OPTOMA HR21G-YHGD03

Contents

OPTOMA Projector Remote Control HR21G-YHGD03 User Manual

Model: HR21G-YHGD03

Brand: OPTOMA

1. Introduction

This manual provides detailed instructions for the operation and maintenance of your OPTOMA Projector Remote Control, model HR21G-YHGD03. Please read this manual thoroughly before use to ensure proper functionality and to maximize the lifespan of your device.

Front view of the HR21G-YHGD03 remote control, showing power, menu, navigation, volume, and source buttons.

Figure 1: Front view of the HR21G-YHGD03 remote control.

2. Safety Information

  • Keep the remote control away from water and other liquids.
  • Do not expose the remote to direct sunlight or extreme temperatures.
  • Avoid dropping or subjecting the remote to strong impacts.
  • Do not attempt to disassemble or modify the remote control.
  • Dispose of batteries properly according to local regulations.

3. Package Contents

The package should contain the following items:

  • 1 x OPTOMA Projector Remote Control (Model: HR21G-YHGD03)
  • (Batteries are typically not included and must be purchased separately.)

4. Specifications

FeatureSpecification
Model NumberHR21G-YHGD03
Wireless CommunicationIR (Infrared)
Frequency433 MHz
Channel1
UseCinema Projector (Compatible with OPTOMA ZW350ST, ZH350, ZW340E, ZH520, GT2000HDR, HZ40HDR, UHZ66, GT2100HDR)
Power RatingDC 3V === 30mA (Requires 2x AAA batteries, not included)
OriginMainland China
CertificationNONE (FCC, CE markings visible on product)
Back view of the HR21G-YHGD03 remote control showing model number, power rating, FCC, and CE markings.

Figure 2: Back view of the remote control with specifications.

5. Setup

5.1. Installing Batteries

  1. Locate the battery compartment cover on the back of the remote control.
  2. Slide the cover downwards or press the latch (if present) to open the compartment.
  3. Insert two AAA batteries, ensuring the positive (+) and negative (-) terminals match the diagrams inside the compartment.
  4. Close the battery compartment cover securely.

5.2. Pairing with Projector (IR Communication)

This remote control uses Infrared (IR) communication. Typically, no pairing is required for IR remotes. Simply point the remote directly at the IR receiver on your OPTOMA projector and press a button. If the projector does not respond, ensure:

  • The batteries are correctly installed and have sufficient charge.
  • There are no obstructions between the remote control and the projector's IR receiver.
  • You are within the effective range of the remote control (usually up to 7 meters).

6. Operating Instructions

The HR21G-YHGD03 remote control provides intuitive access to your OPTOMA projector's functions. Below is a general guide to the main buttons:

6.1. Button Functions Overview

Detailed layout of the HR21G-YHGD03 remote control buttons.

Figure 3: Button layout of the remote control.

Button IconFunction
ⓘ (Power Symbol)Power On/Off: Turns the projector on or off.
□ (Rectangle with arrow)Source Selection: Cycles through available input sources (HDMI, VGA, USB, etc.).
↺ (Curved arrow)Return/Back: Navigates back in menus or exits current function.
💻 (Monitor Symbol)Display Mode/Aspect Ratio: Adjusts screen display settings or aspect ratio.
▲ (Up Arrow)Navigation Up: Moves cursor up in menus.
⚙ (Gear Symbol)Settings/Menu: Opens the projector's main settings menu.
◀ (Left Arrow)Navigation Left: Moves cursor left in menus.
◯ (Circle)OK/Confirm: Confirms selection in menus.
▶ (Right Arrow)Navigation Right: Moves cursor right in menus.
↵ (Curved arrow pointing down)Input/Enter: Confirms input or selection.
▼ (Down Arrow)Navigation Down: Moves cursor down in menus.
≡ (Three Horizontal Lines)Menu/Options: Accesses additional menu options.
🔊 (Speaker with waves)Volume Up: Increases audio volume.
🔇 (Speaker with X)Mute: Mutes or unmutes audio.
🔉 (Speaker with single wave)Volume Down: Decreases audio volume.
❄ (Snowflake/Brightness)Brightness/Mode: Adjusts brightness or picture mode.
▴▼ (Up/Down Triangles)Keystone Correction: Adjusts image geometry.
💻 (Monitor with arrow)Screen Blank/Freeze: Blanks the screen or freezes the image.

7. Maintenance

7.1. Cleaning the Remote Control

  • Wipe the remote control with a soft, dry cloth.
  • For stubborn dirt, lightly dampen the cloth with water or a mild cleaning solution. Do not use harsh chemicals or abrasive cleaners.
  • Ensure no liquid enters the remote control's openings.

7.2. Battery Replacement

Replace batteries when the remote control's response becomes sluggish or stops working. Always replace both batteries at the same time with new ones of the same type (AAA). Refer to Section 5.1 for battery installation instructions.

8. Troubleshooting

ProblemPossible Cause / Solution
Remote not responding.
  • Check if batteries are installed correctly and have sufficient charge. Replace if necessary.
  • Ensure there are no obstructions between the remote and the projector's IR receiver.
  • Point the remote directly at the projector's IR receiver.
  • Ensure you are within the effective range (approx. 7 meters).
Some buttons not working.
  • Clean the remote control, especially around the buttons, to remove any dirt or debris.
  • Ensure the remote is compatible with your specific projector model.
Projector responds intermittently.
  • Weak batteries. Replace them.
  • Interference from other electronic devices or strong light sources. Try using the remote in a different environment.

9. User Tips

  • Check Compatibility: Always verify that the remote control is compatible with your specific projector model before use. While this remote is designed for various OPTOMA projectors, compatibility can vary.
  • Battery Life: To extend battery life, remove batteries if the remote will not be used for an extended period.
  • Direct Line of Sight: For optimal performance, maintain a clear line of sight between the remote's IR emitter and the projector's IR receiver.

10. Warranty and Support

For warranty information, technical support, or service inquiries, please refer to the documentation provided with your OPTOMA projector or contact OPTOMA customer service directly. Keep your purchase receipt as proof of purchase.

11. Product Video Overview

The following video provides a general overview of various remote controls, including the type of product you have purchased. Please note that not all remotes shown may be identical to your specific model.

Video: Showcase of various remote controls.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.