VIDEO PROJECTOR
Product Manual
Model Number: E2
20240815-V1.0
Function Overview
Remote Control Instructions
Note: Battery Not Included.
Connect To WIFI
Select “wifi” on the main interface
- Turn on the Wifi switch
- Select the network you want to connect
BT Settings
- Select “SETTING’ on the main interface
- Set “BT Status’ to “on” and select “Search Bluetooth’ to search for Bluetooth andio devices to connect
Electric focus
- You can use “F+/F =” for electric focusing to make the image clear
- Select ” Manual adjustment of trapezoidal calibration “ to automatically switch to ” Vertical automatic up and down trapezoidal calibration “,
Note : Projector placed when the tilt angle can not exceed 15 degrees , otherwise the automatic trapezoid will not be adjusted .
Screen Mirroing Function for IOS & Android System
On the main page .select “Wireiess’”
- Follw the steps on the screen
Wired Screen Mirroring
- On the main page .select “Wired”
- Follw the steps on the screen
Packing List
Projection Size/Audio/Video Format
| Projection Size | |
| Aspect Ratio | 16:09 |
| Screen Size | Projection Distance (m) |
| 50 | 1. |
| 70 | 2. |
| 100 | 3. |
| 120 | 3. |
Note: The above data is for reference only, please refer to the actual measurement
Multimedia File Specification
Image Format
| Support | File Extension |
| JEPG,PNG,BMP,MPO | .jpg /.png/ .bmp |
Audio Format
| Support | File Extension |
| MPEG1,MPEG2,LPCM,MP3 | .avi/.ts/.dat/.vob/.wav/mkv/.mp3/.mp4/.m4a |
Doesn’t Support: Dolby AC3/AAC. DTS, WMA, DivX, etc
Video Format(Bit Rate up to 30~40 Mbs)
| Support | File Extension |
| MPEG1,MPEG2,H.263,H.264,AVS,VC1, MJPEG,RV30,RV40,HEVC |
.dat/.ts/.mp4/.mpg/.mpeg/.avi/.mkv/.mov /.wmv/.asf/.flv/.3gp./.3gpp/.tp/.trp |
Doesn’t Support: MSVC/CRAM. MP42, GMC, IV32, RLE. cvid, RV20, DivX. RM. RMVB.
FLV, etc.
Warranty Card
| User info | Username | |
| Contact Number | ||
| Zip Code | ||
| Mailing Address | ||
| Product Information | Product Name | |
| Product Number | ||
| Product Serial Number | ||
| Sales Information | Sales Unit | |
| Contact Number | ||
| Zip Code | ||
| Address | ||
| Sale Date | ||
| Installation And Commissioning Date | ||
| Invoice Number |
| Delivery Date: | Maintenance Staff Signature: |
| Cause of Lssue: | |
| Troubleshooting: | |
| Service Point: | Delivery Date: |
| Delivery Date: | Maintenance Staff Signature: |
| Cause of Lssue: | |
| Troubleshooting: | |
| Service Point: | Delivery Date: |
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Documents / Resources
 |
BenQ E2 Video Projector [pdf] Instruction Manual E2 Video Projector, E2, Video Projector, Projector |