ABIR K30 Robot Vacuum Cleaner

Introduction

Thank you for choosing the ABIR K30 Robot Vacuum Cleaner. This manual provides essential information for the safe and efficient operation, maintenance, and troubleshooting of your new device. Please read it thoroughly before use and keep it for future reference.

General Safety Guidelines

1. Check the voltage available at your home and ensure it matches the voltage mentioned on your appliance before switching it on.
2. The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they are under supervision or have been given correct and necessary instructions.
3. If the power cord is damaged, please get it replaced at a service centre or by a person designated by the manufacturer or a qualified person to avoid electric shock.
4. Always keep the unit on a dry and flat surface.
5. Never touch any appliance or equipment with wet or damp hands.
6. While plugging or unplugging a power cord, hold it by the plug, never pull the cord.
7. Do not connect the equipment to an extension cord or a multiple socket adaptor. Always connect the unit to the main socket to prevent short circuits and sparks, which can shorten the life of the unit and prove risky for your life.
8. Do not let the power cord hang over the edge of the table or a work surface as a sharp edge can damage the cable over a period of time.
9. Do not let it get tangled or come into contact with a hot surface.
10. Do not attempt to repair the unit in case of any malfunction; always take it to an authorised service centre.
11. Do not use any attachments other than the ones supplied by or specified by the manufacturer.
12. Never leave the unit unattended while in operation, especially when children are around.
13. Children should be supervised to ensure that they do not play with the appliance.
14. The equipment is for household use only; do not use it for commercial purposes.
15. All appliances and equipment are designed for indoor use. Do not use them outdoors unless specifically mentioned in the instruction manual.
16. Always unplug the unit from the power source during lightning and thunderstorms, or when the unit is not going to be used for a long period of time.
17. To avoid risk of electric shocks, do not immerse the equipment in water or use it in damp conditions.
18. The unit should be cleaned with a damp cloth and immediately wiped dry. Do not use detergents or chemical cleaning agents to clean the unit.
19. Always clean cooking appliances soon after use; this will prevent food from sticking to the unit and the possible bacterial growth.
20. WARNING: If the surface is cracked, switch off the appliance to avoid electric shock.
21. WARNING: Children younger than 3 must not use the appliance due to their inability to react to operate the appliance.

Important Safeguards

1. Please use the product according to the instructions in this manual. Any operation inconsistent with this manual may lead to the damage of the product.
2. This appliance can be used by children aged 8 years old and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
3. Please do not allow children to sit on the product or play with the product as a toy.
4. Before using the product, please move the power cable and small items on the ground to avoid the product being blocked during cleaning; fold the fringe of the carpet under the carpet and keep the draped curtains, tablecloths, etc. from touching the ground.
5. If using the product near a stair or cliff area, please test to ensure it can detect the edge and avoid falling. If necessary, install a protective barrier to prevent the product from falling, making sure the barrier is secure and does not pose a tripping hazard or cause other injuries.
6. Please make sure that the power supply voltage conforms to the voltage marked on the charging dock.
7. This product is an indoor household product; please do not use it outdoors.
8. Only use the original rechargeable battery and charging dock provided by the manufacturer. Do not use non-rechargeable batteries, as this is strictly prohibited.
9. Do not use the product in an environment with open flames or fragile items.
10. The operating temperature of the product ranges from 0 °C to 40 °C.
11. Do not let your hair, clothes, fingers and other parts close to the product's intake port when it's working.
12. Do not use the product in the humid or stagnant environment during the vacuum operation mode.
13. Do not use the product to clean combustible materials such as gasoline, printer toner, or photocopier powder. Avoid using the product in areas with flammable items.
14. Do not allow the product to clean any burning items, such as cigarettes, matches, ashes and other items that may cause fire.
15. Do not place any items at the intake port. Avoid using the product if the intake port is blocked. Clean dust, cotton, and hair from the intake port regularly to ensure proper operation.
16. Handle the power cable with care: Do not use it to drag or pull the product or its charging base, use it as a handle, clamp it in door gaps, pull it around sharp corners, allow the product to run over it, or expose it to heat sources.
17. If the power cable is damaged, it should be replaced by a professional from the manufacturer's maintenance department or similar department in order to avoid danger.
18. Do not use the charging dock if it's damaged.
19. Do not use a damaged cable or power socket to charge the product, and do not use the product if it is not working properly due to falling, damage, outdoor use, or being wet; for safety, have any repairs done by the manufacturer or its after-sales service department.
20. Always disconnect the robot from the outlet and turn off power before cleaning and maintaining it.
21. Unauthorized removal of the battery is not allowed.
22. Please clean the hair from the universal caster and brush promptly.
23. To prevent damage to the PCPA plate, avoid letting the robot cartwheel during mopping, as water may flow over the edges of the tank.
24. Do not use the robot on carpets. Ensure that no water stains appear where the water tank is placed.
25. Always wipe the water tank after filling it.
26. To maintain peak performance, empty the dust bin regularly to prevent filter jams.
27. Before discarding the appliance, disconnect it from the charging dock, turn off the power, and remove the battery. Dispose of the battery according to local laws and regulations.
28. Avoid exposing the robot to extreme temperatures; it operates only within a range of 0°C to 40°C.
29. It is forbidden to burn the product even if it is seriously damaged, as the battery may cause an explosion.
30. If the product will not be used for an extended period, please turn it off.
31. Check whether the charger and socket are properly connected, otherwise it may cause a fire.
32. Plug the charger power cable tightly, otherwise it may cause electric shock, short circuit, smoke or fire.
33. Do not stand or sit on the robot to avoid damage to the robot or personal injury.
34. Do not touch the power cable when your hands are wet, or it may cause electric shock.
35. Only authorized technicians can disassemble the product, and users are not allowed to disassemble the product.
36. It is a battery-operated appliance, the battery being charged outside the appliance.

