Introduction
This manual provides comprehensive instructions for the use and maintenance of your new SCHNEIDER Universal Replacement Remote Control. This remote is designed to be compatible with a range of SCHNEIDER LED, Smart LED, DVD, and HDTV TV models, offering a direct replacement for your original remote without the need for complex programming.
Compatible Models: LED32-SCPX200H, LED43-SCP200K, LED40-SC600K, LD28-SCE8HB, LD32-SCHD15HB, LED55-SCP200K, LED65-SCP200K, LD32-SCN32HB, LD32SCN66FHB, LD39-SCE19, LD39-SCN05HB, LD40-SCN33FHB, LD55-SC8813SK, LED40-SC500K, LD24-SCF06HDB.
Important: If your specific model is not listed or you are unsure about compatibility, please contact the seller for verification before use.
Setup
Battery Installation
The remote control requires two AAA batteries (not included) for operation. Follow these steps to install the batteries:
- Locate the battery compartment on the back of the remote control.
- Press down on the latch and slide the battery cover off.
- Insert two AAA batteries, ensuring the positive (+) and negative (-) terminals align correctly with the markings inside the compartment.
- Slide the battery cover back into place until it clicks securely.
Once batteries are installed, the remote is ready for use. No additional programming is typically required for compatible models.
Operating Instructions
This remote control functions identically to your original SCHNEIDER TV remote. Point the remote directly at your television's IR receiver and press the desired button.
Key Functions:
- STANDBY (Red Button): Powers the TV on or off.
- MUTE (Green Button): Mutes or unmutes the TV audio.
- Number Buttons (0-9): Directly select channels.
- CH LIST: Displays the channel list.
- ASPECT: Adjusts the screen aspect ratio.
- AUDIO: Selects audio tracks or modes.
- PIC.MODE: Changes picture modes.
- S.MODE: Changes sound modes.
- Navigation Pad (Up, Down, Left, Right, OK): Navigates menus and confirms selections.
- EXIT: Exits the current menu.
- SOURCE: Selects input sources (HDMI, AV, etc.).
- MENU: Opens the main menu.
- VOL (+/-): Adjusts volume up or down.
- CH (+/-): Changes channels up or down.
- DISPLAY: Shows on-screen information.
- Color Buttons (Red, Green, Yellow, Blue): Used for specific functions within menus or interactive services.
- Media Playback Controls (REC, TIMEShift, PLAY, PAUSE, STOP, REW, FF, PREV, NEXT): Controls media playback functions.
- INDEX, REVEAL, HOLD, SIZE, SUBPAGE: Additional teletext or special functions.
Maintenance
Cleaning
To clean your remote control, gently wipe it with a soft, dry cloth. For stubborn dirt, slightly dampen the cloth with water or a mild, non-abrasive cleaner. Avoid using harsh chemicals or excessive moisture, as these can damage the remote's electronics or finish.
Battery Replacement
Replace batteries when the remote's response becomes sluggish or it stops functioning. Always replace both AAA batteries at the same time with new ones. Do not mix old and new batteries, or different types of batteries, as this can lead to leakage or malfunction.
Storage
When not in use for extended periods, it is advisable to remove the batteries to prevent potential leakage and damage to the remote control.
Troubleshooting
- Remote not responding:
- Check if the batteries are inserted correctly with the correct polarity (+/-).
- Replace old batteries with new AAA batteries.
- Ensure there are no obstructions between the remote control and the TV's IR receiver.
- Make sure you are pointing the remote directly at the TV.
- Certain functions not working:
- Verify that your TV model is listed as compatible. While this is a universal replacement, specific advanced functions might vary slightly depending on the original remote's design for your TV model.
- If you suspect a button is stuck, gently clean around it.
- Compatibility issues:
- This remote uses Infrared (IR) communication. Ensure your TV also uses an IR remote.
- If you are unsure about compatibility for your specific TV model, it is recommended to contact the seller for assistance.
Specifications
| Feature | Specification |
|---|---|
| Wireless Communication | IR (Infrared) |
| Frequency | 433 MHz |
| Channel | 1 |
| Battery Type | AAA*2 (not included) |
| Support APP | No |
| Condition | New replacement |
User Tips
- Always double-check your TV's model number against the compatible list provided in this manual. If your model is not explicitly listed, it is best to contact the seller for confirmation to avoid compatibility issues.
- A user has confirmed successful operation with a 'Schneider led 40' model, indicating broad compatibility within the Schneider LED TV range.
- For optimal performance, ensure a clear line of sight between the remote's IR emitter and your TV's IR receiver.
Warranty and Support
This product comes with a 3-month warranty from the date of purchase. This warranty covers manufacturing defects and malfunctions under normal use.
If you encounter any issues with your remote control or have questions regarding its operation or compatibility, please contact the seller directly. They will be able to provide support and assist with troubleshooting or warranty claims.
