USER MANUAL
True Wireless Earbuds
Model: Mpow M30 Plus
PACKING LIST
DIAGRAM
POWER ON
- The earphones automatically turn on(with white LED light flashing) and start pairing when you open the charging case.
- In the shutdown status and when the earphones are not in the charging case. simultaneously press and hold the MFB of both earbuds for 2 seconds to power on ( with the white LED light flashing).
POWER OFF
- Put the earphones back in the charging case and close the case to turn them off.
- If the earphones are not in the charging case. just press and hold the MFB of both earbuds for 5 seconds to power them off. (Mode 2 cannot be conducted during music playing or calling.)
PAIRING
- Open the charging case, they will automatically enter the pairing mode in which the LED light flashes white and red alternately, and then select “Mpow M30 Plus·.
Note: The earbud will reconnect to the paired device by priority. If you want to pair to the second smartphone, please disconnect Bluetooth on the paired smartphone.
MUSIC
INCOMING CALL
MUSIC & INCOMING CALL & Siri
Volume Up/ Down
Volumes +: press and hold the MFB button of Right earbud to tum up the volume increasingly.
Volumes – : press and hold the MFB button of Left earbud to turn down the volume decreasingly.
Next/ Previous Track
Next Track: double tap the MFB of Right earbud.
Previous Track: double tap the M FB of Left earbud.
Play/ Pause
Tap the MFB of either earbud once.
Answer/ Hang Up
Double tap the MFB of either earbud.
Reject
Press and hold the MFB of either earbud for l second.
Activate Siri
Triple-tap the MFB of either earbud.
RESET
In the state of charging, press and hold the button on the charging case for l O seconds. The LED will flash red, which means that the paired information is cleared successfully.
CHARGING
Do not put the earbuds in the charging case \A/hen the earbuds are wet
CORRECT DISPOSAL OF THIS PRODUCT
( Waste Electrical& Electronic Equipment)
This Marking shown on the product or its literature. indicate that it should not be disposed with other household wastes – at the end of its working life.
To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of wast.es and recycle it responsibly to promote the sustainable reuse of material resources. Household user should contact either the retailer where they purchased this product. or their local government office, for details of where and how they can take this item for environmentally safe recycling.
Business users should contact their supplier and check the terms and conditions of the purchase contact This product should not be mixed with other commercial wastes for disposal.
FCC STATEMENT
Any Changes or modifications not expressly approved by the party responsible for compliance could void the use(s authority to operate the equipment
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions,
(1) This device may not cause harmful interference. and
(2) this device must. accept any interference received, including interference that may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment
Questions about your Manual? Post in the comments!
References
- User Manualmanual.tools
Hello. I am using the earbuds for conference calls, and they are loud and make a lot of snapping/cutting out sounds. I’ve tried holding down the pad on the left one to reduce the volume, but that doesn’t work. It turns off the earbud instead.
How do I adjust the volume on Mpow M30 Plus earbuds and fix audio interference issues?
Based on the Mpow M30 Plus manual, here is how to address your volume and audio issues:
If the snapping sounds persist during conference calls specifically, ensure the earbuds are not near other high-frequency electronic devices that might cause interference.
Read the full Q&A page
Hello, after a while, the right earphone began to glow red all the time, regardless of where the earphone is and because of this the commands stopped working, I can’t even turn off the right earphone by pressing it.
Здравствуйте, у меня спустя некоторое время правый наушник стал постоянно светиться красным, независимо от того, где находиться наушник и из-за этого перестали работать команды, я даже не могу зажатием выключить правый наушник.
Здравствуйте, у меня спустя некоторое время правый наушник стал постоянно светиться красным, независимо от того, где находиться наушник и из-за этого перестали работать команды, я даже не могу зажатием выключить правый наушник.
Why is my right earbud glowing red constantly and not responding to touch commands or turning off?
A constant red light and unresponsive touch controls usually indicate that the earbud's firmware has frozen or there is a charging connection error. To resolve this issue with your Mpow M30 Plus, please follow these troubleshooting steps:
If the red light persists after a reset and a full recharge, the earbud may have a hardware defect.
>
Read the full Q&A page
Hi, my earphones (m30) work great when playing music but they continually disconnect and reconnect during phone calls.
Solutions?
Salve, i miei auricolari (m30) funzionano benissimo durante la riproduzione di musica ma si scollegano e ricollegano continuamente durante le telefonate.
Soluzioni?
Solutions?<e/em>
Salve, i miei auricolari (m30) funzionano benissimo durante la riproduzione di musica ma si scollegano e ricollegano continuamente durante le telefonate.
Soluzioni?
Why do my Mpow M30 Plus earbuds keep disconnecting and reconnecting during phone calls even though music works fine?
If your Mpow M30 Plus earbuds are stable during music playback but disconnect during calls, it often indicates a conflict in the Bluetooth profile or corrupted pairing data. You should perform a hardware reset to clear the paired information.
To reset your Mpow M30 Plus:
Additionally, ensure that the earbuds have sufficient battery and that there are no other active Bluetooth devices nearby that might be trying to hijack the connection during the switch from A2DP (music) to HFP/HSP (call) profiles.
Read the full Q&A page
what is the usb connection for it is not in the manual
What is the purpose of the USB connection on the Mpow M30 Plus charging case?
The Mpow M30 Plus charging case features two distinct USB ports that serve different purposes:
Please note that while the manual focuses on earbud operations, the USB-A port is specifically for reverse charging other devices, which is why it may appear separate from the standard earbud charging instructions.
Read the full Q&A page