1. Introduction
This manual provides detailed instructions for the installation, operation, and maintenance of your GreenYi AM700 7-inch AHD Car Rearview IPS Mirror Monitor and its accompanying 1080P Rearview Camera. This system is designed to enhance your driving safety by providing a clear, high-definition view of your vehicle's rear surroundings.
Figure 1: GreenYi 7-inch AHD Mirror Monitor and Rearview Camera
2. Setup and Installation
Careful installation is crucial for optimal performance. It is recommended to have this system installed by a professional if you are unfamiliar with car electrical systems.
2.1 Monitor Installation
- Gently pull down the lower shell of your existing rearview mirror.
- Align the GreenYi monitor with your vehicle's rearview mirror.
- Securely attach the GreenYi monitor by clipping it directly onto the rearview mirror position.
Figure 2: Monitor Installation Steps
2.2 Camera Installation
The rearview camera can be mounted using either adhesive or screws, depending on the specific camera model and your preference. Ensure the camera has a clear, unobstructed view of the rear of your vehicle.
- Adhesive Mounting: Clean the mounting surface thoroughly. Attach the camera bracket using the provided adhesive pad.
- Screw Mounting: Mark and drill pilot holes. Secure the camera bracket using the provided screws.
- Adjust the camera angle (up to 90 degrees) for optimal viewing.
Figure 3: Rearview Camera Dimensions and Adjustable Angle
2.3 Wiring Diagram
Connect the monitor and camera according to the wiring diagram below. Ensure all connections are secure to prevent signal loss or power issues.
Figure 4: Wiring Diagram for Monitor and Camera
Key Connections:
- Monitor Power Supply: Connect to a suitable 12V power source in your vehicle.
- Camera Power Supply: Connect to the vehicle's reverse light circuit for automatic activation when reversing.
- Video 1 (Yellow RCA): Connects to the primary camera (e.g., rearview camera).
- Video 2 (White RCA): Can be used for a secondary camera input.
- 'Back' Wire (Blue): Connect this wire to the reverse light trigger for automatic display switching when reversing.
3. Operating Instructions
3.1 Monitor Controls
The monitor features several buttons on the side for control:
- Power Button: Turns the monitor on/off.
- M (Menu) Button: Accesses the monitor's settings menu.
- Up/Down Buttons: Navigate through menu options or adjust settings.
- V1/V2 Button: Switches between Video Input 1 and Video Input 2.
3.2 Display Features
- AHD Technology: Provides clearer, high-definition video signals (up to 1080P) with advanced color separation and 3D noise reduction. It supports reliable transmission over long distances with zero-delay.
- IPS Screen: Offers excellent 178° full-view display technology, resulting in wider viewing angles, faster response times, and superior color/contrast compared to traditional panels.
- Night Vision: The camera features IR Starlight Night Vision, allowing for clear imaging in low-light or dark environments by utilizing infrared light reflection.
- Adjustable Image: Customize display settings such as brightness, contrast, and color via the menu.
- Parking Line Switch: Enable or disable parking guidelines on the display.
- Rotate Screen: Adjust the screen orientation as needed.
Figure 5: In-car View of AHD Digital 1920x1080 Monitor
Figure 6: Rearview Camera Display with Parking Lines
Video 1: Product Overview of GreenYi AHD Mirror Monitor and Camera
4. Maintenance
4.1 Cleaning
- Monitor: Use a soft, lint-free cloth slightly dampened with water or a screen cleaner. Avoid harsh chemicals.
- Camera: The camera is IP69K waterproof, meaning it is protected against close-range high-pressure, high-temperature spray downs. You can clean the lens with a soft, damp cloth. Ensure no debris obstructs the lens.
Figure 7: Camera IP69K Waterproof Rating
4.2 General Care
- Avoid exposing the monitor to extreme temperatures or direct sunlight for prolonged periods when not in use.
- Ensure all cables are properly routed and secured to prevent damage or interference.
5. Troubleshooting
| Problem | Possible Cause | Solution |
|---|---|---|
| Monitor does not power on. | No power supply; loose connection. | Check power cable connection to the monitor and vehicle power source. Ensure vehicle ignition is on if wired to accessory power. |
| No image from camera. | Camera not powered; video cable loose; incorrect video input selected. | Verify camera power connection (e.g., to reverse light). Check video cable connection between camera and monitor. Press V1/V2 button to cycle inputs. |
| Image is blurry or distorted. | Dirty camera lens; incorrect signal type; damaged cable. | Clean camera lens. Ensure camera and monitor are both AHD compatible (if using AHD camera). Check video cable for damage. |
| Parking lines not displayed. | Parking line feature disabled in settings. | Access monitor menu (M button) and enable the parking line switch. |
6. Specifications
| Feature | Specification |
|---|---|
| Model Name | AM700 |
| Brand Name | GreenYi |
| Item Type | Car Monitors |
| Placement | Roof (Rearview Mirror) |
| Monitor Specifications | |
| Display Size | 7 inches |
| Mirror Size | 9-inch full mirror display |
| Resolution | 1024*600 |
| Screen Brightness | 500 CD/M2 |
| Monitor Contrast | 300:1 |
| IPS Screen | Support |
| Video Signal | Supports AHD and CVBS signals |
| Signal Format | PAL / NTSC |
| Power Consumption | <= 6W |
| Camera Specifications | |
| Camera Pixel | 1920*1080P (2,000,000 pixels) |
| Angle | 170° Horizontal Angle |
| Waterproof Rating | IP69K |
| Night Vision | IR Starlight Night Vision |
| Color Cast | No Color Cast (Digital Image) |
| Material | Plastic display and metal camera |
| General | |
| Item Weight | 1250g |
| Item Size | 7inch (Monitor) |
| Certification | CE, RoHS |
7. Warranty and Support
Your GreenYi AM700 monitor and camera system comes with a 12-month Manufacturer Warranty. This warranty covers defects in materials and workmanship under normal use. Please retain your proof of purchase for warranty claims.
For technical support or warranty inquiries, please contact GreenYi customer service through your purchase platform.
8. User Tips
- Mirror Functionality: The monitor functions as a standard rearview mirror when the camera feed is not active. When the reverse gear is engaged (and wired correctly), it will automatically switch to display the camera view.
- Optimal Camera Placement: Experiment with the camera's adjustable angle during installation to find the best view for your vehicle, ensuring maximum visibility of blind spots.
- Cable Management: Secure all wiring neatly to prevent interference with vehicle operations and to ensure a clean installation.
