ALDI MAL1380 Stand Light Instructions

ALDI MAL1380 Stand Light Instructions

Hotline: 00800/BRILONER (00800/27456637) Briloner Leuchten / Im Kissen 2 / 59929 Brilon

Safety directions / Please read this information carefully before installing or using this product. Please keep this user manual for further reference.

The manufacturer does not accept any responsibility for injuries or damage resulting from improper use of the light.
Maintenance of the lights is limited to the surfaces. For electrical safety reasons, this product must not be cleaned with water or other liquids. Use only a dry, lint-free cloth for cleaning.
Caution! Risk of electric shock. Before connecting to the mains, always check the entire light for possible damage. Never use the light if you notice any damage.
Caution! Disconnect the mains cable from the power supply before assembling or disassembling. Switch off the earth leakage circuit breaker/automatic circuit breaker or unscrew the fuse. Turn the switches to “OFF“.
The symbol of the crossed-out garbage can on the product or the packaging means that the product must not be disposed with ordinary household waste. At the end of its useful life, the product must be returned to a point of acceptance for the recycling of electric and electronic device. Please ask your local municipality for the point of acceptance.
Safety class II . This light is specially insulated and must not be connected to an earthed conductor.
Do not install the light on a damp or conductive subsurface.
Please make sure that no cables get damaged during the installation work.
Connection type Y: In order to eliminate any risks in case of damages, the outer flexible cable of this lamp may only be replaced by a special cable or by a cable exclusively available from the manufacturer, its service representative or a comparable qualified technician.
Attention! During operation, lamp parts and illuminants can reach temperatures of more than 60°C. Do not touch during operation!
Place the lamp on horizontal surfaces only.
The lights have a protection class rating of “IP20“ and are solely intended for indoor use only of private households.
The maximum wattage indicated of each lighting unit must not be exceeded.
Make sure that illuminants are securely fixed during the installation.
Please make sure that illuminants have first cooled down before replacing them. Attention! Always disconnect the power cable or the socket light from the wall outlet before.
Do not look directly into the light source (illuminant, LED, etc.).
The included or insertable LED light bulb can be replaced by the end customer.
This product can be used with light bulbs of the energy efficiency classes “A – G“, based on the EU regulation 2019/2015.