions for the Dtirszxy replacement remote control, specifically designed for ONN Soundbar Audio Speaker Systems models 100024201 and 100020788. Please read this manual carefully before using the remote control to ensure proper operation and longevity of the device.

2. Package Contents

Upon opening the package, please verify that all items are present and in good condition:

  • 1 x Dtirszxy Replacement Remote Control

Note: Batteries (2 x AA) are not included and must be purchased separately.

3. Setup

3.1 Battery Installation

To install the batteries:

  1. Locate the battery compartment on the back of the remote control.
  2. Press down on the latch and slide the battery cover downwards to open it.
  3. Insert two (2) AA batteries, ensuring the positive (+) and negative (-) terminals align correctly with the markings inside the compartment.
  4. Slide the battery cover back into place until it clicks securely.
Back of the remote control showing the battery compartment
Figure 1: Rear view of the remote control with the battery compartment.

For non-visual users: The image displays the back of the remote control, highlighting the rectangular battery compartment cover located at the bottom half of the remote. The cover has a small indentation for easy opening.

3.2 Initial Use

This remote control is designed as a direct replacement for the specified ONN Soundbar models. No complex programming or pairing is typically required. Once batteries are installed, point the remote towards your ONN Soundbar Audio Speaker System and begin operation.

4. Operating Instructions

The remote control features various buttons for controlling your ONN Soundbar. Refer to the diagram below for button identification and their functions.

Front and back view of the remote control with labeled buttons
Figure 2: Front and back view of the Dtirszxy replacement remote control.

For non-visual users: The image shows the remote control from both the front and back. The front features a power button (red circle with line) at the top left, a Bluetooth button, and a mute button (speaker with 'x'). Below these are circular navigation buttons for volume up/down (VOL +/-) and track skip/play/pause. Further down are input selection buttons (AUX, OPTICAL) and sound mode buttons (MUSIC, MOVIE, TALK).

4.1 Button Functions

ButtonFunction
Power (⏻)Turns the soundbar On/Off.
Bluetooth (Ⓘ)Activates Bluetooth pairing mode or switches to Bluetooth input.
Mute (🔇)Mutes or unmutes the sound.
VOL + / VOL -Increases / Decreases the volume level.
Play/Pause (⏸)Plays or pauses media playback.
Previous Track (⏮)Skips to the previous track.
Next Track (⏭)Skips to the next track.
AUXSelects the Auxiliary input.
OPTICALSelects the Optical input.
MUSICActivates Music sound mode.
MOVIEActivates Movie sound mode.
TALKActivates Talk/Dialogue sound mode.

5. Maintenance

5.1 Battery Replacement

Replace batteries when the remote's performance degrades or it stops responding. Always replace both AA batteries simultaneously with new ones. Do not mix old and new batteries, or different types of batteries.

5.2 Cleaning

To clean the remote control, wipe it with a soft, dry cloth. Do not use liquid cleaners, aerosols, or harsh chemicals, as these may damage the remote's surface or internal components.

5.3 Storage

Store the remote control in a cool, dry place away from direct sunlight and extreme temperatures. If the remote will not be used for an extended period, it is recommended to remove the batteries to prevent leakage.

6. Troubleshooting

  • Remote not responding:
    • Check if the batteries are inserted correctly with the correct polarity.
    • Replace old batteries with new AA batteries.
    • Ensure there are no obstructions between the remote control and the soundbar's IR receiver.
    • Verify that the remote is pointed directly at the soundbar.
  • Limited range:
    • Ensure batteries are fresh.
    • Reduce the distance between the remote and the soundbar.
    • Remove any potential interference sources (e.g., bright lights, other electronic devices).
  • Compatibility issues:
    • This remote is specifically designed for ONN Soundbar Audio Speaker System models 100024201 and 100020788. If your soundbar is a different model, it may not be compatible.
    • If you are unsure about compatibility, please verify your soundbar's model number before purchase.

7. Specifications

FeatureDetail
BrandDtirszxy
Model CompatibilityONN Soundbar Audio Speaker System 100024201, 100020788
Wireless CommunicationRF, IR
Frequency433 MHz
Channel8
UseAudio / Video Players
Power Source2 x AA Batteries (not included)
Dimensions (Approx.)Length: 10 cm, Width: 5 cm, Height: 10 cm
Weight (Approx.)0.21 kg
CertificationCE

8. Warranty and Support

This product is inspected for accuracy before shipping. For any issues or inquiries regarding the remote control, please contact the seller or manufacturer's support channel. When contacting support, please provide your product model and a detailed description of the issue.

9. User Tips

  • Verify Compatibility: Before purchasing or using, always double-check that your ONN Soundbar model number (e.g., 100024201, 100020788) matches the compatible models listed for this remote. This is crucial for ensuring proper functionality.
  • Battery Quality: Use high-quality alkaline AA batteries for optimal performance and to prevent leakage.
  • Line of Sight: For infrared (IR) communication, ensure a clear line of sight between the remote's emitter and the soundbar's receiver.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.