1. Important Safety Measures
Dear Customer,
Thank you for trusting and purchasing our car multimedia system. To ensure effective and safe use of your device, please read these instructions carefully before use.
Note: Due to the continuous improvement of our products, some descriptions in this manual may differ from the actual equipment. Specifications are subject to change without notice.
- It is forbidden to watch videos or other visual accessories while driving. Active use of the system during driving is not recommended because it can reduce attention and may result in violation of traffic laws and road accidents.
- The unit is designed for use in cars with a 12V power supply and a minus ground. Do not install the system in a bus or truck with an on-board voltage of 24V. This may cause damage to the device.
- Use a special cleaning device to take care of the screen.
- To avoid overheating of the device, do not allow direct exposure to sunlight and do not install near the heating system. Operating temperature is between 0°C and 35°C. If the temperature inside the vehicle is too high, it is necessary to cool the interior before switching on the system. It is also not recommended to operate the unit at very low temperatures. It is necessary to wait until the temperature of the interior and the vehicle returns to normal. When the temperature is low, the image on the screen may change with a delay. This is not a malfunction. Wait until the multimedia system reaches the operating temperature.
- Only use the fasteners provided (screws, mounting frames, etc.) for installation. The use of other fasteners may result in damage to the system, and this is not covered by the warranty.
- Installation and connection of the device shall be performed by a qualified specialist, or specially trained staff of the service center.
- Do not reset to factory settings on your own unless in extreme cases, as this will cause loss of your settings, which may result in incorrect operation of the system.
- Violation of the above items and improper use may cause the system to malfunction. In this case the warranty service will not be performed.
2. Product Specifications
| Feature | Specification |
|---|---|
| Mounting Size | 9"/10" |
| Screen Resolution | 1280x720 IPS |
| Screen Size | 9" and 10" |
| CPU | UIS7862 1.8GHz 8-core (2 cores ARM cortex A75 + 6 cores ARM cortex A55) |
| RAM | DDR3 2GB/3GB/4GB/6GB/8GB |
| ROM | 32GB/64GB/128GB |
| Operating System | Android 11 |
| Maximum Output Power | 4 x 45 W |
| Sound Amplifier | TDA 7388/Toshiba 001 (M200S M300S), TDA7851/7850/7838 (M400S M500S M600S M700S) |
| Chip FM Tuner | NXP TEF6686 |
| Features of the Equalizer | Low Pass Filter, Tone Compensation, Balance Mode, Balance mode, surround sound mode, extended Equalizer settings (32 bands) |
| CarPlay / Android Auto | Supported (add-on Car Link) |
| Video Format | RMVB, MKV, MOV, WMV, AVI, MPG, TS, H.264 codec and others. |
| Audio Format | MP3, WMA, WAV, OGG, FLAC |
| GPS | Built-in receiver with external antenna |
| Software for Navigation | Support |
| Wi-Fi | Support |
| 360° Camera | Support |
| BT | A2DP and BT address book transfer |
| Control of the Steering Wheel Buttons | Support |
| ADAS DVR | Activation in the settings menu |
| AHD HD Reversing | Automatic activation of video input |
| 4G Internet / 4G LTE | Support |
| DSP | Support |
| Start | 16 c~ 20 c |
| Voltage during operation | DC12V |
| Voltage at operating range | 9V~16V |
| Electric Current | 15A |
| Operating Temperature | -20°C - +70°C |
| Main Menu Language | Support for multiple national languages |
| Warranty | One year |
3. Package Contents
The package includes the main unit and necessary accessories for installation and operation. Please check all items upon receipt.

For M90S M95S models: Machine, Power Cable + Canbus Box, RCA Cable, Reversing Camera, USB Cable, GPS Antenna.
For M200S M400S M700S M800S models: Machine, Power Cable + Canbus Box, RCA Cable, Reversing Camera, USB plug*2 (9863), USB plug*3 (7862), Audio Out, 4G Antenna, GPS Antenna, MIC.
4. Installation and Connection
4.1. Connection Diagram
Refer to the diagram below for proper wiring of the car stereo system.

