SHIMANO RD-TZ31-A-GS

Contents

Shimano TOURNEY RD-TZ31-A-GS Rear Derailleur Instruction Manual

Model: RD-TZ31-A-GS | Brand: SHIMANO

1. Introduction

This manual provides essential information for the safe and effective use, installation, and maintenance of your Shimano TOURNEY RD-TZ31-A-GS Rear Derailleur. This derailleur is designed for 6, 7, 18, and 21-speed bicycle systems, suitable for mountain bikes and folding bikes. Please read this manual thoroughly before installation and use to ensure optimal performance and safety.

Shimano TOURNEY RD-TZ31-A-GS Rear Derailleur (Hook and Eye types)
Figure 1: Shimano TOURNEY RD-TZ31-A-GS Rear Derailleur, showing both Hook and Eye mounting types.

2. Safety Information

⚠ Warning

  • This product is not a toy and is not suitable for children under 16 years old without adult supervision.
  • Keep all small parts (e.g., screws, pulleys) away from infants and toddlers to avoid choking hazards.
  • Always wear appropriate protective gear (helmet, gloves, knee pads) when operating the bicycle with this derailleur.
  • Do not use the product in traffic without proper training.
  • Ensure the derailleur is correctly installed and adjusted before use. Improper installation may cause chain slippage, leading to falls or serious injury.
  • Do not modify the derailleur's structure or components. Unauthorized modifications void compliance and safety guarantees.
  • This product is not intended for use with children's bicycles (refer to EN 14765 for children-specific requirements).
  • Keep the derailleur away from corrosive substances (acids, solvents) and extreme temperatures to prevent mechanical failure.

Additional Safety Notes

  • Regularly inspect the derailleur for wear, damage, or loose connections.
  • Replace worn parts immediately using genuine Shimano accessories.

3. Setup and Installation

Proper installation is crucial for the performance and safety of your derailleur. If you are unsure about any steps, it is recommended to seek assistance from a qualified bicycle mechanic.

3.1. Choosing the Correct Type (Hook vs. Eye)

The RD-TZ31-A-GS is available in two mounting types: Hook and Eye. Ensure you have the correct type for your bicycle frame.

  • Hook Type: Mounts directly to a dropout that has an integrated derailleur hanger.
  • Eye Type: Mounts to a separate derailleur hanger that is bolted to the frame.
Shimano TOURNEY RD-TZ31 Hook Type Rear Derailleur
Figure 2: RD-TZ31 Hook Type Rear Derailleur.
Shimano TOURNEY RD-TZ31 Eye Type Rear Derailleur
Figure 3: RD-TZ31 Eye Type Rear Derailleur.

3.2. General Installation Steps (Consult a professional if unsure)

  1. Attach the derailleur to the frame's derailleur hanger (or directly to the dropout for hook type) using the appropriate bolt. Ensure it is securely tightened to the manufacturer's specifications.
  2. Route the shift cable through the cable housing and attach it to the derailleur's cable fixing bolt.
  3. Adjust the high (H) and low (L) limit screws to prevent the chain from overshifting off the smallest or largest cogs.
  4. Adjust the B-tension screw to set the proper distance between the upper guide pulley and the cogs.
  5. Fine-tune the cable tension using the barrel adjuster for smooth shifting across all gears.
Detailed view of Shimano TOURNEY RD-TZ31 Eye Type Rear Derailleur
Figure 4: Detailed view of the RD-TZ31 Eye Type Rear Derailleur, highlighting key adjustment points.

4. Operating Instructions

The Shimano TOURNEY RD-TZ31-A-GS derailleur is designed for reliable shifting on 6-speed and 7-speed systems, which translates to 18-speed (3x6) or 21-speed (3x7) setups when combined with a triple front chainring.

4.1. Shifting Gears

  • Use your bicycle's shift levers to move the chain between different cogs on the rear cassette.
  • Shift to a lower gear (larger cog) for easier pedaling on inclines.
  • Shift to a higher gear (smaller cog) for faster speeds on flat terrain or descents.
  • Always pedal lightly when shifting to ensure smooth and efficient gear changes and to prevent damage to the drivetrain components.

4.2. Speed Compatibility

This derailleur is compatible with:

  • 6-speed rear cassettes
  • 7-speed rear cassettes
  • Total system speeds of 18 (3x6) or 21 (3x7) when paired with a compatible front derailleur and chainrings.

5. Maintenance

Regular maintenance will extend the life of your derailleur and ensure consistent performance.

5.1. Cleaning

  • Keep the derailleur, especially the pulleys and cage, clean from dirt and grime. Use a brush and a suitable bicycle degreaser.
  • Rinse thoroughly with water and dry completely after cleaning.

5.2. Lubrication

  • Lubricate the pivot points of the derailleur and the chain regularly with appropriate bicycle lubricant.
  • Wipe off any excess lubricant to prevent attracting dirt.

