Introduction
This manual provides detailed instructions for the safe and efficient operation of your Hicon Countertop Ice Maker Machine. Please read it thoroughly before first use and keep it for future reference. This appliance is designed to produce square ice cubes for household or light commercial use.
Safety Instructions
- Read all instructions before operating the appliance.
- Ensure the power supply voltage matches the rating label on the appliance.
- Do not immerse the appliance, power cord, or plug in water or other liquids.
- Keep the appliance away from heat sources and direct sunlight.
- Supervise children when the appliance is in use.
- Unplug the appliance from the power outlet when not in use, before cleaning, or during maintenance.
- Do not operate the appliance with a damaged cord or plug.
- Use only potable water in the ice maker.
- Ensure proper ventilation around the appliance.
Package Contents
- 1 x Hicon Countertop Ice Maker Machine
- 1 x Ice Scoop
- 1 x User Manual
Product Overview
Setup
1. Unpacking and Placement
- Remove all packaging materials and inspect the ice maker for any damage.
- Place the ice maker on a flat, stable surface, ensuring adequate ventilation around the unit, especially near the heat dissipation fan on the side.
2. Initial Cleaning
Before using your ice maker for the first time, it is strongly recommended to clean it thoroughly:
- Take out the ice basket.
- Clean the interior with a diluted detergent solution, warm water, and a soft cloth.
- Rinse the inside parts with clean water and drain the water completely from the draining port by unplugging the water drainage cap on the bottom.
- Clean the exterior of the ice maker regularly with a mild detergent solution and warm water.
- Dry the interior and exterior with a soft cloth.
3. Water Filling
The ice maker offers two convenient ways to add water:
- Manual Water Addition: Open the top lid and pour potable water directly into the water reservoir until it reaches the MAX fill line. The reservoir capacity is 3 liters.
- Bottled Water Installation: Place a 1-gallon water bottle (with a 5 cm base) upside down into the designated slot on top of the ice maker. The machine will automatically draw water as needed.
Video: Water Filling Demonstration
This video demonstrates both manual water pouring and the installation of a bottled water container for the ice maker.
Operating Instructions
1. Power On/Off
- Plug the ice maker into a grounded electrical outlet.
- Press the 'ON/OFF' button on the control panel to turn the machine on or off.
2. Ice Production
- Once powered on and water is added, the machine will begin its ice-making cycle.
- Each cycle produces 24 square ice cubes.
- The ice maker can produce up to 44 lbs (20 kg) of ice in 24 hours.
3. Adjusting Ice Cube Size
- Use the '+' and '-' buttons on the control panel to select your desired ice cube size.
- Available sizes and approximate production times:
- Small: Approximately 11 minutes per cycle.
- Medium: Approximately 15 minutes per cycle.
- Large: Approximately 20 minutes per cycle.
4. Indicator Lights
- The LCD display and indicator lights will provide status updates:
- 'Add Water' Indicator: Lights up when the water tank is low, reminding you to refill.
- 'Ice Full' Indicator: Lights up when the ice basket is full, indicating that ice production will pause until some ice is removed.
- Any unused ice melts back into the reservoir for future use, minimizing waste.
Maintenance
1. Automatic Self-Cleaning Program
- To Start: With the unit plugged in, press and hold the 'TIMER/CLEAN' button on the control panel for more than 5 seconds. The ice maker will enter a 20-minute self-cleaning program. The display will show a rotating symbol and a '20M' countdown.
- To Cancel: The program will automatically switch to an off-state after 20 minutes. You can also press the 'ON/OFF' button at any time to manually cancel the self-cleaning program.
2. Manual Cleaning and Draining
- Regularly clean the ice maker as described in the 'Initial Cleaning' section.
- To drain the water reservoir, locate the water drainage cap on the bottom of the unit, unplug it, and allow all water to flow out. Ensure the cap is securely re-plugged before next use.
- When the machine is not in use for a long time, always drain the water completely from the reservoir to prevent stagnation and maintain hygiene.
Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Ice maker not turning on | No power supply | Check if the power cord is securely plugged in and the outlet is functional. |
| No ice production | Water reservoir is empty | Refill the water reservoir. The 'Add Water' indicator should be on. |
| Ice basket is full | Remove ice from the basket. The 'Ice Full' indicator should be on. | |
| Ice cubes are too small or not solid | Ambient temperature is too high | Ensure the ice maker is in a cool, well-ventilated area. |
| Water quality issues | Use filtered or distilled water for better ice quality. | |
| Unusual noise during operation | Normal compressor operation | Some noise is normal during the ice-making cycle. If noise is excessive or unusual, contact customer support. |
Specifications
| Feature | Specification |
|---|---|
| Brand | Hicon |
| Model No. | WZB-25FS |
| Origin | Mainland China |
| Certification | CE |
| Ice Production Capacity | Up to 44 lbs (20 kg) per 24 hours |
| Ice Making Cycle | Approx. 11-20 minutes per cycle (depending on size) |
| Ice Cube Quantity per Cycle | 24 pieces |
| Ice Shape | Square |
| Weight of Each Ice Cube | 7-9g |
| Water Tank Capacity | 3 Liters (1 Gallon) |
| Ice Storage Capacity | 1.4 KG |
| Net Weight | 20.94 lbs (9.5 kg) |
| Voltage/Frequency | 115V/60Hz |
| Product Dimensions (L x W x H) | 14.2" x 9.9" x 14.6" |
| Noise Level | Less than 35 dB |
User Tips
- For optimal ice quality and machine longevity, consider using filtered or distilled water.
- Ensure the drain plug at the bottom of the unit is securely closed during operation to prevent leaks.
- Regularly check the 'Add Water' and 'Ice Full' indicators to maintain continuous ice production.
- If the ice maker is not used for an extended period, perform a self-cleaning cycle and drain all water before storing.
Warranty and Support
For any questions, technical assistance, or warranty claims, please contact the seller or manufacturer's customer support. Keep your purchase receipt as proof of purchase.