Introduction
This manual provides detailed instructions for the proper handling, installation, operation, and maintenance of the Miyota 2315 quartz watch movement. The Miyota 2315 is a standard three-hand movement with a date display, designed for reliable timekeeping in various watch applications.


Specifications
| Feature | Detail |
|---|---|
| Caliber No. | 2315 |
| Type | Quartz Movement |
| Size | 11 1/2''' |
| Height | 4.15mm |
| Accuracy | ±20 seconds per month |
| Battery Life | 3 years |
| Balance Weight (Minute) | 0.40 μN・m |
| Balance Weight (Second) | 0.09 μN・m |
| Functions | Three Hands (Hour, Minute, Second), Date Display |
| Battery Type | SR626SW |


Setup and Installation
The Miyota 2315 movement is designed for watch assembly or replacement. Professional installation is recommended to avoid damage to the delicate components.
Crown Positions:
- Normal Position (0): Watch is running.
- 1st Position: Used for setting the date.
- 2nd Position: Used for setting the time (hour and minute hands).
Operating Instructions
Setting the Time:
- Pull the crown out to the 2nd position. This will stop the second hand.
- Turn the crown in either direction to set the hour and minute hands to the desired time.
- Once the time is set, push the crown back into the normal position (0). The second hand will begin to run, indicating the watch is operating.
Setting the Date:
- Pull the crown out to the 1st position.
- Turn the crown counter-clockwise to advance the date.
- Important Note: Avoid setting the date between approximately 9:00 PM and 1:00 AM, as this can interfere with the automatic date change mechanism and potentially damage the movement. If the date is set during this period, it may not change correctly on the following day.
- After the date has been set, push the crown back into the normal position (0).
Maintenance
Battery Replacement:
The Miyota 2315 movement uses an SR626SW battery, which typically lasts for 3 years. When the battery needs replacement, it is recommended to have it done by a qualified watchmaker to ensure proper handling and sealing of the watch case.
- Always use the specified battery type (SR626SW).
- Ensure the battery is inserted with the correct polarity.
- Dispose of old batteries responsibly.
General Care:
- Avoid exposing the movement to extreme temperatures, strong magnetic fields, or excessive shocks.
- Keep the movement clean and free from dust and moisture.
- If the watch stops or exhibits irregular behavior, consult a professional watch repair service.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Watch stops running | Depleted battery | Replace battery (SR626SW) |
| Incorrect time display | Time not set correctly | Refer to "Setting the Time" section |
| Date does not change automatically | Date set during restricted hours (9 PM - 1 AM) or incorrect setting | Reset date outside restricted hours; refer to "Setting the Date" section |
| Intermittent stopping or erratic behavior | Low battery, shock, magnetic interference, or internal damage | Replace battery; consult a professional watchmaker for inspection and repair. |
User Tips
- When replacing the movement, ensure all hands are properly aligned and secured to prevent them from touching each other or the dial.
- Handle the movement with anti-static tweezers and gloves to avoid contamination and damage from oils or static discharge.
- Always double-check the crown stem length and fit when installing a new movement to ensure smooth operation and proper water resistance (if applicable to the watch case).
Warranty and Support
For warranty information or technical support regarding your Miyota 2315 movement, please refer to the official Miyota documentation or contact an authorized service center. As this is a component part, warranty terms may vary depending on the watch manufacturer or the seller from whom the movement was purchased.
For further assistance, please contact your watch repair specialist or the original vendor.