PHILIPS logoST15IT CoreLine Projector Gen2
Instruction Manual

ST15IT CoreLine Projector Gen2

PHILIPS ST15IT CoreLine Projector Gen2PHILIPS ST15IT CoreLine Projector Gen2 - icon

CCT (K) Lumen (Im) P (W) Input current ImA PHILIPS ST15IT CoreLine Projector Gen2 - icon1 PHILIPS ST15IT CoreLine Projector Gen2 - icon2
ST151T 3000 3000 30 140 25°/ 38° 0.51
4000 27 125 25°138°

PHILIPS ST15IT CoreLine Projector Gen2 - 1

Inrush current

PHILIPS ST15IT CoreLine Projector Gen2 - 2

Electrical characteristics
I max (A) 43.8
Tref (ps) 11.2
MCB Downlights Max.
B-16 A 30
C-16 A 50

warning 2 ATTENTION OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC SENSITIVE DEVICES

  • PHILIPS ST15IT CoreLine Projector Gen2 - icon3 The luminaire shall be installed by a qualified elec-trician and wired in accordance with the latest IEE electrical regulations or the national requirements.
  • The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
  • Clean with dry cloth. – The luminaire should be mounted outside of arm’s reach.

PHILIPS ST15IT CoreLine Projector Gen2 - 3

This product contains a light source of energy efficiency class: E

Disconnect before servicing

Luminaire has basic insulation between Low Voltage supply and control conductors.
If this luminaire contains an external flexible cable, it shall only be replaced by the manufacturer or his service agent or a similar qualified person. The light source and/or control gear contained in this luminaire are not replaceable, in case of damage replace the luminaire.
Storage, installation, use, operation and maintenance of the products needs to be performed exactly according the instructions in this manual and/or other instructions as may be provided by us to guarantee safe use of the product over its entire lifetime. Failure to adhere to these instructions will invalidate your entitlement to warranty. Bolts with indication of torque strength on the drawing need to be tightened using a calibrated torque wrench. Pre-assembledbolts need to be retightened again to the required torque specification to assure maximum strength over lifetime.

PHILIPS logoPrinted in The Netherlands
Data subject to change without notice
Keep for future reference:
www.philips.com/lighting
0000 000 00000 © 2021
Signify Holding. All rights reserved

Documents / Resources

PHILIPS ST15IT CoreLine Projector Gen2 [pdf] Instruction Manual
ST15IT, CoreLine Projector Gen2, Projector Gen2, CoreLine Projector, Projector, ST15IT

References

Leave a comment

Your email address will not be published. Required fields are marked *