RM KL203 Linear Amplifier Instruction Manual

RM logo

RM KL203 Linear Amplifier

RM KL203 Linear Amplifier

Specifications

  • Frequency: 28-29.7 MHz
  • Power Supply: 12-14Vcc
  • Input Current: 10A max
  • Input Power: 0.5-10W
  • Output Power: 100W
  • Input VSWR : 1.1-1.5:1
  • Mode: AM/FM/SSB
  • Fuse: 12A

VOX RTX Switching. Protection against inverse polarity. 24 months warranty, (not including RF transistors / asthetic damage). The use on 27MHz band is forbidden and that the use of linear amplifiers is ruled by specific laws that are to be understood by the user. The manufacturer declines any responsibility from unlawful use. If this device is installed in a vehicle the vehicle must be stationary before use.

ATTENTION: This product complies with CE standards if used in conjunction with RM 27/586 external Low Pass Filter connected between the KL203 (ANT) Output and Antenna.

The power supply cable should be shorter than 3m and have a cross sectional area of at least 1.5mm² (16AWG). If installed in a vehicle it should prefereably be connected directly to the battery via a fuse.

RM KL203 Linear Amplifier 1

RM KL203 Linear Amplifier 2

Documents / Resources

PDF thumbnailKL203 Linear Amplifier
Instruction Manual · KL203 Linear Amplifier, KL203, Linear Amplifier, Amplifier

References

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.