REXTON M-Core R-Li Hearing Aid
REXTON M-Core R-Li Hearing Aid
This is not a substitution for reading your Owner’s Manual.
For more in-depth instructions, please refer to your Owner’s Manual.
Check the charging status of your hearing aid
| LED | Status description |
 |
Orange LED: Charging status 0 to 33 % |
 |
Single green LED: Charging status 34 to 66 % |
 |
Single green LED: Charging status 34 to 66 % |
 |
Three green LEDs: Hearing instrument is fully charged |
Turn your hearing aids on
- Your hearing aids turn on automatically when removed from the charger
- They are programmed to have a start-up delay to allow you to insert without whistling
- You will hear a melody during the start-up
 |
6 Second | |
18 Second | |
12 Second |
Insert your hearing aids
- Grasp receiver/dome between your thumb and forefinger
– Insert dome into your ear canal
– Gently work the dome into proper position by slightly adjusting it until it is firmly seated in your ear - Lift the hearing aid over the top of your ear
− Adjust it to fit behind your ear
− Press slightly for a secure and comfortable fit
− Place retention strand into the bottom “bowl” of your ear (if applicable)
Using your hearing aids
- Your hearing aids feature Wireless Sync, which automatically adjusts both hearings aids simultaneously to reflect changes in your hearing environment
- The rocker switch to control on your hearing aids may be programmed to give you personal control of your hearing aids
- The functions for short and medium press will change both hearing aids simultaneously
| Your controls | Press | ||
| Short (1 second) | Medium (2 seconds) | Hold* | |
|
L R |
L R |
L R |
|
|
Volume Up/Down |
 |
|
– |
| Program Up/Down | |
|
– |
| TV Stream | |
|
– |
| Power On/Off |
– |
– |
 |
*Press and hold until hearing aid turns on/off
Your hearing aids may be programmed to alert you when you are making changes to your hearing aids or when your battery needs replacing.
|
Signal tones |
|
|
L R |
|
| Program Change | |
| Volume Change | |
| Volume Limit | |
| Volume On Position | |
| Low Battery | |
| Bluetooth On/Off | |
| Power On/Off | |
Troubleshooting
| Problem & possible solutions |
| Sound is weak: |
| Increase the volume |
| Recharge the hearing aid |
| Clean or exchange the click dome or wax protector |
| Hearing aid emits whistling sounds: |
| Reinsert the receiver until it fits securely |
| Decrease the volume |
| Clean or exchange the click dome or wax protector |
| Sound is distorted: |
| Decrease the volume |
| Recharge the hearing aid |
| Clean or exchange the click dome or wax protector |
| Hearing instrument emits spontaneous signal tones: |
| Recharge the hearing aid |
| Hearing aid does not work: |
| Turn the hearing aid on |
| Recharge the hearing aid |
| Power-on-delay is active. Wait several seconds and check again |
| Clean or exchange the click dome or wax protector |
Consult your Hearing Care Professional if you have further problems
© Rexton, a Division of WSAUD A/S. All rights reserved. 10980917 6/20 2.0 V11011083 SIV-7465
DOWNLOAD RESOURCES
- REXTON M-Core R-Li Hearing Aid [pdf] User Guide M-Core R-Li Hearing Aid
- Read more: https://manuals.plus/rexton/m-core-r-li-hearing-aid-manual#ixzz7dmB9fhEj
FAQ’S
If your rechargeable hearing aid doesn’t have a battery door, it contains a Lithium-Ion rechargeable battery. These batteries take about 3-4 hours to fully charge and will power your hearing aids for about 24 hours per charge. The battery itself should last for the entire life of the hearing aid, typically 4-5 years.
The first one is a volume. Control. You can change volume from right and left ear separately or tap this icon to put them together as one slider drag the slider up to increase volume.
The button allows you to change to way the hearing aid operates for using in different situations, for example using in noisy situations or where there is a loop system. On most aids, moving the volume control downwards will reduce the volume.
Connect transmitter to power cord and plug into power supply. Both lights on front of the transmitter should blink blue. Start TV streaming Switch your hearing aids to the television program via app, hearing aid rocker switch, Smart Mic, or Smart Key.
Pairing your hearing aid with an Android device
Locate, then tap the Settings icon on your device. Select Bluetooth. In this screen, if Bluetooth appears Off, change the settings to On. Then, turn your hearing aids off and then back on (this puts your hearing aids into pairing mode).
