Contents
hide
CTA ADD-LTPCF VESA Compatible Laptop and Other Device Holder with Built-in Cooling Fan
CONTENTS
INSTALLATION
How to Setup your Holder
- Extend the holder brackets.
- Adjust the holder to your laptop by sliding the brackets towards it.
- Once laptop is securely in place, tighten four knobs as shown until securely fastened.
Powering Up Cooling Fan
- Locate the fan.
- Find the integral USB cable below.
- Plug into your laptop to power the fan.
Cable Management
- Route all cables through the cable organizer as illustrated.
Attaching to VESA Compatible Device
- Locate the four VESA hole sunderneath. Using an allen key (not provided, endcaps)
- Screw in the four screws from the back to a VESA compatible device using screwdriver. (not provided)
Documents / Resources
 |
CTA ADD-LTPCF VESA Compatible Laptop and Other Device Holder with Built-in Cooling Fan [pdf] Instruction Manual ADD-LTPCF VESA Compatible Laptop and Other Device Holder with Built-in Cooling Fan, ADD-LTPCF, VESA Compatible Laptop and Other Device Holder with Built-in Cooling Fan, Built-in Cooling Fan, Cooling Fan, Fan |
