1. Introduction
This manual provides essential information for the safe and efficient operation, maintenance, and troubleshooting of your Ronix RH-4705 Portable Gasoline Generator. Please read this manual thoroughly before operating the generator to ensure proper use and to prevent injury or damage.
2. Safety Information
WARNING: Failure to follow these safety instructions could result in serious injury or death.
- Carbon Monoxide Hazard: Generators produce carbon monoxide (CO), a colorless, odorless, poisonous gas. DO NOT USE INDOORS OR IN ENCLOSED SPACES. Always operate the generator outdoors in a well-ventilated area, far away from windows, doors, and vents.
- Fire Hazard: Gasoline is highly flammable. Refuel in a well-ventilated area with the engine off and cool. Do not smoke or allow open flames near the generator. Store fuel in approved containers.
- Electrical Shock Hazard: Do not operate the generator in wet conditions. Ensure all electrical connections are secure and dry. Do not overload the generator.
- Hot Surfaces: The generator engine and muffler become very hot during operation and remain hot for some time after shutdown. Avoid contact to prevent burns.
- Keep children and pets away from the generator during operation.
- Always wear appropriate personal protective equipment (PPE) when handling fuel or performing maintenance.

3. Product Overview
The Ronix RH-4705 is a portable gasoline generator designed to provide reliable electrical power. It features a 4-stroke air-cooled engine and a robust frame for durability and portability.
3.1 Key Components

- Fuel Tank: Located on top, with a capacity of 15 liters.
- Engine Switch (ENG.SW): Controls engine ON/OFF.
- AC Outlets: For connecting 230V appliances.
- DC12V Outlet: For connecting 12V DC devices, equipped with a protector.
- Breaker: Overload protection for AC output.
- Voltmeter: Displays output voltage.
- Recoil Starter: Manual starting mechanism.
- Air Filter: Protects the engine from dust and debris.
- Oil Alert System: Automatically shuts down the engine if oil level is too low.

4. Specifications
The following table details the technical specifications of the Ronix RH-4705 generator:
| Feature | Specification |
|---|---|
| Model Number | RH-4705 |
| Engine Type | 4-stroke, Air-cooled, LB156F |
| Engine Displacement | 210cc |
| Engine Horsepower | 7.0 HP |
| Rated Voltage | 230V |
| Frequency | 50Hz |
| Rated Current | 12.1-13 Amp |
| Max Output Power | 3000W |
| Continuous Output Power | 2800-3000W (copper winding) |
| Fuel Tank Capacity | 15 Liters |
| Starting System | Recoil Start + Electric Start |
| Continuous Operation Hours | 10 hours |
| Protection Features | DC12V with protector, Oil Alert, AVR (Automatic Voltage Regulator) |
| Approx. Shipping Dimensions (L x W x H) | 61 cm x 44 cm x 44 cm |
| Approx. Shipping Weight | 11.0 kg |
| Certification | CE |
5. Setup
5.1 Unpacking and Inspection
- Carefully remove the generator from its packaging.
- Inspect for any shipping damage. Contact your dealer immediately if damage is found.
- Ensure all components listed in the packing list are present.
5.2 Adding Engine Oil
The generator is shipped without engine oil. It is crucial to add the correct type and amount of oil before first use.
- Place the generator on a level surface.
- Remove the oil filler cap/dipstick.
- Add recommended 4-stroke engine oil (e.g., SAE 10W-30) to the proper level, as indicated on the dipstick. Do not overfill.
- Securely replace the oil filler cap/dipstick.
5.3 Adding Fuel
Use fresh, unleaded gasoline with an octane rating of 87 or higher.
- Ensure the generator is off and cool.
- Move the generator to a well-ventilated outdoor area for refueling.
- Remove the fuel cap.
- Carefully pour gasoline into the fuel tank, avoiding spills. Do not fill above the red indicator or the bottom of the filler neck.
- Securely replace the fuel cap. Wipe up any spilled fuel immediately.
5.4 Placement
- Always operate the generator outdoors in a well-ventilated area.
- Place the generator on a firm, level surface.
- Maintain at least 3 feet (1 meter) of clearance from buildings, other equipment, and combustible materials.
6. Operating Instructions
6.1 Starting the Engine
Ensure the generator has sufficient fuel and oil before starting.
- Turn the engine switch (ENG.SW) to the "ON" position.
- If the engine is cold, move the choke lever to the "CHOKE" position.
- For Recoil Start: Pull the recoil starter handle slowly until resistance is felt, then pull sharply and quickly. Repeat if necessary.
- For Electric Start (if equipped): Press and hold the electric start button until the engine starts.
- Once the engine starts, gradually move the choke lever to the "RUN" position.
- Allow the engine to warm up for a few minutes before connecting electrical loads.
6.2 Connecting Electrical Loads
- Ensure the generator is running stably.
- Plug your appliances into the AC outlets or DC12V outlet.
- Do not exceed the generator's rated output (3000W max, 2800-3000W continuous). Overloading will trip the breaker.
- If the breaker trips, reduce the load, then reset the breaker.
6.3 Stopping the Engine
- Disconnect all electrical loads from the generator.
- Allow the engine to run for a few minutes without load to cool down.
- Turn the engine switch (ENG.SW) to the "OFF" position.
7. Maintenance
Regular maintenance is essential for the longevity and reliable operation of your generator. Always ensure the engine is off and cool before performing any maintenance.
7.1 Maintenance Schedule
| Item | First Month / 20 Hours | Every 3 Months / 50 Hours | Every 6 Months / 100 Hours | Every Year / 300 Hours |
|---|---|---|---|---|
| Check Engine Oil Level | Check before each use | Check before each use | Check before each use | Check before each use |
| Change Engine Oil | Replace | Replace | Replace | Replace |
| Clean Air Filter | Clean | Clean | Clean | Clean |
| Inspect Spark Plug | Inspect | Inspect | Replace | |
| Inspect Fuel Filter | Inspect | Inspect |
7.2 Storage
For long-term storage (more than 30 days):
- Drain the fuel tank and carburetor. Run the engine until it stops from lack of fuel.
- Change the engine oil.
- Remove the spark plug and pour a tablespoon of engine oil into the cylinder. Crank the engine a few times to distribute the oil, then reinstall the spark plug.
- Clean the exterior of the generator.
- Store in a clean, dry, well-ventilated area, away from direct sunlight and heat sources.
8. Troubleshooting
This section provides solutions to common operational issues. For problems not listed here, contact customer support.
| Problem | Possible Cause | Solution |
|---|---|---|
| Engine will not start | No fuel or low fuel level | Add fresh gasoline to the fuel tank. |
| Engine switch in "OFF" position | Turn engine switch to "ON". | |
| Low engine oil level | Add engine oil to the proper level. The oil alert system will prevent starting. | |
| Choke not set correctly (cold engine) | Move choke lever to "CHOKE" for cold starts, then gradually to "RUN". | |
| No power output | Circuit breaker tripped | Reduce electrical load and reset the circuit breaker. |
| Overloaded generator | Ensure total wattage of connected devices does not exceed 2800-3000W. |
9. User Tips
- Always use fresh fuel to prevent carburetor issues. Stale fuel can cause starting problems and engine damage.
- Periodically check and clean the air filter to ensure optimal engine performance and longevity.
- When using the electric start, ensure the battery is charged. If the battery is low, use the recoil start.
10. Warranty & Support
This Ronix RH-4705 generator comes with a 1-year warranty from the date of purchase, covering manufacturing defects. Please retain your proof of purchase for warranty claims.
For technical assistance, parts, or warranty inquiries, please contact your authorized Ronix dealer or customer service.