ALTHY U200PRO

Contents

ALTHY U200PRO Under Sink Water Purifier User Manual

Model: U200PRO

1. Product Overview

Thank you for choosing ALTHY products. The ALTHY U200PRO under-sink water purifier utilizes Nano antibacterial carbon rod filter elements to provide clean and safe drinking water.

The U200PRO water purifier is designed to effectively filter sediment, rust, 99% residual chlorine, and chloride from your water. Its carbon rod filter element incorporates MetSorb Adsorbent Media, which is NSF certified and patented. This advanced media efficiently removes heavy metals such as cadmium, lead, chromium, and arsenic, achieving a removal rate of over 90%.

Note: The AL-U200Pro does not reduce the TDS (Total Dissolved Solids) value of water. TDS value is not the sole basis for judging water quality.

Diagram showing U200PRO's 5-in-1 Nano Integrated Composite Technology filter
Figure 1: U200PRO's 5-in-1 Nano Integrated Composite Technology filter, combining PPF, ACF, AGF, KDF, and MetSorb® for comprehensive filtration.
Diagram illustrating NSF 42 & 53 certified filtration elements
Figure 2: NSF 42 & 53 certified filtration elements removing 99.99% of contaminants like rust, sand, bacteria, chlorine, odor, fluoride, lead, and insects, while retaining beneficial minerals.
Close-up of MetSorb® Adsorbent Media
Figure 3: MetSorb® Adsorbent Media, certified to NSF Standard 42, designed for efficient removal of heavy metals such as arsenic, lead, and mercury from drinking water.

2. Safety Information

Please read all safety instructions carefully before installation and use. Failure to follow these instructions may result in product damage or personal injury.

2.1. Prohibitions ⚠

  • Do not use accessories not approved by ALTHY. Unauthorized accessories may cause mechanical failure and will void the warranty.
  • In case of any malfunction, immediately turn off the main water supply to the unit. Do not operate a defective product.

2.2. Warnings ⚠

  • Children and individuals with disabilities should only use this product under the direct supervision of a guardian.
  • If a malfunction occurs, ensure the main water supply is turned off immediately. Do not attempt to use a faulty product.
  • All installation pipelines must comply with international safety standards.

2.3. Important Notes

  • If additional accessories are required for installation, please ensure they are high-quality products.
  • This product is designed for municipal tap water. The applicable water pressure range is 15-100 psi (100-689 kPa), and the applicable water temperature is 5°C~38°C (41-100°F). If your water pressure exceeds this range, a pressure reducing valve must be installed.
  • This product is suitable for indoor installation only. Ensure there is a reliable floor drain within 1.5 meters (approximately 5 feet) of the installation location to prevent potential water damage from leaks.
  • If the product will not be used or left unattended for more than 3 days, please shut off the water source to prevent damage or leakage due to external factors.

⚠ WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

3. Packing List

The following items are typically included with the ALTHY U200PRO Under Sink Water Purifier system. Please check that all components are present before installation.

  • Water purifier (with filter)
  • Water purifier faucet
  • Three-way valve
  • User Manual (this document)
  • Faucet hanging plate
  • Raw material belt (Teflon tape)
  • Water purifier connector
  • PE pipe
  • Self-tapping screws (x3)
  • Expansion tubes (x3)
  • Buckles for water purifier connector (x5)
Image of four replacement filters for ALTHY U200PRO
Figure 4: Example of replacement filter packaging (4x filters shown).
Image of two replacement filters for ALTHY U200PRO
Figure 5: Example of replacement filter packaging (2x filters shown).

4. Setup and Installation

This product offers a flexible and convenient water supply solution. The recommended installation method is as follows:

4.1. Site Selection

  1. Select a suitable installation location, typically under the sink. Ensure a floor drain is available nearby.

4.2. Connecting the Water Purifier

  1. Connect the water purifier to your household tap water point. Pay close attention to the following during installation:
    • When installing pipe joints, any joints without gaskets should be wrapped with an appropriate amount of raw material tape (Teflon tape) to ensure a watertight seal.
    • Refer to the installation diagram for proper connection of the three-way valve, PE pipe, and water purifier faucet.
Installation diagram for the under-sink water purifier
Figure 6: Installation diagram showing connections to the cold water angle valve, three-way valve, PE pipe, and water purifier faucet.
ALTHY U200PRO dimensions and operating conditions
Figure 7: ALTHY U200PRO dimensions (70mm width, 330mm height) and operating conditions: Municipal water, 6-12 months/8000 Gallons filter life, 0.1-0.4Mpa water pressure.

