OPPSHINE Solar String Light Instructions

OPPSHINE Solar String Light

Overview

This Solar String Light uses a solar panel to power eight lighting modes. Before first use, connect the ground plug assembly, position the panel for unblocked sunlight, and allow several hours of charging.

Specifications

• Power switch: ON / OFF
• Lighting modes: 8 (Combination, Waves, Sequential, Gradual, Chasing, Slow Fade, Twinkle, Steady On)
• Solar panel adjustment: up to 180° rotation

Quick Setup & Use

1. Connect the two ground plugs/stakes.
2. Insert the ground plug assembly into the slot on the back of the solar panel.
3. Adjust the solar panel angle (up to 180° rotation).
4. Insert the stake securely into the ground.
5. Peel off the protective film from the solar panel.
6. Turn the power switch to ON before first use.
7. For initial charging, place the lights in direct sunlight for several hours.
8. During operation, ensure the solar panel is not sheltered or shaded so it receives unblocked sunlight.

Product Display

Mode(8 lighting Modes)

1. Combination
2. Waves
3. Sequential
4. Gradual
5. Chasing
6. Slow Fade
7. Twinkle
8. Steady On

Installation

1. Step 1: Connect the two ground plugs
2. Step 2: Insert the ground plug into the solar panel slot
3. Step 3: Adjustable panel with 180°
4. Step 4: Insert into the ground

Product Function Introduction

1. Please tear off the protective film from the solar panel and make sure to turn on the switch before using.
2. The solar lights are not fully charged upon arrival; please put them in the sun for several hours to get fully charged before first use.
3. Make sure that the solar panel is NOT sheltered from the sun, because it needs to absorb enough sunlight during the daytime.
4. Please kindly note that as a solar-powered product, the working time is related to weather conditions.
5. Perfect for different occasions, adding a charming ambience to your anniversary party, wedding, backyard, walkway, patio, Christmas, holiday, or any other moment.

FCC

Information to User:

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help.

Important: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.

• Lights seem dim or don’t last: The solar lights may not be fully charged on arrival. Place them in direct sunlight for several hours before first use.
• Performance is poor in daytime: Make sure the solar panel is not shaded or sheltered. It requires unblocked sunlight during the daytime to absorb sufficient energy.
• Overall runtime varies: Operating time is directly dependent on weather conditions and sunlight exposure.