1. Introduction
Thank you for choosing the Hirisi B150 Carp Fishing Bite Alarm. This device is designed to enhance your fishing experience by providing clear audio and visual alerts when a fish bites. This manual provides essential information for the safe and effective use of your bite alarm.
2. Safety & Warnings
Important Safety Information
Read all instructions before use. Failure to follow these instructions may result in damage to the product or personal injury.
- Warning: Keep the device and its cord out of reach of children under 3 years old.
- Keep away from children unless supervised by an adult.
- Do not use this product for purposes other than its intended use.
- Inspect the product before each use; do not use if damaged.
- Follow installation and operation guidelines to avoid injury.
- Do not expose to water or moisture.
- Handle with care to avoid cuts or injuries.
3. Package Contents
Please check the package for the following items:
- Hirisi B150 Carp Fishing Bite Alarm Unit(s)
- User Manual (this document)
Note: 9V batteries are not included and must be purchased separately.
4. Product Overview
Familiarize yourself with the components of your Hirisi B150 Bite Alarm:

Figure 1: Hirisi B150 Bite Alarm Components
- Snag Ear Bar
- White LED Light
- 6 Red LED Light Band (rolls up and down)
- Power On/Off Button (Long press for On/Off, press twice for Anti-theft)
- High Output Speaker
- Anti-theft Sensor
- Red LED Light
- Volume Control Knob
- Tone Control Knob
- Sensitivity Control Knob
- 2.5mm Extra Jack for LED Swinger
5. Setup
5.1. Battery Installation
The Hirisi B150 requires one 9V battery (not included).
- Locate the battery compartment cover on the back of the alarm unit.
- Slide or unclip the cover to open the compartment.
- Insert a new 9V battery, ensuring correct polarity (+/-).
- Replace the battery compartment cover securely.

Figure 2: Battery Compartment
5.2. Device Installation
- Fix the alarm securely onto your rod rest or bank stick using the threaded base.
- Tighten the adjusting knob to ensure the alarm is stable and does not wobble.
- Route your fishing line and place it against the sensing contact (roller wheel) to ensure sensitive detection.

Figure 3: Alarm Mounted on Rod Rest
6. Operating Instructions
6.1. Power On/Off
- To turn ON the alarm, long press the Power On/Off button (4).
- To turn OFF the alarm, long press the Power On/Off button (4) again.
6.2. Sensitivity Adjustment
Turn the Sensitivity Control Knob (10):
- Clockwise: To increase sensitivity (for subtle bites).
- Counter-clockwise: To decrease sensitivity (to avoid false alarms from wind or water movement).
Adjust according to fishing conditions and fish activity.
6.3. Volume & Tone Control
- Volume Control Knob (8): Turn to adjust the alarm's sound level.
- Tone Control Knob (9): Turn to change the pitch of the alarm sound.
Adjust these settings to ensure clear alarm prompts that suit your preference and environment.
6.4. Fishing Operation
- After casting your line, tighten it and ensure it is properly in contact with the sensor (roller wheel) of the bite alarm.
- Wait for bites. The device will activate sound and light alarms once a fish pulls the line.

Figure 4: Line Movement Detection (Run and Drop)
6.5. Fish Fighting
When the alarm goes off, lift the rod firmly to hook the fish. Control the reel drag properly to prevent line breakage and fish escape.
6.6. Anti-theft Function
Press the Power On/Off button (4) twice quickly to activate the anti-theft function. This feature provides an additional layer of security for your fishing rods.
6.7. LED Indicators
- The alarm features a White LED Light (2), a 6 Red LED Light Band (3) that rolls up and down, and a Red LED Light (7).
- These lights provide visual indication of a bite, especially useful during low light conditions or night fishing.
- The alarm provides different sounds for when the fishing line drops (slack line) and when it runs (fish taking line).
7. Maintenance
To ensure the longevity and optimal performance of your bite alarm:
- After each use, turn off the power.
- Wipe off any water, dirt, and debris from the device using a soft, dry cloth.
- Reset the sensitivity knob to a neutral position before storage.
- Store the product in a dry and cool place, away from direct sunlight and extreme temperatures.
- Remove batteries if the device will not be used for an extended period to prevent leakage.
8. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Alarm not turning on or no sound/light | Dead or incorrectly inserted battery | Check battery polarity, replace with a new 9V battery. |
| Alarm sound is too low or inconsistent | Low battery; Volume setting too low | Replace battery; Adjust Volume Control Knob (8). |
| False alarms (e.g., from wind) | Sensitivity set too high | Decrease sensitivity using the Sensitivity Control Knob (10). |
| Alarm not detecting bites | Sensitivity set too low; Line not properly on sensor | Increase sensitivity; Ensure fishing line is correctly placed on the roller wheel. |
| Knobs adjust in steps, not smoothly | Normal operation | This is by design for tactile feedback. |
| Device completely unresponsive/broken | Internal fault or damage | Contact customer support for assistance. |
9. Specifications
| Feature | Detail |
|---|---|
| Model | B150 |
| Type | Fish Bell/Alarm |
| Material | ABS |
| Power Source | 1 x 9V Battery (not included) |
| Features | LED alarming signals, Adjustable Tone, Volume, Sensitivity, Anti-theft function, 2.5mm jack for swinger, Water Resistant |
| Package Dimensions (approx.) | Length: 24 cm, Width: 19 cm, Height: 7 cm |
| Package Weight (approx.) | 0.12 kg |
| Origin | Mainland China |
10. User Tips
- The variable sensitivity feature works effectively; adjust it to match current fishing conditions.
- The alarm includes a night light that may activate automatically in low-light conditions, enhancing visibility.
- Utilize the side snag ear bars to help keep your rods securely in place, especially in windy conditions.
- Ensure your fishing line is clean and free of debris for optimal sensor performance.
11. Frequently Asked Questions (FAQ)
Q: Is the Hirisi B150 bite alarm waterproof?
A: While not explicitly rated as fully submersible, many users report that the alarms perform well in wet conditions and hold up during rain or night fishing without issues. It is designed to withstand typical outdoor fishing weather.
Q: Does this model connect to a wireless receiver?
A: Based on the product description and available information, the Hirisi B150 bite alarm is a standalone unit and does not appear to support connection to a wireless receiver.
12. Warranty & Support
For warranty information, returns, or technical support, please contact your original retailer or the seller directly. Please retain your proof of purchase.
Manufacturer & EU Representative Information:
- Manufacturer: SUCCESS COURIER SL, CALLE RIO TORMES NUM. 1, PLANTA 1, DERECHA, OFICINA 3, Fuenlabrada, Madrid.
- EU Authorized Representative: Ningbo hai ruisi outdoor products co., ltd, Room 309, building 1, no. 188, wanjin road, haishu district, ningbo city, zhejiang province.