5. Operating Instructions

  1. After completing the installation, open the three-way valve.
  2. Turn on the water purifier faucet and flush the water for at least 10 minutes until the water runs clear. This purges air and loose carbon fines from the new filter.
  3. After this initial flush, the water purifier is ready for normal use.
Images showing filtered water being used for drinking and washing
Figure 8: Filtered water from the ALTHY U200PRO is suitable for both drinking and washing.

6. Maintenance: Filter Replacement

Regular filter replacement is crucial for maintaining optimal water quality and purifier performance. The filter life is typically 6-12 months or 8000 gallons, depending on water quality and usage.

6.1. Filter Replacement Method

  1. Close the three-way valve to shut off the water supply to the purifier.
  2. Open the water purifier faucet to drain any remaining water from the system and relieve pressure.
  3. Unscrew the filter bottle counterclockwise by hand to remove the old filter element.
  4. Tear off the protective film from the new filter element.
  5. Screw the new filter element into the base, then place it back into the filter bottle and tighten the filter bottle clockwise by hand until secure.
  6. After replacement, follow the operating instructions (Section 5) to flush the new filter.
Diagram showing quick 1-minute filter replacement
Figure 9: The ALTHY U200PRO features a quick 1-minute filter replacement process, offering a large flow rate of 3 L/min and a filter life of 8000 Gallons or 1 year.

7. Troubleshooting

If you encounter any issues with your ALTHY U200PRO water purifier, refer to the table below for common problems and their solutions.

SymptomPossible CausesSolutions
Clean water flow drops significantlyFilter clogged
Water pressure is too low
Ball valve not fully open
Replace with a new filter element
Take measures to increase water pressure
Check and fully open the ball valve
Poor effluent qualityFilter failure
Long-term inactivity (more than 3 days)
Source water poor quality
Replace with a new filter element
Turn on the faucet and let water flow for at least 10 minutes
Ensure the water source is municipal tap water
Water leakagePE pipe not inserted correctly
Joint damage, PE pipe rupture, three-way ball valve damage
Install the PE pipe in place
Replace corresponding accessories, or contact ALTHY customer service

8. Specifications

ParameterValue
Product NameALTHY Under Sink Water Purifier
ModelAL-U200Pro
Maximum Flow Rate1.6 GPM (3.0 Liters/Minute)
Total Filtered Water Capacity8000 Gallons (depends on water quality)
Filter MethodNano antibacterial carbon rod (5 Stage Filtration: PPF, ACF, AGF, KDF, MetSorb®)
Filtration Accuracy0.01 micron
Filter Life6-12 months (depends on water quality)
Working Water Pressure15-100 psi / 100-689 kPa (0.1-0.4 Mpa)
Applicable Water Temperature5-38°C / 41-100°F
Applicable Water QualityMunicipal Water
Power SourceNon-electric
MaterialUltrafiltration Membrane
Purifying PositionTerminal Purification
Installation TypeUnder Sink (Kitchen/Table)
FunctionDirect Drink
CertificationsCE, RoHS, Water Mark, NSF/ANSI (NSF 42 & 53)
China Water Quality Agency Certification document
Figure 10: China Water Quality Agency Certification confirming 99.99% removal rate for 64 types of harmful substances.

9. User Tips

  • TDS Levels: Remember that these filters are designed to remove contaminants while retaining beneficial minerals, so they do not lower TDS (Total Dissolved Solids) levels. A high TDS reading does not necessarily indicate poor water quality with this type of filter.
  • Filter Life: The cartridge typically lasts 6-12 months or 8000 gallons. This duration can vary based on your local water quality and usage frequency.
  • Initial Flush: Always perform the initial 10-minute flush after installing a new filter to ensure optimal performance and clear water.
  • Packaging: Filters often arrive well-packaged, sometimes with bubble wrap or air cushions, to prevent damage during transit.

10. Warranty and Support

The ALTHY U200PRO Under Sink Water Purifier comes with a One Year Guarantee from the date of purchase.

For further assistance, technical support, or to inquire about replacement parts, please contact ALTHY customer service.

A detailed user manual in PDF format is also available for download: ALTHY U200PRO User Manual (PDF).

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.