Introduction
The Radtel RT-890 is a versatile multi-band amateur two-way radio designed for a wide range of communication needs. Featuring extensive frequency coverage, NOAA weather alerts, and advanced functions like one-key frequency copy, this radio is suitable for both amateur enthusiasts and professionals requiring reliable communication in various environments.

Key Features
- Full Band Coverage: 136-660MHz (RX/TX), 64-108MHz (FM Rx), 108-136MHz (Air Band Receiving at AM Mode).
- NOAA Weather Channel: 11 US weather channels for real-time alerts.
- One-Key Frequency Copy: Quickly capture and decode frequencies from other radios.
- Automatic Frequency Match: Simplifies channel setup.
- USB Type-C Charging: Convenient and modern charging option.
- 999 Memory Channels: Ample storage for your preferred frequencies.
- Channel Name Edit: Customize channel names for easy identification.
- VOX Function: Voice-activated transmission for hands-free operation.
- Emergency Alert & SOS: Built-in safety features for critical situations.
- Scan Function: Efficiently scan for active frequencies.
- Battery Save: Extends battery life during prolonged use.
- PC Programming: Customize settings and channels via computer.
- DTMF Encoding/Decoding: For advanced signaling.
- CTCSS/DCS: Privacy codes for interference-free communication.
- FM Standby Mode: Listen to FM radio while monitoring for radio traffic.
- TX Priority & TOT: Transmission priority and Time-Out Timer functions.
- Roger Beep: Audible tone indicating end of transmission.
- Busy Channel Lockout: Prevents transmission on occupied channels.
- Scrambler/Companding: Enhances privacy and audio quality.
- FQSCAN: Detects frequency and CTCSS/DCS from other radios.

Setup Guide
1. Battery Installation
To install the battery, align the battery pack with the back of the radio and slide it into place until it clicks securely. To remove, press the release latch and slide the battery off.
2. Antenna Attachment
Screw the antenna clockwise onto the connector at the top of the radio until it is finger-tight. Do not overtighten.
3. Initial Charging
Before first use, fully charge the radio's battery using the provided USB Type-C cable. Connect the cable to the Type-C port on the side of the radio and to a compatible USB power source.

Operating Instructions
Power On/Off
Rotate the power/volume knob clockwise to turn the radio on. Continue rotating to adjust the volume. Rotate counter-clockwise until a click is heard to turn the radio off.
Frequency Modes
The RT-890 supports various frequency bands for transmitting and receiving:
- FM Broadcast: 64-108MHz (Receive only)
- AM Air Band: 108-136MHz (Receive only)
- VHF: 136-199MHz (Transmit/Receive)
- 220MHz Band: 200-299MHz (Transmit/Receive)
- 350MHz Band: 300-400MHz (Transmit/Receive)
- UHF: 400-520MHz (Transmit/Receive)


Menu Navigation
Use the 'MENU' button to access the main menu. Use the up/down arrow keys to scroll through options. Press 'MENU' again to select an option, and 'EXIT A/B' to go back or exit the menu.
NOAA Weather Alerts
The radio can receive 11 NOAA US weather channels. This feature allows you to stay informed about severe weather conditions, especially useful for outdoor activities.

One-Key Frequency Copy (FQSCAN)
This function allows the radio to detect and copy frequencies and CTCSS/DCS tones from another radio. Activate FQSCAN mode, place the RT-890 near the transmitting radio, and press the designated button to initiate the copy process. This is also referred to as 'Wireless Copy Frequency'.

Scanning Function
The radio can scan through programmed channels or a frequency range to find active transmissions. Refer to the menu settings for 'Scan DIR' (Scan Direction) and 'Prior Channel Scanning' options.
VOX Function
Voice-Operated Exchange (VOX) allows for hands-free transmission. When enabled, the radio will transmit automatically when it detects your voice. Adjust the VOX level and delay in the menu settings (Menu 15 and 17).
Maintenance and Care
- Cleaning: Use a soft, damp cloth to clean the radio's exterior. Do not use harsh chemicals or solvents.
- Battery Care: Use only the designated charger. Do not disassemble the battery, put it into fire, or short-circuit it.
- Storage: Store the radio in a cool, dry place when not in use. Remove the battery if storing for extended periods.
- Water Resistance: This product is NOT waterproof/water-resistant. Avoid exposure to water or high humidity.
- Physical Protection: The radio is designed with pressure and fall resistance, but avoid dropping it from significant heights or subjecting it to extreme impacts.
Troubleshooting
No Power / Radio Not Turning On
- Ensure the battery is properly installed and fully charged.
- Check the battery contacts for any dirt or corrosion.
- Verify the power/volume knob is rotated clockwise sufficiently.
Poor Reception or Transmission Range
- Ensure the antenna is securely attached.
- Check for obstructions (buildings, hills) between radios.
- Verify that you are operating within the optimal frequency ranges (136-174MHz / 400-520MHz for best performance).
- Confirm the correct CTCSS/DCS codes are set if privacy codes are in use.
- Environmental factors (terrain, weather) can significantly affect range.
Scanning Stops Frequently
- The scanner may be stopping on weak signals or noise. Adjust the SQ Level (Squelch Level) in the menu settings (Menu 12) to a higher value to filter out weaker signals.
- Check the scan resume settings in the menu to ensure it's configured as desired (e.g., time-operated, carrier-operated).
Firmware Update Issues
The radio is delivered with factory stock firmware. If you wish to upgrade to OEFM M70CM firmware, you will need to download the appropriate firmware and use a computer for the upgrade process. Ensure you download the correct version for your PCB (check Menu 46 for your PCB version):
- For 2.1 PCB: Download Firmware 2.1
- For 2.0 PCB: Download Firmware 2.0


Specifications
| Attribute | Value |
|---|---|
| Brand Name | radtel |
| Model Number | RT-890 |
| Walkie Talkie Type | Portable |
| Output Power (W) | 3W-5W |
| Frequency Range | 108-520MHz |
| Storage Channel | 999 |
| Battery Capacity (mAh) | 1100mA or 2000mA |
| Battery Included | Yes |
| Maximum Range | 3km-5km |
| Waterproof / Water-Resistant | No |
| Is Display | Yes |
| Material | Plastic |
| Dimensions | 108*59*38 mm |
| Weight | 189g (no accessories) |
| NOAA Weather Channel | Yes |
| Air Band Receive | Yes |
User Tips
- Scanning Behavior: If the scanner stops on every signal, even weak ones, try increasing the squelch level (SQ Level) in the menu settings to filter out noise.
- Firmware Updates: Always check your radio's PCB version (Menu 46) before downloading and attempting a firmware update to ensure compatibility.
- Range Expectations: While rated for 3-5km, actual range can vary significantly based on environmental conditions, terrain, and obstructions. Optimal performance is typically achieved in open areas.
- DMR Compatibility: Please note that the Radtel RT-890 is an analog radio and does not support DMR (Digital Mobile Radio).
- Frequency Coverage: The radio is designed for full band TX/RX across 136-660MHz, with specific receive-only bands for FM (64-108MHz) and AM Air Band (108-136MHz).
Warranty and Support
For warranty information, technical support, or service inquiries, please refer to the official Radtel website or contact your authorized dealer. Keep your purchase receipt as proof of purchase.