Introduction
This manual provides detailed instructions for the installation, maintenance, and care of your replacement parts for the Fmart E200 Robot Vacuum Cleaner. The kit includes side brushes, Hepa filters, and mop cloths, designed to ensure your robot vacuum continues to operate at peak efficiency.
Regular replacement and cleaning of these parts are crucial for maintaining the cleaning performance and extending the lifespan of your Fmart E200 robot vacuum cleaner.
Package Contents
Please verify that all items listed below are included in your package:
- 4x Side Brushes
- 4x Hepa Filters
- 3x Mop Cloths

Setup and Installation
Before installing any replacement parts, ensure your Fmart E200 robot vacuum cleaner is powered off and disconnected from its charging base.
Installing Side Brushes
- Turn the robot vacuum cleaner upside down to access the brush modules.
- Locate the existing side brushes. Depending on your model, they may be held by a screw or snap into place.
- If secured by a screw, use a screwdriver to remove it. Gently pull the old side brush upwards to remove it.
- Align the new side brush with the corresponding post on the vacuum cleaner. Ensure the shape of the brush's base matches the post.
- Press down firmly or re-insert the screw to secure the new side brush.

Installing Hepa Filters
- Open the dustbin compartment of your robot vacuum cleaner.
- Remove the dustbin.
- Locate the filter assembly within the dustbin. Remove the old Hepa filter.
- Insert the new Hepa filter into the designated slot in the dustbin. Ensure it is seated correctly to maintain proper filtration.
- Close the dustbin and re-insert it into the vacuum cleaner.

Installing Mop Cloths
- Locate the mop cloth attachment plate on the underside of the robot vacuum cleaner.
- Remove the used mop cloth from the plate.
- Attach a clean mop cloth to the plate, ensuring it is securely fastened, typically using Velcro or clips.
- Re-attach the mop cloth plate to the robot vacuum cleaner if it was removed.
Operating Instructions
These items are replacement parts for the Fmart E200 Robot Vacuum Cleaner. For detailed operating instructions of the robot vacuum cleaner itself, please refer to the original user manual provided with your Fmart E200 unit.
Once the replacement parts are correctly installed, your robot vacuum cleaner should resume its normal cleaning functions with improved performance.
Maintenance
Regular maintenance of these parts is essential for optimal performance and longevity.
Side Brushes
- Cleaning: Periodically check side brushes for tangled hair or debris. Use scissors to cut away any tangled material and a small brush to clean dust.
- Replacement: Side brushes should be replaced every 3-6 months, or sooner if they become visibly worn, bent, or damaged, as this can affect cleaning efficiency.

Hepa Filters
- Cleaning: Tap the filter gently over a trash can to remove loose dust and debris. Do NOT wash Hepa filters with water, as this can damage the filter material.
- Replacement: Hepa filters should be replaced every 1-3 months, depending on usage frequency and household environment (e.g., pets, allergies). A clogged filter reduces suction power.
Mop Cloths
- Cleaning: After each mopping cycle, remove the mop cloth and wash it thoroughly with water and mild detergent. Allow it to air dry completely before re-attaching.
- Replacement: Mop cloths can be reused multiple times. Replace them when they show signs of significant wear, tear, or permanent staining that affects cleaning performance.
Troubleshooting
If you encounter issues after replacing parts, consider the following:
- Side Brush Not Spinning:
- Ensure the brush is correctly installed and securely fastened.
- Check for any hair or debris tangled around the brush motor or base.
- Verify the brush is not bent or damaged.
- Reduced Suction Power:
- Check if the Hepa filter is clogged. Clean or replace it if necessary.
- Ensure the dustbin is empty and properly seated.
- Poor Mopping Performance:
- Ensure the mop cloth is clean and properly attached.
- Check if the water tank (if applicable to your vacuum model) is filled and dispensing water correctly.
For issues not related to these replacement parts, consult your Fmart E200 robot vacuum cleaner's original manual or contact Fmart customer support.
Specifications
| Attribute | Detail |
|---|---|
| Product Type | Robot Vacuum Cleaner Replacement Parts |
| Compatibility | Fmart E200 Robot Vacuum Cleaner |
| Material | Plastic (for brushes and filter frame), Fabric (for mop cloths) |
| Vacuum Part Type | Filters, Side Brushes, Mop Cloths |
| Package Contents | 4x Side Brushes, 4x Hepa Filters, 3x Mop Cloths |
| Origin | Mainland China |
User Tips
- Regular Checks: Make it a habit to check the side brushes and filter after every few cleaning cycles, especially if you have pets.
- Spare Parts: Always keep a spare set of filters and brushes on hand to avoid downtime when replacements are needed.
- Mop Cloth Care: For best results, pre-wet the mop cloth slightly before attaching it for mopping.
- Filter Longevity: While Hepa filters cannot be washed, gently tapping them to dislodge dust can extend their effective life slightly between replacements.
Warranty and Support
For warranty information regarding these replacement parts, please refer to the terms and conditions provided by the original seller or contact Fmart customer service directly. Keep your purchase receipt as proof of purchase.
If you require further assistance or have questions not covered in this manual, please contact the retailer where you purchased these parts or Fmart's official support channels.