DEKO CSP-400BL, CSP-750BY

Contents

DEKO Sump Pump Instruction Manual

Models: CSP-400BL, CSP-750BY

Introduction

This manual provides essential information for the safe and efficient operation and maintenance of your DEKO 400W/750W Sump Pump. This portable submersible pump is designed for clean and dirty water removal in various applications such as draining sumps, transferring water from one place to another, irrigating gardens, crops, and washing cars. It is an indispensable tool for every family, offering high power and small size.

Product Overview

DEKO Sump Pump Model CSP-400BL
Figure 1: DEKO Sump Pump (CSP-400BL model shown) with float switch and output connection.
Labeled parts of DEKO Sump Pump
Figure 2: Key components of the DEKO Sump Pump, including the pump handle, cable, switch (float switch), output tie-in, and water suction port.

Setup Instructions

  1. Attach the Output Tie-in: Securely screw the output tie-in connector onto the pump's outlet.
  2. Connect the Discharge Hose: Attach a suitable discharge hose to the output tie-in. The pump comes with four outlet options (1", G1", 1-1/4", G1-1/2") to choose from. For higher flow rates, a wider outlet (e.g., G1-1/2") should be used. Use a hose clamp to ensure a tight, leak-free connection.
    Video 1: Demonstration of attaching the output tie-in and hose to the pump.
  3. Position the Pump: Place the pump in the water to be drained. Ensure it is stable and upright. The pump is fully submersible.
  4. Float Switch Placement: Position the float switch so it can move freely and activate the pump at the desired water level. The pump will automatically start when the water level rises and the float switch lifts, and stop when the water level drops and the float switch lowers.
  5. Power Connection: Connect the pump to a suitable power outlet (refer to specifications for correct voltage).

Operating Instructions

The DEKO Sump Pump is designed for automatic operation via its integrated float switch. Once properly set up and connected to power, the pump will operate as follows:

  • When the water level rises and lifts the float switch to its 'on' position (approximately 500mm from the pump base), the pump will automatically start draining water.
  • As the water level drops and the float switch falls to its 'off' position (approximately 250mm from the pump base), the pump will automatically stop.
  • The pump is suitable for both clean and dirty water, capable of handling particles up to 35mm in size.
DEKO Sump Pump CSP-400BL in operation, draining water from a pond.
Figure 3: The CSP-400BL model actively pumping water from a pond.
DEKO Sump Pump CSP-750BY in operation, draining water from a pond.
Figure 4: The CSP-750BY model actively pumping water from a pond.

Maintenance

Regular maintenance ensures the longevity and optimal performance of your DEKO Sump Pump.

  • Cleaning: Periodically clean the pump, especially the water suction port, to remove any debris, sediment, or foreign objects that may impede its operation. Ensure the float switch is also free from obstructions.
  • Inspection: Regularly inspect the power cable, float switch cable, and hose connections for any signs of wear, damage, or leaks. Replace damaged components immediately.
  • Storage: When not in use for extended periods, clean the pump thoroughly, drain any remaining water, and store it in a dry, frost-free location.

Troubleshooting

If your DEKO Sump Pump is not operating as expected, consider the following common issues:

  • Pump does not start:
    • Check if the pump is properly plugged into a working power outlet.
    • Ensure the float switch is not obstructed and is free to move to the 'on' position.
    • Verify that the power supply voltage matches the pump's requirements.
  • Pump runs but no water is discharged:
    • Check for blockages in the water suction port or the discharge hose.
    • Ensure the pump is fully submerged in water.
    • Verify that the discharge hose is not kinked or blocked.
  • Pump cycles on and off too frequently:
    • Adjust the position of the float switch to allow for a wider range of water level fluctuation.
    • Check for leaks in the discharge system that might be causing water to flow back into the sump.

For persistent issues, please contact customer support.

Specifications

Below are the detailed specifications for the DEKO Sump Pump models. Note that some specifications may vary slightly between production batches or regions.

DEKO Sump Pump Product Features and Specifications
Figure 5: Detailed product features and specifications for both DEKO 400W and 750W Electric Submersible Water Pumps.

Model: CSP-400BL

FeatureSpecification
TypeWater Pump
Power Consumption400 W
Power Supply220 V ~ 60 Hz
Max. Flow Rate8000 L/H
Max. Pump Height (H.Max)5 m
Max. Submersion Depth7 m
Protection TypeIPX8
Connection TypeG1-1/2"
Weight (approx.)3.7 kg
Max. Particle Size35 mm
Threaded Connection1", 1-1/4", 1-1/2"
Min Operating Depth115 mm
Max Water Level After Suction35 mm
Cable Type & LengthH05RN-F3G0.75MM2*5 m
Hose Connection Inner Diameter25 mm; 32 mm
Height for Switch On500 mm
Height for Switch Off250 mm
DEKO Sump Pump CSP-400BL flow rate chart
Figure 6: Flow rate curve for DEKO Sump Pump Model CSP-400BL. The flow rate decreases as the pumping height increases. Max flow rate is 8000L/H at 0m height, approaching 0L/H at 5m height. Four outlet diameters are available: 1" (25mm), G1", 1-1/4" (32mm), and G1-1/2". The G1-1/2" outlet is recommended for flow rates up to 8000L/H.

Model: CSP-750BY

FeatureSpecification
TypeWater Pump
Power Consumption750 W
Power Supply220 V ~ 60 Hz
Max. Flow Rate14000 L/H
Max. Pump Height (H.Max)8 m
Max. Submersion Depth7 m
Protection TypeIPX8
Connection TypeG1-1/2"
Weight (approx.)4.7 kg
Max. Particle Size35 mm
Threaded Connection1", 1-1/4", 1-1/2"
Min Operating Depth115 mm
Max Water Level After Suction35 mm
Cable Type & LengthH05RN-F3G0.75MM2*5 m
Hose Connection Inner Diameter25 mm; 32 mm
Dimensions170 x 158 x 330 (mm)
Plug Fuse Specifications5A
Height for Switch On500 mm
Height for Switch Off250 mm
DEKO Sump Pump CSP-750BY flow rate chart
Figure 7: Flow rate curve for DEKO Sump Pump Model CSP-750BY. The flow rate decreases as the pumping height increases. Max flow rate is 14000L/H at 0m height, approaching 0L/H at 8m height. Four outlet diameters are available: 1" (25mm), G1", 1-1/4" (32mm), and G1-1/2". The G1-1/2" outlet is recommended for flow rates up to 14000L/H.

General Information:

  • Origin: Mainland China

Warranty and Support

DEKO Service and Brand Story
Figure 8: DEKO's commitment to service, including warranty and technical support, and brand philosophy.

DEKO is committed to providing high-quality tools. Your DEKO Sump Pump comes with a one-year warranty. Additionally, DEKO offers free lifetime technical support for this product.

DEKO specializes in the design and production of power tools, with a philosophy to provide well-designed and cost-effective tools to customers worldwide.

For warranty claims, technical assistance, or any inquiries, please contact DEKO customer service.


Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.