1. Introduction
Thank you for choosing the LEHX L6 Pro Car Multimedia System. This manual provides detailed instructions for the installation, operation, and troubleshooting of your new device. Please read it thoroughly before installation and use to ensure optimal performance and safety.
2. Safety Information
- Always ensure the vehicle's engine is off and the parking brake is engaged before performing any installation or wiring.
- Incorrect wiring can cause damage to the device or vehicle. If you are unsure about any step, seek professional assistance.
- Do not operate the device in a way that distracts you from driving. Always prioritize road safety.
- Keep the device away from water and extreme temperatures.
3. Package Contents
Please check the box for the following items:

L6/LQ/L6X/L6 Plus Series Accessories
- 1 Power Cable
- 2 RCA Input/Output cables
- 3 Camera Input/BT Antenna
- 2 USB Cables
- 5 GPS Antenna
- CAN BUS
- Bracket

L5 Pro/L6 Pro Series Accessories
- 1 Power Cable
- 2 RCA Input/Output cables
- 3 Camera Input/BT Antenna
- L5 Pro USB Cable *2
- L6 Pro USB Cable *3
- 5 GPS Antenna
- CAN BUS
- Audio Out
- 4G Antenna
4. Setup & Installation
Before Installation:
Before installing the product directly into your car, please test the machine. Due to long journeys, the product may be affected. Test the machine before proceeding with full installation.
4.1. Rear Interface Description (Power Plug)
This section details the wiring connections for the main power plug.

Wiring Notes:
- When the yellow line B+ and the red line ACC have a 12V positive power at the same time, the unit can be turned on normally.
- The yellow line B+ keeps the power on and the machine has a memory function.
- 8 speaker cables: each cable cannot be grounded, cannot be shared, cannot touch the line, otherwise there will be no sound output, output sound distortion, machine fever and so on.
4.2. CANBUS Connection
The CANBUS connection varies depending on whether your vehicle is a high-end or low-end model.

High-End Model Car: Disconnect and Connect CANBUS

Low-End Model Car: Connect
Attention: If the CANBUS box and black buckle are connected simultaneously, it may cause the radio to fail to shut down after the car is turned off.
4.3. Reversing Camera Installation
Follow these steps to install the reversing camera:

- 1) Yellow cable: Connect to the navigation reversing video input socket.
- 2) Red cable: Connect to the reverse detection line of the navigation adapter (BACK or REVERSE).
- 3) Connect ③ and ④ together: Then connect the positive pole of the reverse light power supply.
- 4) Black cable ⑤: Connect the body screw to the ground or the negative pole of the reverse light power supply.
If the reversing camera is not installed, do not connect the REVERSE/BACK cable to any place. Leave the cable unconnected, otherwise the machine will not display properly, or it will automatically enter the reverse mode, which will cause the machine to fail. In case of such a situation, please disconnect the REVERSE/BACK line as soon as possible to avoid affecting the normal use of the user.
4.4. Learning Steering Wheel Controls
To configure steering wheel controls:
- Press and hold a button on the steering wheel of the original car.
- Find the button icon corresponding to the function of the button on the steering wheel.
- Click the icon to change the color. Learning is successful.

Note: If your order comes with CANBUS, please set the CANBUS type so that the button can work. Please contact customer service for help.
5. Operating Instructions
5.1. Wireless Carplay & Android Auto
This system supports both wired and wireless Carplay and Android Auto for seamless smartphone integration.
- Wired Connection: Connect your phone via USB data cable. The system will automatically enter the Carplay/Android Auto interface.
- Wireless Connection: Turn on Bluetooth and Wi-Fi on your mobile phone, then connect to the device's Bluetooth. The system will automatically enter the Carplay/Android Auto interface. (Note: The signal is transmitted via Wi-Fi. If Bluetooth is off, it will still transmit normally. If Wi-Fi is off, Carplay/Android Auto will disconnect.)

5.2. Voice Control
The device supports intelligent voice control for various functions, enhancing driving convenience and safety.

5.3. Split Screen Functionality
The split screen feature allows you to run two applications simultaneously, such as navigation and music, or DVR and music.