Hearing aids should be worn during waking hours. When going to bed for the night, you should remove your hearing aids and open the battery door, if you have one, to help conserve battery life.
Your hearing aids are water-resistant, which means they are designed to be worn in all daily life situations. So you don’t have to worry about sweat or getting wet in the rain. However, do not wear your hearing aids while showering or participating in water activities.
If your hearing aids are working but the sound seems to be muffled or too soft, there is likely a buildup of wax on the microphone or earmold. Try thoroughly cleaning your hearing aid.
The easiest way to ensure calls are routed through your hearing aids is to answer phone calls using the multi-function button of the hearing aid. For outgoing calls, initiate the call normally. Depending on your phone configuration, the call will be routed to the hearing aids automatically.
In most cases, you need to replace it once a month or if your hearing aid doesn’t sound as loud or is distorted.
Moisture in your ear canal can cause the device to move around. The hearing aid also may change position from jaw movement when you talk or chew. If you use a dome on your hearing aid, try adjusting to a smaller or larger size. A retention wire may also need to be added by your audiologist.
The wax loop or brush from a cleaning kit are the best tools to gently scoop any wax away from the opening of the sound tip. Behind the ear hearing aids come with tubes that can also become blocked with earwax. Remove it, check for any blockages, and remove them with either a small, bendable wire or an air blower.
VIDEO
www://rexton.com/
Documents / Resources
 | M-Core R-Li Hearing Aid |
References
- Hearing aids you can rely on. Since 1955. | Rextonwww.rexton.com
- User Manualmanual.tools
how do I connect the hearing aid to my iphon to get the hearing signal through the hearing aid
hoe koppel ik het hoortoestel aan mijn iphon om het hoorsignaal via het hoortoestel te krijgen
hoe koppel ik het hoortoestel aan mijn iphon om het hoorsignaal via het hoortoestel te krijgen
How do I connect my Rexton M-Core R-Li hearing aids to my iPhone for audio streaming?
To connect your Rexton M-Core R-Li hearing aids to your iPhone for direct audio streaming, follow these steps:
Once paired, your hearing aids will automatically stream phone calls, music, and other audio from your iPhone. You can also download the Rexton App from the App Store for additional control and adjustments.
Read the full Q&A page
Where can I find the original complete version??
There is a lot wrong with this manual.
Waar kan ik de originele complete versie vinden??
Aan deze handleiding mankeert veel.
There is a lot wrong with this manual.<e/em>
Waar kan ik de originele complete versie vinden??
Aan deze handleiding mankeert veel.
Where can I find the complete original owner's manual for the REXTON M-Core R-Li hearing aid?
The document currently available on this page is the Quick Start Guide for the REXTON M-Core R-Li. As noted on the first page of the guide, it is not a substitution for the full Owner's Manual.
To obtain the complete original version, you can try the following resources:
If you have identified specific errors in the Quick Start Guide, we recommend consulting your Hearing Care Professional to ensure your device is configured correctly for your hearing needs.
Read the full Q&A page
What a bad job. A picture with an arrow, showing press this button for1 sec to turn up your hearing
aids is better than this page of real crap. talk about a sloppy job.
was there supposed to be sound with those little squares so you can hear the actual sound.
What about a video if you can’t do a better job.
What is that with your advertisers like Clear Bar, nothing went forward to show what one was
looking for, and one is shown manuals that you don’t need and they have no good search engine.
aids is better than this page of real crap. talk about a sloppy job.
was there supposed to be sound with those little squares so you can hear the actual sound.
What about a video if you can't do a better job.
What is that with your advertisers like Clear Bar, nothing went forward to show what one was
looking for, and one is shown manuals that you don't need and they have no good search engine.
How do I use the rocker switch to adjust volume and power on the Rexton M-Core R-Li hearing aids, and are there audio/video guides available?
To adjust your Rexton M-Core R-Li hearing aids using the rocker switch, please note that the specific functions depend on how your Hearing Care Professional programmed them. Generally:
Regarding your request for audio and video: The physical manual and this webpage are static documents and do not contain playable sound. However, the Rexton App (available for smartphones) provides an interactive way to adjust settings and may offer more visual guidance. For a video demonstration of the technology, you can view the Rexton MotionCore video included on this page, which highlights the adaptive sound features of the device.
If the rocker switch is not performing as expected, it may be because those specific controls (like Volume or Program changes) were not enabled during your fitting. You should consult your Hearing Care Professional to confirm your button configuration.
Read the full Q&A page