acer M22 Toggle Switch Mouse User Guide

acer M22 Toggle Switch Mouse User Guide

Overview:

Instruction:

1. Slide the mouse toggle switch to the left to turn it ON
2. Press and hold the top DPI button for at least 3 seconds to enter Bluetooth pairing mode. The red indicator light on the top flashes, indicating the mouse is in pairable status. Please complete the pairing operation within 120 seconds.
3. Turn on the Bluetooth of your device for searching.
   After successful connection, the indicator light stays on for 2 seconds and then turns off.

LED Status:

1. Supports 3-level of DPI adjustment. 800/ 1200/ 1600. The DPI selection button blinks once for 800 DPI, twice for 1200 DPI and thrice for 1600 DPI.
2. Connection Status Prompt: During mouse pairing, the red light flashes quickly twice per second.During mouse reconnection, the red light flashes slowly once per second. When the mouse is connected successfully, the red light stays steadily on for 2 seconds then turns off.
3. Low Batter y Reminder : When the batter y level is lower than 20%, the red light flashes slowly.

FCC Requirement

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.