5.4. HIFI DSP Sound Settings
The LEHX L6 Pro features a 5.1 channel DSP with DTS HiFi digital audio authorization, offering advanced sound customization including surround sound, Trubass, and Phantom Center modes.

5.5. Optional Accessories: OBD2 & TPMS
The system supports optional OBD2 (On-Board Diagnostics) and TPMS (Tire Pressure Monitoring System) accessories for enhanced vehicle monitoring.

OBD2 Vgate Icar2 Bluetooth

TPMS (Tire Pressure Monitoring System)
5.6. 4G Internet & Dual SIM
The L6 Pro features an external SIM card slot, supporting the installation of two SIM cards (integrated and external cable) for 4G internet connectivity.

5.7. Optional DAB+ Tuner
With the optional DAB+ radio receiver stick (connected via USB), you can enjoy better sound quality and stronger digital audio broadcasting channels.

5.8. Rear View System
The system supports a rear view camera, automatically displaying the view when reversing.

5.9. Optional ADAS DVR
The ADAS DVR provides 1080P video recording and clear night image quality. It can also provide reminders if your car is about to hit the car in front or if you drift from your lane.

5.10. Bluetooth Connectivity
The LEHX L6 Pro supports BT5.1 for mobile phone Bluetooth pairing, music streaming, hands-free dialing, and clear calls, ensuring driving safety.

5.11. Video Playback & Apps
The system allows for video playback from local storage and streaming from apps like YouTube. You can also download various apps from the Google Play Store.
Product demonstration video showing UI, navigation, sound settings, OBD, TPMS, split screen, and app usage.
5.12. Changing Boot Logo
You can customize the boot logo of your device:
- Go to Configuration > Car Information > General > Boot Logo.
- Enter the password (L6/L6Plus: 8888, L6Pro: 3368).
- Select your desired logo.

