ADDER RMK15 Rack Mount User Guide

ADDER RMK15 Rack Mount

Using the RMK15 Adder rack mount

1. Place a compatible module into each side of the rack mount so that their rear panels butt up against the center backstop.
2. Locate the two supplied brackets.
3. Place a bracket at the side of the rack mount so that they hold each unit in place (A).
4. Install the rack-mount into your 19” rack frame and fully secure it using four bolts (B).
5. Place the power adapters in the rear section of the rack mount and connect them to their respective modules.
6. Make all other necessary connections to the modules.