ADT Safe N Go Alarm Panel
Getting to know your device
Charging your device
Charging base
- Place the device on the charging base.
- Connect the USB cable from charging base to the AC adaptor.
The charging base light will glow when charging and turn solid when fully charged.
Tip
- For the first time use, please fully charge the battery for around 2-3 hours.
Tip
- When the battery level falls below 20%, the device will give a voice prompt of “low battery alarm”.
Switching the device ON/OFF
- To turn on the device: press the CALL button for 1 second, all the LEDs will flash rapidly. The device can also be turned on automatically by charging via magnetic USB cable or put it into the docking station.
- To turn off the device: press and hold the side button and SOS button together for 3 seconds until the LEDs turn off.
What do the lights mean?
Cellular signal indicator – Green
|
Green |
Light shows a single flash rapidly every 3 seconds |
Light shows a double flash rapidly every 3 seconds |
| Means | The device has a stable Cellular signal | The device is registered to the Cellular network |
Positioning indicator – Blue
|
Blue |
Light shows a single flash
rapidly every 3 seconds |
Light shows a double flash rapidly every 3 seconds |
Light Off |
|
Means |
The device has no latest location fix |
The device has the latest location fix |
The device is not fixing the latest location |
Power indicator – Red
| Red |
Red ON (solid) |
Red shows a double flash rapidly every 3 seconds |
| State | The device has been fully charged |
Bluetooth Low Energy |
| Red | Red Blinking Quickly | Red Off or blinking slowly |
| Means | Battery power is lower than 20% |
The device is charging |
Activating an SOS alarm
When you need help, press the SOS button twice, you will hear a voice prompt of activating an SOS alarm. Voice prompt will say “SOS alert has been activated, click SOS to Stop”. This will prompt the Alarm Response process. Only click SOS again in case of false alarm.
Activate SOS on docking station
Note: Only works if ADT Safe-N-Go device is connected to the docking station via Bluetooth and is in the proximity of 10-15 metres.
De-Activating an SOS alarm
In the case of a false alarm, press SOS button once after, you hear a voice prompt of activating an SOS alarm. Voice prompt will say “SOS alert has been activated, click SOS to Stop”. Only click SOS again in case of false alarm. Voice prompt will say “Alarm has been cancelled” to confirm.
Silent Mode Button
- Double-click this button to turn off voice warnings, double-click the button again to turn on voice warnings.
- Put device on charging base more than 30 seconds, and they will be paired automatically via Bluetooth.
Specifications
- Dimension: 62mm*47mm*17mm
- Weight: 53g
- Battery: Rechargeable, 3.7V, l000mAh
- Charging voltage: 5V DC
- Waterproof: IP67
- 4 locating technologies: GPS, BLE, WIFI, LBS
Cautions
Please comply with the instructions to extend the unit life:
- Don’t use & store the unit in dusty places.
- Don’t put the unit in overheated or over-cooled places.
- Clean the unit with a piece of dry cloth. Don’t clean with chemicals or detergent.
- Don’t disassemble or refit the unit.
- Using other batteries will cause an unwanted situation.
Warning: Keep the IMEI and SIM in confidential, or your privacy may expose.
- 38 South St, Rydalmere NSW 2116
- Phone: 131 238
- www: www.adtsecurity.com.au.
Documents / Resources
 |
ADT Safe N Go Alarm Panel [pdf] User Guide Safe N Go Alarm Panel, Safe N Go, Alarm Panel, Panel |