Introduction
This manual provides essential instructions for the safe and effective use, charging, and maintenance of your Savior Heat 7.4V rechargeable Lithium Polymer batteries. Please read this manual thoroughly before using the product and retain it for future reference.
What's Included
- A pair of 7.4V 2200mAh or 3000mAh Li-Polymer rechargeable batteries (Model SWB01)
- 1pc 8.4V dual battery charger
- 1pc carry bag (may vary by product package)
- 1pc user manual (this document)
Specifications
| Feature | Specification |
|---|---|
| Model | SWB01 |
| Voltage | 7.4V |
| Capacity Options | 2200mAh / 3000mAh |
| Wattage (2200mAh) | 16.28Wh |
| Battery Type | Li-Polymer |
| Special Feature | Anti-freeze (can work under 0°C/32°F) |
| DC Plug | 3.5*1.35mm |
| Dimensions (approx.) | 62mm x 40mm x 13mm |
Note: Specifications may vary slightly between 2200mAh and 3000mAh versions.
Setup
1. Initial Charging
- Before first use, fully charge the batteries with the provided 8.4V dual battery charger.
- Remove batteries from any heated garments before charging.
- Connect the batteries to the charger. A red light will illuminate on the charger, indicating charging is in progress.
- Charge at room temperature for 4-6 hours.
- The light on the charger will turn green when charging is complete.
- Once fully charged, promptly remove the batteries from the charger. Do not leave batteries charging unattended.
2. Battery Installation (into Heated Garment)
The installation method depends on your specific heated garment (e.g., gloves, socks). Common methods include:
- Outer Zipper Pocket: Locate the zipper pocket on the exterior of the garment. Insert the battery and connect the power wire.
- Inside Velcro Pocket: Locate the Velcro-secured pocket on the interior of the garment. Insert the battery and connect the power wire.
Operating Instructions
Connecting and Powering On
- Carefully connect the battery to the power wire located inside the garment's pocket.
- To turn on the heating, press and hold the power button on the garment for approximately 2 seconds. The garment will typically start at the High heating level (indicated by a Red LED).
Adjusting Heating Levels
Once powered on, you can cycle through heating levels by pressing the power button:
- High Level (Red LED): Press and hold for 2 seconds to turn on.
- Medium Level (White LED): Press the button for 1 second from High level.
- Low Level (Blue LED): Press the button for 1 second from Medium level.
To turn off the heating, press and hold the power button for 2 seconds at any heating level.
Automatic Adjustment
If the garment is turned on at the High heating level and no further operation is performed, it will automatically switch to the Medium heating level after 5 minutes to conserve battery life and prevent overheating.
Battery Power Indicators
The battery indicator lights on the garment's controller will show the remaining power level. These lights will illuminate when the heating level is adjusted and then turn off after approximately 5 seconds.
- 4 lights on: 100% power
- 3 lights on: 75% power
- 2 lights on: 50% power
- 1 light on and flashing: 25% power (low battery warning)
Maintenance
Battery Care and Storage
- Regular Charging: If the product is not in use, charge and discharge the batteries at least once every 3 months to maintain their usability and prolong their lifespan.
- Charger Usage: Always use the original charger provided by the manufacturer. Using an incorrect charger can cause severe risks, including fire hazards.
- Handling: Do not disassemble, crush, squeeze, or throw the battery into a fire.
- Safety Inspection: Regularly inspect the battery for any signs of damage, swelling, leaks, or discoloration. If any issues are found, stop using it immediately and replace the battery. If the battery leaks liquid, avoid contact with it. In case of accidental contact, flush the affected area with water. If liquid contacts your eyes, seek immediate medical attention.
- Storage: When not in use, store the battery in a cool, dry place, away from direct sunlight or heat sources. Do not store it in a fully charged or fully discharged state for long periods.
- Swollen Batteries: If a battery becomes swollen, place it in a metal bucket with at least 8 liters of water for 48 hours, then dispose of it at a local battery recycling point.
- Short Circuit Prevention: Keep the battery away from metal objects such as paper clips, coins, keys, nails, or screws, as these can cause short circuits, potentially leading to burns or fire.
Garment Washing Instructions (Battery Removal)
Always remove the batteries from your heated garments before cleaning or storing the garments. For garment washing, use mild detergent to clean only the spots and air dry lying flat. Hand wash only. Do not machine dry or use bleach on the garments.
Troubleshooting & Safety Warnings
General Warnings
- Do not use the product in environments exceeding 50°C/122°F or near open flames.
- Do not use the battery after it has been soaked in water.
- The elderly, children, and individuals with limited mobility should not use the product alone. People with diabetes, vascular problems, or neuropathy should consult their physician and use the product under medical supervision.
- Do not use the product if your hands or feet have bacterial infections or other medical conditions.
- Do not use the product while sleeping.
- If any area of the heated garment becomes excessively hot during use, there may be a short circuit in the heating wire. Stop using the product immediately and disconnect the battery.
- For safety, do not drop, short circuit, or operate the batteries under high temperature conditions.
- Do NOT disassemble, knock, squeeze the battery, or throw it into fire. If the device or battery swells or becomes malformed, stop using it immediately.
User Tips
- Verify Capacity: Always double-check the battery capacity (2200mAh or 3000mAh) when ordering to ensure it matches your requirements.
- Compatibility: While designed for Savior Heat products, if using with other brands, ensure the voltage (7.4V) and DC plug size (3.5*1.35mm) are compatible.
- Packaging: Do not be alarmed if batteries arrive wrapped in a glove or sock; this is a common practice for protection during transport.
Warranty & Support
Savior Heat Li-Polymer batteries, charger, and associated heated garments (if purchased together) are covered by a 12-month warranty period from the date of purchase.
For customer support, inquiries, or warranty claims, please contact:
Email: info@saviorheat.com
For additional information and guides, you may refer to the official user manual PDF: Savior Heat User Manual (PDF)
Product Video
Watch the official product video for a visual guide on using Savior Heat heated garments and battery installation: