A-TRACS SD-W01 Smart Wind-Sensor
Specifications
- BLUETOOTH: BLE5.0, Broadcast Distance 100m
- SENSOR: Wind Measurement Sensor
- Speed Range: 0 ~ 25m/s
- Speed Accuracy: +/- 1.5m/s
- Direction Accuracy: +/- 10 Deg
- E-Compass for auto-direction alignment
- BATTERY: Non-chargeable Alkaline battery, 3 pieces AA size, Operating Time: more than 1 year (Using LR6 AA batteries)
- LEDs: Three-colour LED lights
- INTERFACE IOs: Dip Switch (Power on)
- PHYSICAL: Dimensions: 75 (W) x 75 (L) x 121 (H) mm, Weight: 170 (g)
- APPROVALS: FCC, IC
Product Usage Instructions
Installation
- Place the Smart wind sensor in an open area with clear access to wind. Ensure it is securely mounted to prevent any movement during operation.
- Power On: Use the Dip Switch to power on the Wind-Sensor. The three-colour LED lights will indicate the power status.
Bluetooth Connectivity
- Activate Bluetooth on your device and pair it with the Wind-Sensor to receive measurement results within a range of up to 100 meters.
Reading Measurements
- Utilise the provided app or software to view wind speed and direction measurements accurately. Pay attention to the specified accuracy levels.
Battery Replacement
- When the battery needs replacement, ensure to use non-rechargeable Alkaline AA batteries for optimal performance.
INTRODUCTION
- Smart and cost-effective Wind-Sensor, which can be used in many areas for measuring the wind speed and wind direction.
- It has Bluetooth wireless connectivity for reporting the measurement results. It is battery-powered with off-the-shelf AA Alkaline batteries.
Specifications
- BLUETOOTH
- BLE5.0
- Broadcast Distance 100m
- SENSOR
- Wind Measurement Sensor
- Speed Range : 0 ~ 25m/s
- Speed Accuracy : +/- 1.5m/s
- Direction Accuracy : +/- 10 Deg
- E-Compass for auto-direction alignment
- BATTERY
- Non-chargeable Alkaline battery
- 3 pieces AA size
- Operating Time: more than 1 year
- (Using LR6 AA batteries)
- LEDs
- Three-colour LED lights
- INTERFACE IOs
- Dip Switch (Power on)
- ENVIRONMENTAL
- Operation Temperature: -20°C to +60°C
- Storage Temperature: -40°C to +85°C
- PHYSICAL
- Dimensions: 75 (W) x 75 (L) x 121 (H) mm
- Weight: 170 (g)
- APPROVALS
- FCC
- IC
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference,
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used according to the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. To comply with FCC RF Exposure compliance requirements, this grant applies only to Mobile Configurations. The antennas used for the transmitter must be installed to provide a separation distance of at least 20cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
CUSTOMER SERVICES
- Asiatelco Technologies Inc. (ATEL)
- Asiatelco Technologies Inc.
- 8821 Research Dr., Irvine, CA 92618, USA sales@asiatelco.com
Frequently Asked Questions
- Q: How long does the battery last?
- A: The Wind-Sensor operates for more than 1 year using LR6 AA batteries.
- Q: What is the Bluetooth range for this device?
- A: The device has Bluetooth BLE 5.0 with a broadcast distance of up to 100 meters.
Documents / Resources
 |
A-TRACS SD-W01 Smart Wind-Sensor [pdf] Owner's Manual SD-W01, SD-W01 Smart Wind-Sensor, Smart Wind-Sensor, Wind-Sensor |