EWEADN E7 Mouse User Manual

EWEADN E7 Mouse

Button Instructions

Mouse

Power setting

• Low power: The indicator light is flashing red
• Charging: The red indicator light is always on
• Fully charged: The indicator light switches to the corresponding DPI color (When switching DPI in charging mode, it will change to the corresponding
• DPI color for 3 seconds and return to the charging state)

Connection method

Wired mode
Insert the computer USB, then enter the USB wired mouse mode first and start charging.

2.4G pattern
Switching method: Use the mode switch button at the bottom of the mouse to switch to 2.4G mode (the 2.4G receiver is paired by default at the factory) Pairing method: In 2.4G mode, long press the mode switch button for 3 seconds. If the red mouse indicator light flashes rapidly, enter pairing mode. Then insert the 2.4G receiver and pairing is successful. The mouse indicator light remains on.

Bluetooth mode

Switching method: Short press the mode switch button to switch to BT1/BT2 Pairing method: In BT mode, long press the mouse mode switch button for 3 seconds, and the mouse indicator light will flash (BTI green light/BT2 blue light) to enter BT pairing mode. After successful pairing, the mouse indicator light (corresponding to the mode light) stays on continuously

Sleep description

• After 30 seconds of inactivity, the mouse enters primary sleep mode and can be awakened by moving or pressing a button
• After 5 minutes of inactivity, the mouse enters a deep sleep mode and can be awakened by moving or pressing a button

DPI adjust

• red light
  • 400DPI
• green light
  • 800DPI(default)
• Lantern
  • 1200DPI
• blue lamp
  • 1600DPI
• yellow light
  • 2400DPI
• Purple lamp
  • 3200DPI

Pressing the DPI toggle button can quickly switch DPI

The drive can be adjusted to 12800

Rate of return

• BT mode return rate: 125Hz
• Default return rate for wired/2.4G mode: IOOOHz
• (Driver software adjustable return rate: 125Hz/250Hz/500Hz/1000Hz)

• Authorized by: Jiangxi Xuanfeng Technology Co., Ltd
• Manufacturer: Jiangxi Jichi Technology Co., Ltd
• Address: Plant No.3, Block B13-1-2, B14-1, Jinggangshan Economic and Development
• Zone, Ji’an City, Jiangxi Province, China
• Service Email: support@eweadn.com
• Website: www.eweadn.com
• Product executive standard number: Mouse GB/T 26245-2010
• Attention: The product images are for reference only and may differ from the actual product. Please refer to the actual product. We apologize for any inconvenience caused!
• Certificate of conformity

FCC Caution

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure

American agent information:

• Company Name: LOBOS IOWA INC
• FRN: 0036413961
• Contact Name: Harley Li
• Address: 4623 Bittercreek Dr Colorado Springs CO 80922 US
• Phone: +1 8188180538
• Email: info@lobos-lowa.com