1. Product Overview
This kit provides essential wiring and connectivity components for integrating various peripherals with a car Android system head unit that features a 16-pin connector. It includes a main wiring harness, USB adapters, a GPS antenna, and RCA cables for audio/video input and output.

Figure 1: All components included in the PHYEE Universal 16 Pin Wiring Harness Kit.
Video 1: Overview of the PHYEE Universal 16 Pin Wiring Harness Kit components.
2. Package Contents
- 1 x 16-Pin Main Wiring Harness
- 1 x RCA Harness (Audio/Video Input/Output)
- 1 x 4-Pin USB Cable
- 1 x 6-Pin USB Cable
- 1 x GPS Antenna
- 1 x Video Input & WiFi Antenna Cable
3. Setup and Installation
NOTE: The car radio must be a 16-Pin connector Android system for compatibility.
3.1 Component Identification

Figure 2: 1. 16-pin main harness, 2. RCA harness.

Figure 3: 3. 4-pin USB cable, 4. 6-pin USB cable, 5. Video input & WiFi antenna cable.

Figure 4: 6. GPS antenna.
3.2 Connecting to the Android Head Unit
Refer to the diagram below for connecting the harness kit to the back of your Android head unit.

Figure 5: Rear view of an Android head unit with numbered connection points.
- Main 16-Pin Harness (1): Connect the 16-pin main wiring harness to the corresponding port on your head unit. This harness provides power, speaker outputs, and other essential signals.
- USB Cables (2, 3): Connect the 4-pin USB cable (2) and the 6-pin USB cable (3) to their respective USB ports on the head unit. These are used for connecting USB devices like flash drives or smartphones.
- RCA Harness (4): Connect the RCA harness to the multi-pin connector (4) on the head unit. This harness provides various audio and video input/output options (e.g., AUX IN, SUBWOOFER OUT, CVBS IN).
- Video Input & WiFi Antenna (5): Connect the video input cable (yellow RCA) and the integrated WiFi antenna to port (5). This is typically for a reverse camera video input and WiFi connectivity.
- GPS Antenna (6): Connect the GPS antenna to the dedicated GPS port (6) on the head unit. Position the GPS antenna in a location with a clear view of the sky for optimal signal reception.
3.3 CAN Bus Setting Operation (If Applicable)
If your vehicle requires a CAN Bus decoder for steering wheel controls or other vehicle data integration, follow these steps:

Figure 6: CAN Bus wiring diagram and setting instructions.
- Connect Harness and Decoder: Connect the harness adapter and the CAN Bus decoder correctly as shown in Figure 6. The CAN Bus decoder typically connects via an 8-pin connector (CAN TXD, CAN RXD).
- Access Factory Settings: On your Android head unit, enter the factory settings menu (a password may be required, consult your head unit's manual). Navigate to the