User Manual
Zeiss HFA3 Humphrey Field Analyzer
Recommended Protective Coverings For Your Ophthalmic Instruments
ZEISS HFA3
With the health and safety of you, your patients and your staff in mind during the COVID-19 pandemic, ophthalmic practices are advised to take extra precautions to prevent the spread of germs by using protective coverings on equipment when at all possible.
Using a single-use protective covering may help put your patient at ease and demonstrate your commitment to their health and well-being. Below, you’ll find a list of suggested protective products to help facilitate a hygienic environment.
These products are recommended to be used as single-use disposables and should be changed after each patient visit. Simply slip the sleeves on before the patient arrives, and remove and replace them before your next patient exam.
*Suggested protective coverings are not sold with ZEISS products. Examples shown are select U.S. vendors, which may not be available in your market.
You may find comparable vendors in your own market.
Protective Covering also fits model HFAII-i.
Please always refer to User Manual for any further instruction on operation of device.
EN_31_025_0400II; HFA.12332 Rev B ©Carl Zeiss Meditec, Inc. 2020. All rights reserved.
Read More About This Manual & Download PDF:
Zeiss HFA3 Humphrey Field Analyzer User Manual – Optimized PDF
Zeiss HFA3 Humphrey Field Analyzer User Manual – Original PDF
Questions about your Manual? Post in the comments!
References
- User Manualmanual.tools
中心暗点のある患者さんで固視目標の変更はHFAⅢの場合ぢのように操作しますか？
How do I change the fixation target on the HFA3 for a patient with a central scotoma?
To change the fixation target on the Zeiss HFA3 for a patient with a central scotoma (who cannot see the central yellow light), follow these steps during the test setup:
Note: The provided manual snippet focuses on protective coverings; for precise software menu navigation, please refer to the 'Operating Instructions' section of the full HFA3 User Manual.
Read the full Q&A page