VEVOR SC15 Borescope User Manual

VEVOR SC15 Borescope

Note: The product picture is for reference; the actual details shall prevail

This is the original instruction. Please read all manual instructions carefully before operating. VEVOR reserves a clear interpretation of our user manual. The appearance of the product shall be subject to the product you received. Please forgive us that we won’t inform you again if there are any technology or software updates on our product.

Please retain instructions for future reference
Protect yourself and others by observing all safety information, warnings and cautions. Failure to comply with instructions could result in personal injury and/or damage to product property.

FCC STATEMENT

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment! This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This product may cause harmful interference.
2. This product must accept any interference received, including interference that may cause undesired operation.

WARNING: Changes or modifications to this product not expressly approved by the party. Responsible for compliance could void the user’s authority to operate the product.

Note: This product has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules, These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this product does cause harmful interference to radio or television reception,which can be determined by turning the product off and on, the user is encouraged to try to correct the interference by one or more of the following measures.

• Reorient or relocate the receiving antenna.
• Increase the distance between the product and the receiver.
• Connect the product to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for assistance.

WEEE symbol.

• Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or local store for recycling advice.

PARAMETER

OVERVIEW

1. Before use, please read this manual carefully. We are not responsible for improper use.
2. Before use, please use a DC 5V 2A charger or computer to charge the device.
3. Please do not disassemble without authorization; it may cause damage and loss of warranty eligibility.
4. If the battery is found to be significantly swollen, leaking, or unable to charge, please stop using it immediately and contact a professional for assistance.
5. LCD screen maintenance:
   • Avoid touching or scratching the screen with sharp or hard objects.
   • When cleaning the screen, please turn off and unplug the power first, and gently wipe it with a fiber cloth (such as dust-free cloth,eyeglass cloth)or tissue.It is strictly prohibited to use alcohol, solvents, strong cleaning agents, or rough fabrics to wipe the screen to avoid damaging the coating.
6. Camera protection:
   • This is the most precise component! Be extra careful at all times.
   • In case of water ingress into the camera, it can be dried in a well-ventilated and dry place before use.
   • Cleaning the camera can be done using a fiber cloth, air blowing, or an extremely soft lens brush.
7. Storage:
   • When not in use for along time, please shut down and unplug the power.
   • Return the device to its packaging box or store it in a clean, dry, cool, and dust-free environment.
   • Avoid environments with high temperatures, high humidity, direct sunlight, strong magnetic fields, or large amounts of dust.
   • Built in battery, it is recommended to charge it regularly (every half month or a month)to maintain battery health.
8. Observation of items: It is strictly prohibited to observe flammable, explosive. highly corrosive, radioactive, or toxic samples.
9. Troubleshooting: Please refer to the troubleshooting section of the instruction manual first. If the issue cannot be resolved,stop using immediately and contact the seller or manufacturer.
10. For any other unspecified information, please contact the seller or manufacturer.

DETAILS

1. Type-C (camera cable)
2. HD Triple Lens camera
3. Power on/off: Press and hold for 2s to turn on, then press and hold for 2.5s to turn off. Adjust the brightness of LED lights: Short press to go from the brightest to the unlit (default 3 levels brightest, 3, 2, 1,0).
4. Take photos: Short-press (requires inserting a TF card to operate).
   Video recording: Long press to record ,short press to terminate recording(requires inserting a TF card to operate, if not terminated midway, record a video every 5 min).
5. Zoom in: Short-press to enlarge the image by 1X/2X/4X/6X/8X.
   Up:In the settings and gallery, short press and select Up.
   Camera switching: By default, A Camera is enabled. Long-press and hold to switch in order:A Camera >B Camera>C Camera >A Camera(loop switching).
6. Zoom out: Short press to zoom theimage by8X/6X/4X/2X/1X. Down:In the settings and gallery, short press and select Down. Dual display: Long press to display A+B Camera simultaneously, long press again to display A+C Camera simultaneously,long press again to switch back to A Camera, as shown in the diagram below.
7. Freeze frame: Short-press to freeze the image. At this time, the image cannot be moved. Short press again to exit the freeze frame.
   OK: In the settings and gallery, short press to confirm the selection.
   Gallery: Short press to enter the gallery, where you can view pictures and replay videos; Short press again to exit the gallery (This requires inserting a TF card to operate).
8. Settings: Short press to enter settings and adjust language, time, etc Short press again to exit the settings.
   Exit: Use other interfaces as exit keys.
9. Type-C port(connected to camera)
10. Module lock
11. Type-C charging port/data transmission
12. Reset button: In case of lagging and inability to charge, use a toothpick or pen core to press this button.
13. TF card slot

HOW TO USE

1. Before use,please use a DC 5V 2A charger or computer to charge the device. Fully charged: black screen
2. Move module lock 10 to the left, gently insert camera 1 into display screen 9 and then release the module lock.
3. Insert a TF card.if without a TF card,you cannot take photos or record videos, but normal observation remains unaffected. Insert the metal contacts upwards into the card slot First time inserting TF card, please format.
4. Press and hold for 3 2 seconds to turn on the device and it will be ready for  use.

Image browsing, video playback,deletion(requires inserting a TF card for photo graphy and video recording tasks):

Short press 7 to enter the gallery interface (nine grid),short press 5 6 to select a picture or video, short press 7 to confirm the selection, and you can browse the current picture or video (short press 7 to play the video,short press again to pause playback), long press to delete the current picture or video, or delete all parts; Short press 8 to exit.

Export of images and videos

1. Connect the TF card to the computer through the card reader.
2. Connect to the computer using a Type-C data cable.
3. After turning on the product, wait for the display to show“ ” then it is ready for use.

Installation of accessories

Blurred image

Lens dirt:

• Gently wipe the surface of the lens with a soft, clean cloth (such as a glasses cloth).
• If water enters the camera, place it in a well-ventilated, dry area to air dry before using it again.

Dirty Display screen

• Wipe the display screen with a clean cloth.
• The display screen is covered with protective film, which can be removed if necessary.

Improper focusing distance

• Please ensure that the observed object is within the effective focal length range of the lens (view product parameters)

Low battery

• Low battery level of the device may affect its normal operation. Please charge the device in a timely manner.

Unable to take photos and record videos

1. The device requires the insertion of a high-quality TF card.
2. Backup the data and format the TF card on the computer.
3. Replace TF card for testing

Image lag, inability to charge,etc.

1. Reference product details>12.Reset button

Warning: This product is an industrial endoscope camera and is not suitable for medical or human body examinations!

Frequently Asked Questions