5.3. Inspection Schedule

Inspect and lubricate the derailleur every 500 km or every 3 months, whichever comes first.

  • Check for any signs of wear, cracks, or damage on the derailleur body, cage, and pulleys.
  • Ensure all bolts are securely tightened.
  • Verify that the shift cable is not frayed or corroded.
  • Check for proper alignment of the derailleur hanger.
Close-up of derailleur pulleys and cage
Figure 5: Close-up view of the derailleur pulleys, which require regular cleaning and lubrication.

6. Troubleshooting

Here are some common issues and their potential solutions:

Problem Possible Cause Solution
Difficulty shifting to smaller cogs (higher gears) Too much cable tension, bent derailleur hanger, dirty cable/housing. Decrease cable tension (turn barrel adjuster clockwise), check/straighten hanger, clean/replace cable and housing.
Difficulty shifting to larger cogs (lower gears) Too little cable tension, bent derailleur hanger, dirty cable/housing. Increase cable tension (turn barrel adjuster counter-clockwise), check/straighten hanger, clean/replace cable and housing.
Chain rubbing on derailleur cage Limit screws incorrectly set, bent derailleur hanger. Adjust H/L limit screws, check/straighten hanger.
Noisy shifting or drivetrain Lack of lubrication, dirty components, incorrect B-tension, bent hanger. Clean and lubricate chain/derailleur, adjust B-tension, check/straighten hanger.
Derailleur not moving smoothly Dirt/grime in pivots, damaged spring, bent cage. Clean and lubricate pivots, inspect for damage (replace if necessary).

If problems persist after attempting these solutions, it is recommended to consult a professional bicycle mechanic.

7. Specifications

Feature Detail
Brand SHIMANO
Model Number RD-TZ31-A-GS (TZ31)
Type Rear Derailleur
Derailleur Groupset Type Mechanical Derailleur system
Speed Compatibility 6/7 speed (18/21 speed)
Mounting Type Hook / Eye
Material Alloy
Weight ±257g
Color Black
Application Mountain Bike, Folding Bike
Origin Japan (Jp)
Shimano TOURNEY RD-TZ31 Rear Derailleur with key features and dimensions
Figure 6: Key features and approximate dimensions of the RD-TZ31 Rear Derailleur.
Shimano TOURNEY RD-TZ31 Rear Derailleur showing dimensions
Figure 7: Additional dimensional details for the RD-TZ31 Rear Derailleur.

8. User Tips

  • Compatibility Check: Before purchasing or installing, verify that the derailleur's mounting type (hook or eye) and speed compatibility (6/7 speed) match your bicycle's frame and drivetrain components.
  • Professional Installation: If you are not experienced with bicycle mechanics, consider having the derailleur installed and adjusted by a professional to ensure optimal performance and safety.
  • Careful Use: Handle the derailleur with care during installation and use to prevent damage, which can affect shifting performance.
  • Dimension Verification: For specific fitment, especially for folding bikes or custom builds, it may be helpful to measure the distance between pulley centers or other dimensions to ensure proper clearance.

9. Compliance and Manufacturer Information

9.1. Applicable Regulations & Harmonized Standards

This product complies with the following EU regulations and standards:

  • General Product Safety Directive (GPSD): 2001/95/EC
  • Mechanical Directive (MD): 2006/42/EC

Harmonized Standards:

  • EN ISO 4210-2:2015 (Bicycle safety requirements for city, trekking, mountain bikes)
  • EN 14781:2015 (Racing bicycle specific safety standards)
  • REACH Regulation (EC) No 1907/2006 (Restriction of hazardous substances)

9.2. Usage Restrictions

This product is Not Suitable For:

  • Children under 16 years old (without adult supervision)
  • Bicycles with wheel sizes below 26" or above 29"
  • Electric bicycles with motor power exceeding 250W
  • Off-road use in extreme conditions (e.g., rock climbing, steep descents >30°)

Environmental Restrictions: Do not use in saltwater environments (e.g., coastal areas) without proper corrosion protection.

9.3. EU Declaration of Conformity (DoC)

This product (Shimano Bicycle Derailleur, Model: Universal Fit for Road/Gravel/MTB/E-Bike) meets the essential requirements of EU Directive 2006/42/EC (Mechanical Directive) and related harmonized standards. A complete copy of the DoC is available upon request from the EU Responsible Person.

For the full PDF user manual, please refer to the official document: Shimano TOURNEY RD-TZ31-A-GS User Manual (PDF)

9.4. Manufacturer Information

Detail Information
Manufacturer Name Shimano Inc.
Manufacturer Address 3-1-1 Sakai-cho, Sakai-ku, Osaka, Japan
Manufacturer Contact support@shimano.com
EU Responsible Person Name MJCM SARL
EU Responsible Person Address 78 avenue des Champs Elysees, Bureau 326, 75008 Paris, France
EU Responsible Person Phone +33-752907452
EU Responsible Person Email mjcm190928@gmail.com

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.