acoem NXA Digital Laser Based Shaft Alignment Tool
error
{
“error”: {
“message”: “You exceeded your current quota, please check your plan and billing details.”,
“type”: “insufficient_quota”,
“param”: null,
“code”: null
}
}
the following is the text from the user manual / instructions:
USER MANUAL NXA
Activate spacer shaft in Configuration.
See the Express Mode method.
Go back to measurement in cold or hot condition.
Publication No. P-0243-GB
All rights reserved. No part of this manual may be copied or reproduced in any form or by any means without prior permission from ACOEM AB.
www.fixturlaser.com
USER MANUAL NXA
· ·
· · British Standard BS EN 60825-1 ·
·
·
·
·
·
·
·
·
·
· · · · ·
Activate spacer shaft in Configuration.
See the Express Mode method.
·
· ·
· ·
· · · ·
· · · · ·
·
· · ·
· ·
· ·
· · · ·
· ·
·
· · ·
Go back to measurement in cold or hot condition.
°
· ·
· ·
· ·
·
·
· ·
· ·
· · · · ·
Ø
Ø
± µ µ
Ø
Ø
Publication No. P-0243-GB
© 2020 ACOEM AB, Mölndal, Sweden
All rights reserved. No part of this manual may be copied or reproduced in any form or by any means without prior permission from ACOEM AB.
www.fixturlaser.com
Documents / Resources
 |
acoem NXA Digital Laser Based Shaft Alignment Tool [pdf] User Manual NXA Digital Laser Based Shaft Alignment Tool, NXA, Digital Laser Based Shaft Alignment Tool, Shaft Alignment Tool |