6. Maintenance
- Keep the screen clean using a soft, dry cloth. Avoid abrasive cleaners.
- Ensure all connections are secure and free from corrosion.
- Regularly check for software updates to ensure optimal performance and access to new features.
7. Troubleshooting
7.1. Cannot Boot Normally
- Wiring Check: Ensure the yellow (B+), red (ACC), and black (GND) wires are correctly connected. Yellow to positive, red to key control, black to negative. Incorrect or incomplete connections will prevent booting.
- Original Car Wiring: If the original car wiring colors do not match standard connections, connecting them incorrectly can cause damage.
- Fuse Check: If the 3 wires are correctly connected but it doesn't boot, check the fuse on the yellow line. If the fuse is intact, twist the yellow and red wires together, turn the key, and press the power button.
- Memory Function: If the unit burns a fuse every time it's changed, it indicates a short circuit in the protection circuit. Professional repair is needed.
7.2. Automatic Shut-down
- Cable Error: If the blue cable (automatic antenna power supply) is connected to the unit's power cable, an automatic shutdown will occur. Correct the wiring.
- Unstable Voltage: Test the power supply with a 12V-5A source. If it still shuts down, the power supply is problematic.
7.3. Noise Issues
- Speaker Power: If the original speaker power is too low, increasing the volume may cause noise. Adjust volume or replace speakers.
- Grounded Speaker Cable: Ensure speaker cables are not grounded. Connect the iron speaker cable directly to the unit's speaker cable.
7.4. Remote Control Not Working
Test the remote by pointing it at a mobile phone camera and pressing a button. If the phone camera lights up, the remote is working; otherwise, replace the battery.
7.5. Settings Not Saved (No Memory)
- Wiring: The yellow and red lines are connected together (yellow to positive, red to key control).
- Reversed Wires: Yellow and red wires are reversed (just change positions).
7.6. Bluetooth Not Working
Turn on the machine, search for its Bluetooth name on your mobile phone, and connect. If successful, you can answer calls or play music via Bluetooth.
7.7. Product Emits Smoke
Replace the FUSE. If the problem persists, the internal circuit is burned. After-sales service is required.
7.8. Sound Cannot Be Adjusted
- Reset the unit or unplug and replug the power cord.
- If the volume knob is broken, it can be replaced.
7.9. Reversing Camera Does Not Display
- Wrong/Missing Wiring: Refer to section 4.3 for correct wiring.
- Broken Camera: If the camera is correctly wired but doesn't light up, it may be broken and needs replacement.
7.10. USB Devices Cannot Be Played
Format the USB flash disk to FAT32. Re-download songs and try again. If it still doesn't work, replace the USB flash drive.
7.11. FM Radio Not Receiving Stations
- Antenna Connection: Ensure the antenna plug is fully inserted. Check if the antenna is disconnected or the line is broken.
- Station Search: Use the 'AS' button for automatic search or the 'before/after' buttons for manual search.
- If the above doesn't resolve the issue, unplug the antenna plug and try inserting a screwdriver or metal strip in its place to test.
7.12. No Sound Immediately After Installation
This usually indicates a wiring error or a short-circuited original car speaker wire. Check the speaker cables for shorts and reconnect. If only 2 speaker cables are present, and the original car line does not match the unit, you may need to re-route the original car line. Each speaker requires 2 wires, so 2 speakers need 4 wires.
7.13. No Sound After A While
Disconnect all speaker cables from the unit (do not remove them). Connect an external speaker to the gray and purple wires of the tail line. Test any group of green wires. If there is sound, the car's speaker line is short-circuited or the speaker is damaged. If there is no sound, the unit is broken.
8. Specifications
| Feature | Specification |
|---|---|
| Brand Name | LEHX |
| Model/Brand | For Ford Everest Ranger (2015-2018) |
| Operating System | Android |
| RAM/ROM | 6G+128G / 1G+32G (Optional) |
| Display Size | 9" |
| Screen Display | 9inch 2.5D screen, QLED 1280*720 resolution 4G version IPS |
| Resolution | QLED 1280*720 |
| Out Power | 50x4 |
| Voltage | 12 V |
| Item Weight | 1.5kg |
| Item Size | 247*228*140 |
| Max External Memory | 128G |
| Special Features | wifi function, Support steering wheel control, Support 4G Network, Support Can-Bus, Built-in GPS, Charger, Mobile Phone, MP3 players |
| Digital Media Format | CD, DVD-R/RW, DVD-RAM, VIDEO CD, Mp3, MP4, WMA, JPEG |
| OSD Language | Multi-language support including English, Chinese, Arabic, Russian, French, Spanish, etc. |
| Origin | Mainland China |
| Certification | CE |
| Material | ABS+ |
| Subwoofer Output | Support |
| AV-OUT | WiFi version support, 4G version not support |
| RCA cable | 7 channels including subwoofer cable |
| INPUT Interface | 2*USB RCA Bluetooth |
| WIFI | Built-in |
| 4G LTE SIM | Optional |
| Steering wheel control | Support |
| Mirror link | Iphone & Android |
| Microphone | Built-in (external microphone optional) |
| GPS Navigation map | Built-in offline map free update (support navitel/Igo) |
| Bluetooth phone book | Support |
| Bluetooth music | Support |
| Carplay | Support |
| Android auto | Support |
9. User Tips
- Steering Wheel Controls: If your unit comes with CANBUS, ensure the CANBUS type is correctly set in the system settings for steering wheel controls to function properly.
- Installation: It is highly recommended to have the unit installed by professionals to avoid any damage to the car dashboard or incorrect wiring.
- Testing Before Final Installation: Always test the unit's basic functions (power on, sound, display) before fully installing it into the dashboard, especially after shipping.
- Troubleshooting Wiring: For issues like no boot or no sound, carefully check the power (yellow, red, black) and speaker wiring. Incorrect grounding or short circuits are common causes.
- Voice Assistant: If the voice assistant doesn't understand, try rephrasing your commands or check the Q&A section in the manual for common phrases.
10. Warranty & Support
The product comes with a 1-year warranty.
For further assistance, technical support, or warranty claims, please refer to the official user manual PDF or contact customer service through the following channels:
- User Manual (PDF): A detailed user manual in PDF format is available. View User Manual (PDF)
- WhatsApp: Scan the QR code on page 32 of the manual.
- TikTok: Scan the QR code on page 32 of the manual.
- Instagram: @LEHXCARRADIO (Scan the QR code on page 32 of the manual).