4.2. Front Panel Control
The front panel features:
- Microphone
- Emergency reassembly of equipment
- Input/output switch/live switch/-sound switch
- Return to main menu
- Switching back to the previous menu
- Increase volume
- Lower the volume
4.3. Turning On/Off the Device
- Switching on: After switching off the ignition and starting the engine, the multimedia system is automatically switched on. The display shows the initial screen.
- Exception: The unit activates automatically after the engine is switched off.
4.4. Touch Screen Operation
This unit is equipped with an interactive touchscreen display. Before using it for the first time, the sealed plastic membrane must be removed. Otherwise the touch screen may not function properly.
- Touch: Click the necessary item with your finger to start the plugin (signal source) or select the menu item (option).
- Double Tap: A quick double touch allows you to resize when viewing images.
- Touch & Hold: Click and hold the item for 2 seconds to trigger an additional action available for that item.
- Dragging: Touch and hold the selected item, then drag it onto the screen.
- Moving: Rotate the screen with your finger and keep your finger touched, move your finger in the right direction throughout the screen.
- Scroll through: Move your finger on the screen in the direction you need to and let go. Rotation can be stopped by touching the screen, or wait until the motion stops itself.
Attention! Do not use metal or sharply sealed objects to control sensory interactive display. Also don't apply excessive force when touching the screen.
4.5. Cooling Fan Installation (M200S M400S M700S M800S)
The cooling fan helps manage temperature for optimal performance.

Setup steps:
- Go to Settings > Factory.
- Enter the password (3368).
- Find "USB Video Output Setting" and ensure it's configured correctly.
- The cooling fan should start working.
4.6. 4G LTE Module and SIM Card Insertion (M200S M400S M700S M800S)
The built-in 4G module allows you to connect to the cellular network almost anywhere, anytime. No need to open your cellular hotspot connection every time.

SIM Card Insertion Steps:
- Push the iron plate down and open it.
- Insert the SIM card with the chip facing the system module, with a bevel outward.
- After inserting the SIM card, pull up the iron plate to fix the SIM card in place.
4.7. CANBUS Box Setup
If the original functions of your car (e.g., steering wheel control) cannot be used, the CANBUS type needs to be set. Before setting up CANBUS, check your CANBUS photo and select the corresponding type.
For TS7 T3L TS18 TS10 M100 M150 and Y1 Y2 TS100 TS150 TS200 models:
Setup steps:
- Connect as shown in the picture (refer to the connection diagram in section 4.1).
- Go to Settings > Car Settings > Factory (Password: 8888).
- Select the correct CAN Box type, Car Brand, and Car Model.
4.8. Rear Camera Connection
The picture quality of AHD rear-view video is clearer than that of ordinary cameras.

Connection Method (Without CANBUS Box):
- Connect the reversing mode control wire to A5.
- Connect the rear camera control wire to the 12V reverse light power supply.
- Connect the camera GND to Car Ground.
Connection Method (With CANBUS Box):
Note: Connection of the yellow line will not be needed if you already have a CANBUS box and the reverse control line (A3 area) has been connected to the CANBUS box.
- Connect ACC to A3 ACC.
- Connect the two red wires of the camera power supply together (do not connect with other wires).
- Connect camera GND to Car Ground.
4.9. ADAS DVR Installation
The ADAS DVR provides anti-collision warning and driving recording features.

Installation Steps:
- Connect the DVR via USB Cable.
- Open the File Manager app on the stereo.
- Install the DVR software (e.g., uCarDvr.apk).
- Once installed, open the app.
4.10. OBD II Connection
With the OBDII function available on this unit, you can monitor real-time data and fault codes received from the on-board computer.

4.11. TPMS Installation
Once you have properly installed a TPMS on your vehicle, the sensors will automatically monitor the tire pressure and temperature and transmit real-time statistics to the receiver.
4.12. AV Output Connection (M200S M400S M700S M800S)
The video output can display content on external screens, allowing rear passengers to watch HD video and listen to HD audio through the video cable from the navigation console on the headrest display screen.

4.13. DAB+ Connection
EU DAB+ Radio Universal for all Android radio, make you get better sound quality and stronger signal, only for EU countries buyer.

5. Operating Instructions
5.1. Main Interface Customization
You can customize the position of icons in the main interface, and all applications can be freely edited according to the position of the quick menu bar for easy operation.
Change wallpaper of main menu interface: You can set a picture or a photo as a background for the main screen. You can choose from the previously installed Live Spreadsheets (Live wallpaper) and Spreadsheets (wallpaper) or you can choose from images or photos stored on a USB memory device or SD memory card.
5.2. FM/AM Radio
To access the Radio, click the appropriate icon (Radio) on the main menu.
- Main menu
- FM switching group
- LOC mode or DX mode: "LOC" for strong signals, "DX" for all stations in current range.
- MONO mode
- Automatic scanning of stations
- Save the station
- Additional adjustments
- List of saved stations
By tapping on the scale bar, you can quickly select the desired frequency.
5.3. DSP Processor/Equalizer
To access the equalizer (EQ) option, press the (Radio) or (Equalizer) icon on the menu. We are equipped with a DSP chip that allows you to use advanced sound settings in your car.

