Product Specifications
- Product Name: Mortise lock with Authorized Egress (AE)Monitoring
- Also known as: Request to Exit or RX Switch
- Electrical Specifications:
- SPDT Mechanical Switch
- Voltage: 125 VAC, 30 VDC
- Current: 1 AMP (0.5 AMP)
- Usage: Mainly used as a dry contact monitoring switch
Product Usage Instructions
Introduction
The Mortise lock with Authorized Egress (AE) Monitoring is designed to monitor the use of the INSIDE trim when the OUTSIDE trim is locked.
Installation
- Identify the yellow, red, and gray wires according to the wiring diagram provided.
- Connect the yellow wire to the common terminal, the red wire to the normally open terminal, and the gray wire to the normally closed terminal.
- Ensure proper voltage requirements are met (125 VAC, 30 VDC).
Operation
When the OUTSIDE trim is locked, the AE switch will monitor the use of the INSIDE trim. Any activity on the INSIDE trim will be detected by the switch.
Maintenance
Regularly check the wiring connections and ensure they are secure. Clean the switch contacts if needed to maintain proper functioning.
OPERATING INSTRUCTIONS
Mortise lock with Authorized Egress (AE) Monitoring, also referred to as Request to Exit or RX Switch.
AE – AUTHORIZED EGRESS
The AE switch monitors the use of the INSIDE trim when the OUTSIDE trim is locked.
ELECTRICAL SPECIFICATIONS
SPDT Mechanical Switch
| VOLTAGE | CURRENT |
| 125 VAC | 1 AMP |
| 30 VDC | 0.5 AMP |
NOTE: Mainly used as a dry contact monitoring switch
| WIRING DIAGRAM |
| YELLOW WIRE – COMMON |
| RED WIRE – NORMALLY OPEN |
| GRAY WIRE – NORMALLY CLOSED |
1 Annie Pl, Stamford CT 06902
203.348.8865
accuratelockandhardware.com
Frequently Asked Questions (FAQ)
What is the purpose of the AE switch?
The AE switch is designed to monitor the use of the INSIDE trim when the OUTSIDE trim is locked, providing authorized egress monitoring.
What voltage and current does the AE switch support?
The AE switch supports a voltage of 125 VAC, 30 VDC and a current of 1 AMP (0.5 AMP).
How should I wire the AE switch?
Connect the yellow wire to the common terminal, the red wire to the normally open terminal, and the gray wire to the normally closed terminal as per the provided wiring diagram.
Documents / Resources
 |
ACCURATE LOCK HARDWARE AE Mortise Lock with Authorized Egress Monitoring [pdf] Instruction Manual AE Mortise Lock with Authorized Egress Monitoring, AE, Mortise Lock with Authorized Egress Monitoring, Authorized Egress Monitoring, Egress Monitoring, Monitoring |
 |
ACCURATE LOCK HARDWARE AE Mortise Lock with Authorized Egress Monitoring [pdf] Instruction Manual AE Mortise Lock with Authorized Egress Monitoring, AE, Mortise Lock with Authorized Egress Monitoring, Authorized Egress Monitoring, Egress Monitoring |