PHILIPS SRP4000 Replacement Remote

Specifications

• Model: SRP4000
• Brand: Philips
• Power Source: Battery-operated (batteries not included)
• Color: Black

Insert batteries (not included)

Set Up by Code Selection

1. Switch on your TV.
2. Press and hold 1 and 6 at the same time for 5 seconds until the red LED is on.
3. Look up the 5-digit code you would like to change. The pre-programmed code is 0 0 0 0 0.
4. Enter the first 5-digit code using the digit buttons.
5. If the light is off, a valid code is saved. Otherwise, the light will flash once, and then remain for code re-entry.
6. Operate the device with the remote. If your device responds correctly, it means you have entered the right code. Otherwise, repeat from Step 2, and enter the second code on the list.

Learn code from other remote

You must have an original remote for the Replacement Remote Control (RRC) to learn code from it.

1. Press and hold 1 and 6 at the same time for 5 seconds until the red LED light is on.
2. Enter the learning code 9 9 9 0 0. The red LED light will flash once and then remain on.
3. Place the RRC and the original remote, head to head aiming at each other,o n a flat surface.
4. On the RRC, press the button that you would like to learn a code from the original remote. The LED will flash twice and stay on.
5. On the original remote, press and hold the button that you would like to learn from for 2 seconds.
6. The LED will blink once and stay on if the learning is successful. To learn another key, repeat Step 4. To exit, press 1 and 6 at the same time.
7. The LED will blink 6 times quickly if learning fails. Repeat Step 4 to learn again.

List of IR code for Philips TV

www.philips.com/support

Frequently Asked Questions

Q: How do I know if I have successfully set up the remote with the correct code?
A: If your device responds correctly to the remote, it means you have entered the right code. The LED indicator will confirm the successful setup.

Q: What should I do if my device does not respond after setting up with a code?
A: Repeat the setup process from Step 2 and try entering the next code on the list until your device responds correctly.

Specifications are subject to change without notice. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license.
This product has been manufactured by and is sold under the responsibility of MMD Hong Kong Holding Limited or one of its affiliates, and MMD Hong Kong Holding Limited is the warrantor for this product.
Philips Replacement Remote Quick Start Guide SRP4000.

Documents / Resources

PHILIPS SRP4000 Replacement Remote [pdf] Instruction Manual SRP4000, TAPR802, SRP4000 Replacement Remote, SRP4000, Replacement Remote, Remote

References

• User Manual