Product Overview

Main Machine Components

The main machine features a laser obstacle sensor, laser range sensor, laser collision avoidance sensor, and a system reset button on the top. It also has a power button and recharge button.

Bottom View and Side Components

The bottom of the robot includes side brushes, cliff sensors (detection at 9 cm), driving casters, universal caster, main brush, and main brush cover. The charging terminal is also located on the robot.

Charging Dock with Dust Box

The charging dock serves as a self-emptying station. It features infrared lenses and sensor heads for proper docking and dust collection.

Packing List

The package includes:

• Robot Vacuum Cleaner
• 2-in-1 Water Tank
• Mop
• Self-Empty Base (Charging Dock with Dust Box)
• Side Brush (extra set included)
• HEPA + Primary Filter + Sponge (extra set included)
• Main Brush
• Cleaning Brush
• User Manual (PDF)
• Remote Control
• Dust Bag (extra set included)

Technical Data

Setup

Unboxing and Initial Preparation

Video Description: This video demonstrates the unboxing of the ABIR K30 robot vacuum cleaner and its auto-empty dock, followed by the initial setup steps including attaching brushes and connecting to the mobile application.

1. Carefully unpack all components from the box.
2. Insert the side brushes into their designated slots on the bottom of the robot.
3. Remove any protective inserts or films from the robot and charging dock.
4. Place the charging dock with the dust box against a wall on a flat ground. Ensure there are no obstacles within 1.2 meters in front of the charging dock and within 0.5 meters on both sides.
5. Plug the power cord of the charging dock into a suitable power socket.
6. For initial use, fully charge the robot by placing it on the charging dock.

APP Connection

1. Download the 'Smart Life' app from your app store.
2. Open the app and tap the '+' icon in the top right corner to add a device.
3. Select 'Robot Vacuums' under 'Small Appliances'.
4. On the robot, press and hold the button with the house icon for more than 3 seconds. The indicator light will start blinking. Confirm this in the app.
5. The robot will automatically connect via Wi-Fi.

Operating Instructions

Power On/Off/Pause

• Power On: Press and hold the power button for more than 3 seconds. The robot will broadcast a voice message and enter standby mode.
• Start Cleaning: In standby mode, short press the power button to start global cleaning mode.
• Pause: During cleaning, short press the power button to pause the cleaning task.
• Power Off: When the robot is stationary, press and hold the power button for 3 seconds. The power indicator light will turn off.
• Sleep Mode: The robot enters sleep state if there is no operation for 10 minutes. Short press any button to wake it up.

Automatic Recharge

• If the battery is low during cleaning, the robot will automatically return to the charging dock.
• After cleaning is complete, the robot will automatically return to the charging dock to recharge.
• You can also short press the recharge button on the robot to send it back to the charging dock.

