Introduction
Thank you for choosing the IKEA BONDTOLVAN Digital Alarm Clock. This manual provides important information regarding the setup, operation, maintenance, and specifications of your new alarm clock. Please read this manual thoroughly before using the product and keep it for future reference.
Front view of the IKEA BONDTOLVAN Digital Alarm Clock, displaying the time 11:30 and the day Monday.
Safety Information
- This product is intended for indoor use only.
- Do not expose the alarm clock to water or excessive moisture.
- Keep away from direct sunlight and heat sources.
- Do not attempt to open or repair the device yourself. Refer all servicing to qualified personnel.
- Ensure the power source used is compatible with the device's requirements.
- This product bears the CE mark, indicating compliance with European safety standards.
Package Contents
Please check the package for the following items:
- IKEA BONDTOLVAN Digital Alarm Clock
- Power Adapter (or USB cable, depending on model)
- Instruction Manual (this document)
Setup
- Unpacking: Carefully remove the alarm clock and all accessories from the packaging.
- Power Connection: Connect the power adapter (or USB cable) to the alarm clock and then plug it into a suitable power outlet. The display should light up.
- Initial Time Setting: Upon first power-up, the clock may display a default time or require manual setting. Refer to the "Operating Instructions" section for details on setting the time and date.
The alarm clock placed on a bedside table, ready for use.
Operating Instructions
The BONDTOLVAN alarm clock features a clear digital display and intuitive controls on the top panel.
Close-up view of the control buttons on the top of the alarm clock, including '+' and '-' buttons and an alarm icon button.
Setting the Time
- Press and hold the 'SET' button (or similar button, typically located on the top or back) until the hour display starts flashing.
- Use the '+' and '-' buttons to adjust the hour.
- Press 'SET' again to confirm the hour and move to minute setting.
- Use the '+' and '-' buttons to adjust the minutes.
- Press 'SET' one more time to confirm the minutes and exit time setting mode.
Setting the Alarm
- Press the 'ALARM' button (indicated by an alarm clock icon) until the alarm hour display starts flashing.
- Use the '+' and '-' buttons to adjust the alarm hour.
- Press 'ALARM' again to confirm the alarm hour and move to alarm minute setting.
- Use the '+' and '-' buttons to adjust the alarm minutes.
- Press 'ALARM' one more time to confirm the alarm minutes. The alarm icon should appear on the display, indicating the alarm is active.
Snooze Function
When the alarm sounds, press the large button on the top of the clock (often the same button used for setting or a dedicated snooze button) to activate the snooze function. The alarm will temporarily stop and sound again after a few minutes (typically 5-10 minutes).
Turning Off the Alarm
To turn off the alarm completely, press the 'ALARM' button repeatedly until the alarm icon disappears from the display. Alternatively, some models may require holding the 'ALARM' button or pressing a specific 'OFF' button.
Maintenance
Cleaning
- To clean the alarm clock, gently wipe it with a soft, dry cloth.
- Do not use abrasive cleaners, solvents, or strong detergents, as these may damage the surface or electronic components.
- Ensure the device is unplugged before cleaning.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Display is blank or not lighting up. | No power connection or power outage. | Check if the power adapter is securely plugged into both the clock and the wall outlet. Ensure the power outlet is functional. |
| Alarm does not sound. | Alarm not set or alarm volume is too low. | Verify that the alarm time is correctly set and the alarm icon is visible on the display. Check if there's a volume setting and adjust it. |
| Time is incorrect. | Time was not set correctly or power interruption. | Reset the time following the "Setting the Time" instructions. |
Specifications
| Feature | Detail |
|---|---|
| Model Name | BONDTOLVAN |
| Brand | IKEA |
| Designer | Aaron Probyn |
| Dimensions (Height x Width x Depth) | 8 cm x 20 cm x 6 cm |
| Main Material (Watch frame) | Polystyrene plastics (at least 20% recycled) |
| Display Material (Watcher) | PC plastic |
| Color | Green (as per product name) |
| Certification | CE Mark |
| Origin | China |
| Launch Date | January 1, 2023 |
Package Dimensions and Weight
- Width: 9 cm
- Height: 6 cm
- Length: 21 cm
- Weight: 0.28 kg
User Tips
- For optimal visibility, place the alarm clock on a flat surface at eye level, such as a bedside table or shelf.
- If the display brightness is adjustable, set it to a comfortable level for both day and night viewing.
The alarm clock displaying 12:04 and Sunday, positioned on a shelf.
Warranty and Support
For information regarding warranty, service, or technical support, please refer to the official IKEA website or contact IKEA customer service in your region. Keep your proof of purchase for any warranty claims.
