BOJECHER IMEI Activate GPS Tracker (for TK102B, GT06, GT02, TK200, TK210, TK206, TK800)

Contents

BOJECHER GPS Tracker User Manual

Models: TK102B, GT06, GT02, TK200, TK210, TK206, TK800

1. Introduction

Thank you for purchasing the BOJECHER GPS tracker. This manual provides detailed instructions on how to smoothly operate the device. Please read this manual carefully before using the device. Note that any updates to the manual will be released with the latest product sales. The manufacturer does not assume any legal responsibility for any errors or omissions made in this manual.

For additional information, you may refer to the official user manual PDF: User Manual (PDF)

2. Hardware Description

The GPS tracker device features several wire connections for power, alarms, and microphone input.

GPS Tracker with labeled wires for open door alarm, power/ACC/Relay, SOS, and MIC
Figure 1: GPS Tracker Hardware with Wire Connections

Important Installation Note: The device should be installed face up towards the sky. If the vehicle's windscreen is glued with a metal thermal insulation layer or heating layer, it may reduce the GPS signal reception and lead to GPS work disorder.

3. Installation

The GPS tracker must be installed by professional personnel. Below is a general wiring diagram and connection guide.

Wiring diagram for GPS tracker installation in a car, showing connections to battery, ignition, SOS, and fuel pump
Figure 2: Device Wiring Diagram

3.1 Wire Connections

  1. Red wire connects to vehicle power positive (+).
  2. Black wire connects to vehicle power negative (-).
  3. Yellow wire connects to relay yellow wire.
  4. Green wire connects to ACC wire.
  5. Thin Red wire connects to the door control circuit if it is positive.
  6. Thin black wire connects to the door control circuit if it is negative.

The device's yellow wire connects to the relay yellow wire. The relay white wire connects to the car power positive (+). Cut off the pump wire. The relay green wire connects to the engine side, and another relay green wire connects to the fuel pump side.

3.2 Indicator Light Status

INDICATOR LIGHT STATUSMEANING
Green light - SolidGSM signal connection
Green light - FlashNO GSM connection
Blue light - SolidGPS signal connection
Blue light - FlashSearching GPS signal
Red light - SolidConnection external power
Red light - FlashDisconnect external power

Note: All LEDs will turn off after 10 minutes for best concealment. Connect to a 12V-36V power supply.

4. Quick Start Guide

Before using the tracker, ensure you have a compatible SIM card. The tracker supports GSM 2G SIM cards or 4G/3G SIM cards compatible with 2G GSM networks. The SIM card must support making calls, sending messages, and GPRS network access, and have sufficient balance.

Image showing different SIM card sizes: Normal SIM, Micro SIM, Nano SIM
Figure 3: Compatible SIM Card Types
  1. Open the rubber cover and insert the SIM card into the slot.
  2. Place the device outdoors and connect it to a 9V/36V power supply.
  3. Ensure the small switch is turned to the “ON” position.
  4. To get a location, call the device from your mobile phone and hang up, or send the message "smslink123456" to the SIM card in the tracker.

4.1 Explanation of Parameters/Codes in SMS Message

When you receive a real-time tracking SMS, it will contain information like:

GPS! lat:22.67533 long:114.03913 speed:000.3 T:06/14/17 09:14 http://maps.google.com/maps?f=q&q=22.67533,114.03913&z=16
  • Lat/Lon: Positioning of the latitude and longitude values.
  • Speed: Device moving speed (unit is km/h).
  • T: Real-time tracking time (default is London time, can be set by SMS command).
  • Google Link: Google map showing the position of the device.

If you receive LBS information without a GPS satellite signal (e.g., `smcc:27a4 1223: Time:08/00/00`), please take the GPS tracker outdoors and walk around to receive the satellite signal.

5. App and Web Platform Setup

The BOJECHER GPS tracker supports both website tracking and mobile application tracking.

5.1 App Download and Installation

To download the app, scan the QR code provided below with your phone's camera or a QR code scanner app. Open the link with a browser and choose either Android or iPhone to download the installation app.

QR code for app download
Figure 4: QR Code for App Download

Alternatively, for iOS users, search for "dagps" in the App Store and install the DAGPS APP.

5.2 Login to Platform and App

You can track your device via the web platform or the mobile app.

Web Platform: Open www.gps110.org. Use your tracker's IMEI for login. The default password is 123456.

Web platform login screen showing fields for User ID/IMEI and password
Figure 5: Web Platform Login

Mobile App: Open the DAGPS app. Use your tracker's IMEI/ID for login. The default password is 123456.

Mobile app login screen showing fields for IMEI/ID and password
Figure 6: Mobile App Login

Video Tutorial: Watch this video for a demonstration of the app's registration, device adding, tracking, playback, and alarm features.

Video 1: App Usage Demonstration (Registration, Device Adding, Tracking, Playback, Alarms)

5.3 APN Commands

NOTE: If the device is online on the platform, you do not need to set APN commands.