- Equalizer mode: Adjust sound using different frequency settings (Rock/Soft/Jazz/Pop/Classical/Rock/Hall).
- Automatic volume mode: Choose recommended settings for listener position (Driver Mode/Passenger Mode/Rear/Center).
- Balance mode: Adjust the volume ratio of speakers for comfortable sound.
5.4. Music / Video Playback
Connect a USB storage device or insert an SD memory card and press (music) for music playback, press (video) for video playback.
The format supported by the video player is as follows: MP4 / AVI / MMV / MOV / MKV / MPEG / RMVB etc.
Attention! Given the security of the video, you cannot view it while the car is in motion. To view the video, stop in a safe place and apply the handbrake.
5.5. Bluetooth (BT) Function
In the main menu click the "BT" icon, enter the BT hands-free interface, and at the same time open the phone BT "search for new devices" function, when the system and the phone to get a signal contact, will prompt the phone "whether to connect with the device", the phone select "yes" and enter the password (0000) to confirm, the system and the phone link, the system screen shows "connected", indicating a successful connection.
- Call log
- Dialing interface
- Telephone book
- BT music
- Check connection
- BT settings
5.6. CarPlay / Android Auto
Car Link is an add-on that allows you to use your iPhone and Android in the car without being distracted from the road. By connecting your iPhone / Android to Car Link you can use the satellite navigation system, make calls, send and receive messages, listen to music and do many other things.

Wireless CarPlay (iOS System) Connection steps:
- Connect your phone via BT.
- Tap on "Car Link", the phone will ask for authorization to connect, authorize the connection and wait for the connection.
Android Auto Connection steps:
- Connect the mobile phone and car DVD player with USB cable.
- Tap on "Car Link", the phone will ask for authorization to connect, authorize the connection and wait for the connection to complete.
5.7. Split Screen
On the screen of the main device, you can display two additional devices. For example, the navigation program and music.

To exit the split screen mode, pull to the right the icon between the two screens.
5.8. MAP Navigation
Built-in global positioning system, omnidirectional map display, synchronous real time traffic display, fast and accurate positioning.

5.9. Language Settings
The device supports multiple languages.

To change language:
- Go to Settings > User > Language And Input.
- Select the desired language.
5.10. Steering Wheel Control
Take control of the music or use hands-free calling function for safety and to concentrate on the road ahead. This head unit supports steering wheel control (SWC) with a digital SWC.

5.11. Button Light Color
Key support a variety of color display, you can choose your favorite color by setting.

To change button light color:
- Go to Settings > Device > Lantern settings.
- Adjust the RGB values or select a preset color. You can also set it to automatic color change.
5.12. UI Interface Options
The device offers various user interface designs to suit your preference.

6. Maintenance
Use a special cleaning device to take care of the screen. Avoid harsh chemicals or abrasive materials that could damage the display.
7. Troubleshooting
If you have a problem, try disconnecting and then reconnecting your device. Use the special key to press the Reset button. If this does not solve the problem, please refer to the table below. These instructions will help you to solve the problem if the device does not work properly. Otherwise, check that the device is properly connected or consult your authorized dealer.
| Symptom | Probable Cause | Solution |
|---|---|---|
| General Problems | ||
| It doesn't get in the way. | The ignition key is not in the "On" position. | Turn the key to the "On" position. |
| Overheated fuses 15 A. | Check the presence of the circuit breaker in the device, if it is not working, replace it with a good one of the same nominal size. | |
| Incorrect connection of the electrical supply droplets (black and yellow). | Check the connection of the electrical supply. | |
| BT | ||
| Phonebook contacts are not transferred. | No rights on the phone. | After connecting the phone to the device, go to the BT setting on the phone, and authorize the transfer of the phone book. |
8. Warranty and Support
8.1. Warranty Information
This product comes with a 1-year warranty from the date of purchase. The warranty covers manufacturing defects and malfunctions under normal use. Please refer to the safety measures section for conditions that may void the warranty.

8.2. Additional Resources
For a detailed user manual in PDF format, you can view or download it from the official product page or directly via this link: User manual (PDF).
9. User Tips
- Vehicle Compatibility: Before purchasing or installing, always double-check the compatibility of the car stereo with your specific BMW 1 Series model and year. Some users have reported compatibility issues with certain models, such as the BMW E87 2005. It is recommended to verify fitment with the seller or a professional installer if unsure.
- Professional Installation: While the manual provides detailed instructions, professional installation is highly recommended to ensure correct wiring and functionality, especially for features like CANBUS, ADAS DVR, and reversing cameras.
- Software Updates: Keep your device's software updated to the latest version for optimal performance and access to new features.
- Screen Care: Use a soft, lint-free cloth and a screen-safe cleaner to maintain the display's clarity. Avoid harsh chemicals.