Introduction
Thank you for choosing the OUPINKE 3269 Automatic Mechanical Wristwatch. This manual provides essential information for the proper setup, operation, and maintenance of your new timepiece. The OUPINKE 3269 combines meticulous design with authentic Swiss watchmaking technology, featuring a precise automatic movement, durable sapphire crystal, and an ultra-thin profile for a sophisticated look.
Setting Up Your Watch
1. Unboxing and Initial Inspection
Upon receiving your OUPINKE 3269, carefully remove it from its packaging. Inspect the watch for any visible damage or missing components. Ensure the protective films are removed from the crystal and case back.
2. Winding the Watch
Your OUPINKE 3269 features an automatic self-wind movement. While it winds itself with the motion of your wrist, it may require initial manual winding if it has stopped or has not been worn for an extended period.
- Ensure the crown is in position 1 (fully pushed in).
- Turn the crown clockwise approximately 30-40 times. This will provide enough power reserve to start the watch.
- The watch will continue to wind itself as you wear it.
3. Setting Time and Date
To set the time and date:
- Setting the Date: Pull the crown out to position 2. Turn the crown clockwise or counter-clockwise (depending on the model) to adjust the date. Avoid setting the date between 9 PM and 3 AM, as this is when the date change mechanism is active and could cause damage.
- Setting the Time: Pull the crown out to position 3. Turn the crown to move the hands clockwise until the correct time is displayed. Ensure you pass 12 o'clock twice if setting for PM hours.
- Once the time and date are set, push the crown back into position 1 (fully pushed in) to secure it and ensure water resistance.
Operating Your Watch
1. Automatic Movement
The OUPINKE 3269 is powered by a Swiss automatic self-wind movement (STP1-11), featuring 26 ruby bearings and a vibration frequency of 28,800 times/hour for stable and accurate timekeeping. The movement harnesses the kinetic energy from your wrist's natural motion to wind the mainspring. When fully wound, the watch has a power reserve that allows it to run for a certain period without being worn. If the watch stops, simply manually wind it as described in the 'Winding the Watch' section.
2. Luminous Display
The watch features luminous hands and markers, allowing for improved readability in low-light conditions. The luminous material charges by absorbing light and then emits a glow in the dark.
Maintenance and Care
1. Water Resistance
Your OUPINKE 3269 watch has a water resistance rating of 5 Bar (50 meters). This means it is suitable for everyday use, including showering and swimming in shallow water. However, it is crucial to:
- Avoid operating the crown or pushers while the watch is wet or submerged.
- Avoid exposing the watch to hot water, steam, or extreme temperature changes, as this can compromise the seals.
- Do not wear the watch in saunas or hot tubs.
2. Cleaning
To maintain the appearance of your watch, wipe the case and crystal with a soft, dry, lint-free cloth. For the leather strap, use a slightly damp cloth if necessary, and allow it to air dry completely. Avoid using chemical cleaners, solvents, or abrasive materials, as these can damage the watch's finish or strap.
3. Leather Strap Care
The genuine leather strap is designed for comfort and durability. To prolong its life:
- Avoid prolonged exposure to direct sunlight, which can cause fading or cracking.
- Minimize contact with water, oils, and cosmetics.
- If the strap gets wet, gently blot it dry and allow it to air dry naturally.
4. Sapphire Crystal
The watch features a sapphire crystal, known for its high scratch resistance. While highly durable, it is not entirely scratch-proof. Avoid unnecessary impacts or contact with extremely hard surfaces.
Troubleshooting Common Issues
- Watch has stopped: If the watch has not been worn for a while, manually wind it using the crown (30-40 clockwise turns). Ensure consistent wear to keep the automatic movement powered.
- Date not changing: Check if the time is set correctly, especially if it's passing midnight. Avoid setting the date between 9 PM and 3 AM.
- Condensation under crystal: This may indicate a breach in water resistance. Avoid further contact with water and seek professional service immediately.
Product Specifications
| Feature | Specification |
|---|---|
| Brand Name | OUPINKE |
| Model Number | OUPINKE 3269 Watch For Men |
| Item Type | Mechanical Wristwatches |
| Movement | Automatic Self-Wind (Swiss STP1-11) |
| Dial Window Material Type | Sapphire Crystal |
| Case Material | Stainless steel |
| Case Shape | Round |
| Case Thickness | 7.3mm (without mirror) |
| Dial Diameter | 41mm |
| Band Material Type | Leather (Imported Italian leather belt) |
| Band Width | 20mm |
| Band Length | 24cm |
| Clasp Type | Buckle (Convenient pin buckle) |
| Water Resistance Depth | 5Bar (50 meters) |
| Features | Luminous, Shock Resistant, Complete Calendar |
| Weight | 63g |
User Tips
- The OUPINKE 3269 is recognized for its high-quality construction, reliable Swiss movement, and water resistance, making it a stylish and functional accessory for business or casual wear.
- Key features like the shock-resistant design, waterproof functionality, luminous display, and round case shape contribute to its popularity and distinctive appeal.
- For optimal performance, wear your automatic watch regularly. If stored, consider a watch winder to keep it running and maintain lubrication.
Warranty and Support
OUPINKE offers a lifetime return assurance for this product. For any questions, maintenance inquiries, or support needs, please contact OUPINKE customer service. Refer to your purchase documentation for specific contact details.
For a visual guide on the watch's features and design, you may view the official product video:
Official product video showcasing the OUPINKE 3269 watch.
