Panasonic WW23E Module Adapter
GENERAL
This device is the WWAN module adapter, UMTS/LTE/NRSub-6 with carrier aggregation (CA)
Integration to the end product
- Insert WW23E module into PCIe M.2 card connector.
- Secure the end of product using the screw.
- Insert Antenna unit into Antenna connectors of WW23E module.
Technical Specification
- Dimensions (H x W x D): Approx. 30mm x 52mm x 2.38mm
- Weight: 9g (max)
- LTE Standard: 3GPP Release 15
- UMTS Standard: 3GPP Release 9
- NR Sub-6 Standard: 3GPP Release 15
- Operating Temperature: -30 to 70 degree Celsius
- Connector interface: PCIe M.2
- Host interface: USB3.1 etc.,
Regulatory Information
RF Exposure Compliance information
The WW23E module will have been granted modular approval for mobile applications.
Integrators may use the WW23E module in their final products without additional FCC /ISED (Innovation, Science and Economic Development Canada) certification if they meet the following conditions. Otherwise, additional FCC / ISED approvals must be obtained.
- At least 20 cm separation distance between the antenna and the user’s body must be maintained at all times.
- To comply with FCC / ISED regulations limiting both maximum RF output power and human exposure to RF radiation, the maximum antenna gain including cable loss in a mobile-only exposure condition must not exceed the limits stipulated in Table 1.
Table 1 Antenna Gain and Collocated Radio Transmitter Specifications
- USA only
- Canada only
Important: The FCC and IC have a strict EIRP limit in Band 30 for mobile and portable stations in order to protect adjacent satellite radio, aeronautical mobile telemetry, and deep space network operations. Mobile and portable stations must not have antenna gain exceeding 0 dBi in Band 30. Additionally, both the FCC and IC prohibit the use of external vehicle-mounted antennas for mobile and portable stations in this band.
Important: Airborne operations in LTE Band 48 are prohibited.
- The WW23E module may transmit simultaneously with other collocated radio transmitters within a host device, provided the following conditions are met:
- Each collocated radio transmitter has been certified by FCC / ISED for mobile application.
- At least 20 cm separation distance between the antennas of the collocated transmitters and the user’s body must be maintained at all times.
- The radiated power of a collocated transmitter must not exceed the EIRP limit stipulated in Table 1.
A label must be affixed to the outside of the end product into which the WW23E module is incorporated, with a statement similar to the following:
- This device contains FCC ID: ACJ9TGWW23E, IC: 216H-CFWW23E
Instructions to OEM Integrators
A user manual with the end product must clearly indicate the operating requirements and conditions that must be observed to ensure compliance with current FCC/ISED RF exposure guidelines.
The end product with an embedded the WW23E module may also need to pass the FCC Part 15 unintentional emission testing requirements and be properly authorized per FCC Part 15.
If this module is intended for use in a portable device, integrators are responsible for separate evaluation and/or approval to satisfy FCC/ISED RF Exposure requirements.
If other radio devices are to be integrated with this module, an additional evaluation and FCC/ISED submission may be required. Integrators are responsible for such additional evaluation and FCC/ISED submission.
Documents / Resources
 |
Panasonic WW23E Module Adapter [pdf] User Manual WW23E, WW23E Module Adapter, Module Adapter, Adapter |