FGHGF V80 V85

Contents

Instruction Manual

FGHGF Replacement Parts for ZACO V80 V85 Robot Vacuum Cleaner

This manual provides detailed instructions for the installation, operation, and maintenance of the water tank box and mop cloths designed for ZACO V80 and V85 robot vacuum cleaners.

Introduction

These replacement parts are designed to restore or enhance the mopping functionality of your ZACO V80 or V85 robot vacuum cleaner. Proper installation and maintenance ensure optimal performance and longevity of your device.

Parts Included

Depending on your purchase, your package may include:

  • 1 x Water Tank Box for ZACO V80/V85
  • 5 x Mop Cloths for ZACO V80/V85
ZACO V80 V85 Water Tank Box
Front view of the water tank box with a warning label indicating "Do not immerse in water".
ZACO V80 V85 Mop Cloths
A set of five blue mop cloths.

Specifications

FeatureDetail
Brand NameFGHGF
Compatible ModelsZACO V80, ZACO V85
Part TypeWater Tank Box, Mop Cloths
Material (Mop Cloths)Microfiber
OriginMainland China
High-concerned chemicalNone

Setup & Installation

Installing the Water Tank Box

  1. Ensure your ZACO V80/V85 robot vacuum cleaner is powered off and disconnected from its charging base.
  2. Locate the water tank compartment on your robot vacuum. This is typically at the rear or bottom of the device.
  3. Open the compartment cover or remove the existing dustbin/water tank if present.
  4. Fill the new water tank box with clean water. Do not overfill. Observe the "Do not immerse" warning on the tank itself.
  5. Carefully slide the filled water tank box into the designated slot until it clicks securely into place.
  6. Close any compartment covers.
ZACO V80 V85 Water Tank Box Bottom View
Bottom view of the water tank box, showing attachment points for mop cloths.

Attaching Mop Cloths

  1. If installing mop cloths, ensure the water tank box is already installed.
  2. Locate the Velcro strips or attachment points on the underside of the water tank box.
  3. Align a clean mop cloth with these attachment points and press firmly to secure it. Ensure the cloth is evenly spread and not bunched up.
ZACO V80 V85 Mop Cloths Bottom View
Bottom view of the mop cloths, showing the texture and stitching.

Operating Instructions

Once the water tank and mop cloths are installed, your ZACO V80/V85 robot vacuum is ready for mopping. Refer to your robot vacuum's main instruction manual for specific mopping mode activation.

  • Water Dispensing: The robot vacuum will automatically dispense water from the tank to moisten the mop cloth during mopping cycles.
  • Mopping Area: Ensure the robot operates on hard floor surfaces suitable for mopping. Avoid carpets or rugs when the water tank is installed.
  • Monitoring: Periodically check the water level in the tank and the cleanliness of the mop cloth during extended mopping sessions.

Maintenance

Water Tank Box Care

  • Emptying: After each mopping session, empty any remaining water from the tank to prevent stagnation and mold growth.
  • Cleaning: Rinse the water tank with clean water. If necessary, use a mild detergent and a soft brush to clean the interior. Ensure it is thoroughly rinsed to remove all soap residue.
  • Drying: Allow the water tank to air dry completely before re-installing or storing it.
  • Warning: Do NOT immerse the entire water tank box in water, especially the electronic components. Clean only the water reservoir area.

Mop Cloth Care

  • Removal: Detach the mop cloth from the water tank box after each use.
  • Cleaning: Hand wash or machine wash the mop cloths with a mild detergent. For best results, wash separately from other laundry.
  • Drying: Air dry the mop cloths completely before re-attaching them to the water tank or storing them. Do not tumble dry on high heat as it may damage the fabric.
  • Replacement: Replace mop cloths every 1-3 months, or sooner if they show signs of wear, tear, or reduced cleaning effectiveness.

Troubleshooting

  • No Water Dispensing:
    • Check if the water tank is properly filled and installed.
    • Ensure the robot vacuum is in mopping mode.
    • Verify that the water outlet nozzles on the tank are not clogged. Clean if necessary.
  • Mop Cloth Not Cleaning Effectively:
    • Ensure the mop cloth is clean and properly attached.
    • The mop cloth may be worn out and require replacement.
    • Check if the water tank is dispensing water correctly.
  • Water Leakage:
    • Ensure the water tank is correctly seated and sealed.
    • Do not overfill the water tank.
    • Inspect the water tank for any cracks or damage. Replace if damaged.

User Tips

  • For best mopping results, pre-sweep or vacuum the floor to remove loose debris before using the mopping function.
  • Use only clean water in the tank. Avoid using harsh cleaning solutions or detergents that are not approved for robot vacuums, as they can clog the system or damage components.
  • Regularly check and clean the water tank and mop cloths to maintain hygiene and performance.
  • Keep spare mop cloths on hand for continuous mopping without interruption.

Warranty & Support

For warranty information or technical support regarding your ZACO V80/V85 robot vacuum cleaner or these replacement parts, please refer to the original manufacturer's documentation or contact their customer service directly.

These replacement parts are manufactured by FGHGF and are compatible with ZACO V80 and V85 models.

Documents and downloads

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.