Cleaning Modes and Features

• 360 Degree Full View Scanning: The robot maps your room in seconds to design the most efficient cleaning path.
• Multi-Map Saving: Create and save floor plans for each floor of your house, allowing the robot to adapt to multi-floor environments.
• Partition Cleaning: Name rooms in the app and instruct the robot to clean specific areas.
• Software Restricted Areas / Virtual Blocker: Use the app to define 'No-Go Lines' or restricted zones to prevent the robot from entering certain areas.
• Adjustable Suction Power: Manage 3 levels of suction power (Silent 2500PA, Standard 4500PA, Max 6500PA) via the app. The robot automatically switches to turbo mode on carpets.
• Innovative Y Shape Mopping Mode: Mimics hand-mopping with back-and-forth motions for a better cleaning effect.
• Breakpoint Resume Cleaning: If the robot's battery runs low during cleaning, it will return to the charging dock, recharge, and then resume cleaning from where it left off.
• Scheduled Cleaning: Set a cleaning schedule for specific days and times via the app.
• Multi-language Voice Pack: Select different voice languages for robot prompts via the app.
• Smart Home Integration: Compatible with Google Home & Alexa for voice control.

Maintenance

Changing the Dust Bag (Self-Emptying Station)

The LED indicator light on the charging dock will turn red when the dust bag is full. It is recommended to replace the dust bag every 4 weeks.

1. Open the dust station cover.
2. Remove the worn-out dust bag.
3. Throw away the full dust bag and replace it with a new one.
4. Close the top cover and ensure the dust collection station is properly covered.

Cleaning the Dust Tube

If the charging dock's indicator light is red, the dust tube might be blocked. Unplug the power, reverse the dust box, and check for foreign objects. Remove the transparent cover of the dust tube with a screwdriver and clean it. Reassemble after cleaning.

Cleaning the Fan Filter

The fan filter is located under the dust bag. When dust accumulates, wipe it with a clean, soft, dry cloth. It is recommended to clean it once a month.

Cleaning the Main Brush

The main brush is a consumable item and should be cleaned at least once a week. Replace it every 6 or 12 months to ensure cleaning quality.

1. Turn over the robot, press the buckle on the main brush cover, and remove the main brush cover and main brush.
2. Use the cleaning tool to cut entangled hair on the main brush and use the cleaning brush on the other end to clean the main brush.
3. When flipping the robot, avoid collisions to prevent damage.

Cleaning/Replacing the Side Brush

The side brush is a consumable item. Replace it every 3-6 months to ensure cleaning effectiveness.

1. Remove the worn side brush.
2. Install a new side brush back in place.

Cleaning Sensors

It is recommended to gently wipe each sensor with a clean, soft, dry cloth every week to ensure normal operation of the machine. This includes the Cliff sensors (x4), Infrared sensors (x3), Electrode (x2), and Wall sensor (x1).

Cleaning the 2-in-1 Water Tank and Filter

Press and hold the release button of the 2-in-1 water tank and simultaneously pull it out. Open the cover of the water tank and add purified water. If the mop is too dirty, it will affect mopping quality; clean it in time. Be sure to remove the mop for cleaning and install it after drying. Do not clean it when it is installed on the 2-in-1 water tank, otherwise the dirty water will clog the filter element. The mop is a consumable item; replace it once every 3 or 6 weeks. The filter is also a consumable item; replace it every 3-6 months.

Battery Maintenance

The robot has a built-in high-performance rechargeable lithium-ion battery pack. To maintain battery performance, keep the battery charged at all times. If the machine is not used for a long time, turn it off and store it, charging the battery at least once every three months to prevent battery damage due to overdischarge.

Troubleshooting

When an operation exception occurs, the power indicator will flash red light quickly, and the robot will issue a voice prompt for some of the faults. Refer to the table below for solutions.

User Tips

• The ABIR K30 is designed primarily for hard floors. While it can detect carpets and increase suction, it is not a washing vacuum and will not remove old stains.
• The robot supports multiple floor maps, making it suitable for multi-level homes.
• The robot is compatible with smart home systems like Google Home and Alexa for convenient voice control.
• To ensure optimal performance, regularly check and clean all brushes, filters, and sensors.
• If you lose the physical manual, a digital PDF version is available online.

Warranty and Support

The ABIR K30 Robot Vacuum Cleaner comes with a 3-year warranty. For any malfunctions or repairs, please contact an authorized service center. Do not attempt to disassemble or repair the product yourself, as this may void the warranty and pose safety risks.

This product complies with CE and RoHS directives, ensuring it meets European safety and environmental standards.

For further assistance, please refer to the official ABIR support channels or the provided user manual (PDF) for detailed instructions and diagrams: User manual (PDF)