MW APC-12 series 12W Single Output Switching Power Supply Instruction Manual
MW APC-12 series 12W Single Output Switching Power Supply

Contents hide
1 Features
1.1 GTIN CODE
2 SPECIFICATION
3 Mechanical Specification
4 Documents / Resources
4.1 References
5 Related Posts

Features

  • Constant current design
  • Universal AC input / Full range
  • Protections:Short circuit / Over voltage
  • Fully isolated plastic case
  • Small and compact size
  • Cooling by free air convection
  • Class Ⅱ power unit, no FG
  • Class 2 power unit
  • Pass LPS
  • IP42 design
  • Suitable for LED related fixture or appliance (such as LED Decoration or Advertisement devices)(Note.6)
  • 100% full load burn-in test
  • Low cost / High reliability
  • 2 years warranty
GTIN CODE

MW Search: https://www.meanwell.com/serviceGTIN.aspx

SPECIFICATION

MODEL APC-12-350 APC-12-700
OUTPUT RATED CURRENT 350mA 700mA
DC VOLTAGE RANGE 9~36V 9~18V
RATED POWER 12.6W 12.6W
RIPPLE & NOISE (max.) Note.2 300mVp-p 250mVp-p
VOLTAGE TOLERANCE Note.3 ±5.0%
CURRENT ACCURACY ±8.0%
LINE REGULATION ±1.0%
LOAD REGULATION ±3.0%
SETUP, RISE TIME 3000ms, 180ms / 230VAC 3000ms, 150ms / 115VAC at full load
HOLD UP TIME (Typ.) 20ms/230VAC,15ms/115VAC at full load
INPUT VOLTAGE RANGE           Note.4 90 ~ 264VAC           127 ~ 370VDC
FREQUENCY RANGE 47 ~ 63Hz
EFFICIENCY(Typ.) 82% 80%
AC CURRENT 0.2A/230VAC;0.35A/115VAC
INRUSH CURRENT(Typ.) COLD START 70A(twidth=150μs measured at 50% Ipeak) at 230VAC
MAX. No. of PSUs on 16A CIRCUIT BREAKER 17 units (circuit breaker of type B) / 29 units (circuit breaker of type C) at 230VAC
LEAKAGE CURRENT 0.25mA / 240VAC
PROTECTION OVER VOLTAGE 39.6~ 46.8V 20.7~ 24.3V
Protection type : Shut off o/p voltage, clamping by zener diode
ENVIRONMENT WORKING TEMP. -30 ~ 70℃(Refer to “Derating Curve”)
WORKING HUMIDITY 20 ~ 90% RH non-condensing
STORAGE TEMP., HUMIDITY -40 ~ +80℃, 10 ~ 95% RH
TEMP. COEFFICIENT ±0.2%/℃ (0 ~ 50℃)
VIBRATION 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes
SAFETY & EMC

(Note 5)

 SAFETY STANDARDS Note.7 UL8750,CSA C22.2 No.250.0-08, BIS IS15885, EAC TP TC 004,BS EN/EN 62368-1 approved
WITHSTAND VOLTAGE I/P-O/P:3.75KVAC
ISOLATION RESISTANCE I/P-O/P:>100M Ohms / 500VDC / 25℃/ 70% RH
EMC EMISSION Compliance to BS EN/EN55032,BS EN/EN61000-3-2,BS EN/EN61000-3-3, EAC TP TC 020
EMC IMMUNITY Compliance to BS EN/EN55035,BS EN/EN61000-4-2,3,4,5,6,8,11; light industry level(surge 2KV), EAC TP TC 020
OTHERS MTBF 6418.1K hrs min. Telcordia SR-332 (Bellcore) ; 1097.4K hrs min. MIL-HDBK-217F (25℃)
DIMENSION 77*40*29(L*W*H)
PACKING 0.08Kg; 120pcs/11.8Kg/1.06CUFT
NOTE
  1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25℃ of ambient temperature.
  2. Ripple & noise are measured at 20MHz of bandwidth by using a 12″ twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
  3. Tolerance : includes set up tolerance, line regulation and load regulation.
  4. Derating may be needed under low input voltage. Please check the static characteristic for more details. Please connect L line to the positive pole and N line to the negative pole under DC input.
  5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
  6. This product is not intended for LED lighting luminaire applications in the EU.(In the EU the LPF/NPF/XLG series are recommended.)
  7. The model certified for CCC(GB19510.14, GB19510.1, GB17743 and GB17625.1) is an optional model . Please contact MEAN WELL for details.
  8. The ambient temperature derating of 3.5℃/1000m with fanless models and of 5℃/1000m with fan models for operating altitude higher than 2000m(6500ft).
  9.  For any application note and IP water proof function installation caution, please refer our user manual before using. https://www.meanwell.com/Upload/PDF/LED_EN.pdf

※ Product Liability Disclaimer: For detailed information, please refer to https://www.meanwell.com/serviceDisclaimer.aspx

Mechanical Specification

Power Supply

  • ※ T case: Max. Case Temperature.
    Power Supply
  • Block Diagram
    Block Diagram
  • Derating Curve
    AMBIENT TEMPERATURE (℃)
    Derating Curve
  • Static Characteristics
    INPUT VOLTAGE (VAC) 60Hz
    Static Characteristics
  • EFFICIENCY vs LOAD (APC-12-350)
    Efficiency Vs Load

User’s Manual
Scan Me
QR. Code
Safety Icons
Logo.png

Documents / Resources

MW APC-12 series 12W Single Output Switching Power Supply [pdf] Instruction Manual
APC-12 series, 12W Single Output Switching Power Supply, APC-12 series 12W Single Output Switching Power Supply, Output Switching Power Supply, Power Supply

References

Related Posts

Leave a comment

Your email address will not be published. Required fields are marked *