Advantage Controls MINI-TROL IF Reverse Osmosis Controller
Specifications
- Product Name: MINI-TROL IF Reverse Osmosis Controller
- Manufacturer: Advantage Controls
- Model Number: MROIF REV 2
- Input Voltage: 115/230V – 50/60Hz
- Maximum Load: 20 amps
Installation
- Confirm the controller voltage settings.
- Ensure the RO pump motor and solenoid valves match the controller voltage.
- Check and adjust jumper settings if needed.
- If wiring is required, follow the provided steps.
- Mount the enclosure in the desired location.
- Connect wiring to the appropriate appliances without connecting to the power source.
- Reassemble the enclosure ensuring wire slack inside.
- Turn the power switch off.
- Connect the power wire to its source.
- Turn the power switch on and test the unit.
- Observe the status LED color for system status.
Jumper Settings
Refer to the table for jumper settings and adjust as needed for your operation.
FAQs
Q: What should I do if the controller is rated for a maximum 20-amp total load?
A: Ensure that all connected appliances do not exceed this limit to prevent damage to the controller.
Q: How do I determine the proper jumper settings for my operation?
A: Refer to the provided table and identify the functions you require, then adjust the jumpers accordingly.
Q: What do I do if I encounter a system status issue?
A: Check the LED color on the controller to diagnose any system status problems and refer to the manual for troubleshooting steps.
Documents / Resources
 | Advantage Controls MINI-TROL IF Reverse Osmosis Controller [pdf] Instruction Manual MINI-TROL IF Reverse Osmosis Controller, MINI-TROL, IF Reverse Osmosis Controller, Reverse Osmosis Controller, Osmosis Controller, Controller |
 | Advantage Controls MINI-TROL IF Reverse Osmosis Controller [pdf] Installation Guide MINI-TROL IF Reverse Osmosis Controller, MINI-TROL IF, Reverse Osmosis Controller, Osmosis Controller, Controller |