If you insert the correct SIM card and enable GPRS, but the device is still not online outdoors, you need to set the APN commands. There are two methods to find out the APN content:

  1. Ask your SIM card company for the APN details.
  2. Put the SIM card into a mobile phone to find out the APN.

SMS Format:

  • SMS1: `APN123456 space Apn_name` (e.g., `APN123456 ABC`).
  • If the APN requires a username and password, include them: `APN123456 space APNname space APNusername space APNpassword`.

6. SMS Commands

You can control and configure the GPS tracker by sending SMS commands to the device's SIM card number. The default device password is 123456. Note that a space is required in the command where indicated.

INSTRUCTIONExampleREPLY
Vibration alarm (option)Shock123456shock ok
Intelligent mode (option)Sleepin123456Sleepin ok
Saving Power and GPRSupload positioning when vehicle move
not upload positioning when vehicle stops
ParameterCheck123456Device status
GPRS mode (default app tracking)gprs123456(default no need set)gprs ok
Cancel GPRS (SMS tracking)sms123456(default no need set)Sms ok
Set admin numberadmin123456 mobile numberadmin ok
Cancel admin numbernoadmin123456 mobile numbernoadmin ok
Set time zonetime zone123456 1 (1 is east 1, -1 is west 1)Time zone ok
Set time zone (half time zone)Time zone123456 8 30 (8 30 is east 8.5 time zone)time zone ok
Cancel low battery alarmLowbattery123456 offLow batter ok
ACC alarm (message inform)acc123456Acc ok
Cancel ACCNoacc123456Noacc ok
Cut off oil or powerCut123456Stop engine
Cut off oil or power (if car is driving at high speed, more safer by set stop car)Stop123456 (it will control stop the car when the speed is less than 20KM/H)Stop ok
Resume cut off oil or powerresume123456Resume engine
Real-time tracking (default 10s)fix030s***n123456 (Every 30s/1 times positioning, can change time interval)Tnok

6.1 Registering Administrator Account and Tracking Multiple Devices

If you need to register an administrator account and track multiple devices, follow these steps:

  1. In the app, go to user registration.
  2. Fill in the required account details.
  3. Log in to the registered account.
  4. Go to the device list and add devices by filling in their IMEI numbers.
  5. If you add more than two devices, continue to add IMEI numbers as needed.

6.2 Setting New IP and Port for Other Platforms

If you wish to use a different platform, you can set a new IP and port. (No need to set by default if using gps110.org)

  • SMS1: adminip123456 space IP space port
    Example: Adminip123456 103.110.152.62 7018
  • Or SMS1: adminip123456 space DNS space port
    Example: adminip123456 www.gps110.org 7018

7. Troubleshooting (FAQ)

FAQInstructions/Solutions
Fail to turn it onPlease check if connected to power 9V-36V and if the red light is solid.
No GSM signalPlease check if the SIM card is installed correctly and has money. Ensure there is a mobile phone GSM signal. Verify if the SIM card is 2G or 4G/3G compatible with a 2G GSM network. Do not turn on the PIN code, and ensure no calls are diverted.
No GPS signalA more open view of the sky is recommended to ensure the GPS signal is received normally. Take the device outdoors and walk around.
No reply to SMSPassword is wrong or the format is incorrect. To restore factory settings, send the SMS message begin123456.
SMS position OK, but cannot see position in APPPlease check if APN is correctly set or if GPRS is enabled in the SIM card.
Platform position difference and actual locationIf the position time doesn't update or there's no GPS signal, call the device's SIM card number and receive the position message. If it shows LBS information (like Figure 2 in the manual), ensure the device can receive the GPS signal normally outdoors and walk around. Make sure the SIM card is normal.

8. Specifications

ContentSpecs.
Dimensions95*50*13mm
Weight59g
NetworkGSM/GPRS
Band850/900/1800/1900Mhz
GPS Sensitivity-159dBm
GPS Accuracy5m
Work Voltage12V-36V
Time To First Fix (Cold status)45s
Time To First Fix (Warm status)35s
Time To First Fix (Hot status)1s
Storage Temperature-40°C to +85°C
Operation Temperature-20°C to +55°C
Humidity5%–95% non-condensing

9. User Tips

  • IMEI Activation: Ensure your device's IMEI is properly activated for lifetime use on the tracking platform (www.gps110.org). If you have multiple devices, you can request an admin account to manage them all.
  • Platform Access: If you encounter issues with platform access or an expired license, verify your IMEI activation status. This product offers lifetime activation for the specified platform.
  • Outdoor Testing: For initial setup and troubleshooting GPS signal issues, always test the device outdoors in an open area to ensure optimal signal reception.

10. Warranty and Support

For any issues not covered in this manual, please contact your seller or refer to the official product support channels. Keep your purchase records for warranty claims.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.